ULTRANOMADE - Muscle stimulator SPORT ELEC - Free user manual and instructions

USER MANUAL ULTRANOMADE SPORT ELEC

Fibre textile 94% polyester, 6% elastanne

Attention Lire attentivement la notice.

Conformité EN60601-1/EN60601-2-10

0459 (directive 93/42/CEE)

The appliance needs special precaution regarding EMC and needs to be installed and put into service according to the EMC information provided in the chapter "Normative reference".
- The appliance needs to be installed and put into service in accordance with the information provided in the accompanying documents.
- Wireless communications equipment such as wireless home network devices, mobile phones, cordless telephones and their base stations, walkie-talkies can affect this applicable and should be kept at least a distance d away from the appliance. The distance d is calculated by the manufacturer from the 800 MHz to 2.5 GHz column of table in the chapter "Normative reference.

NORMATIVE REFERENCES

GUIDANCE AND MANUFACTURER'S DECLARATION

ELECTROMAGNETIC IMMUNITY

The Ultra Nomade is intended for use in the electromagnetic environment specified below. The customer or the user of the Ultra Nomade should assure that it is used in such an environment.

IMMUNITY TEST	IEC 60601 TEST LEVEL	COMPLIANCE LEVEL	ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
Electrostatic discharge (ESD) IEC 61000-4-2	±6 kV contact ±8 kV air	±6 kV contact ±8 kV air	Floors should be wood, concrete or ceramic tile. If floors are covered with synthetic material, the relative humidity should be at least 30 %.
Electrical fast transient/burst IEC 61000-4-4	±2 kV for power supply lines and dc lines	±2 kV for power supply lines	Mains power quality should be that of a typical commercial or hospital environment.
	±1 kV for input/output lines	Not applicable for input/output lines
Surge IEC 61000-4-5	±1 kV line(s) and neutral ±2 kV line(s) to earth	±1 kV line(s) and neutral N/A(§7.2 EN61000-4-5)
Voltage dips, short interruptions and voltage variations on power supply input lines IEC 61000-4-11	<5 % Ur (>95 % dip in Ur) for 0,5 cycle	<5 % Ur (>95 % dip in Ur) for 0,5 cycle	Mains power quality should be that of a typical commercial or hospital environment. If a dips or an interruption of mains power occurs, the current of the Ultra Nomade may be dropped off from normal level, it may be necessary to use uninterruptible power supply or a battery.
	40 % Ur (60 % dip in Ur) for 5 cycles	40 % Ur (60 % dip in Ur) for 5 cycles
	70 % Ur (30 % dip in Ur) for 25 cycles	70 % Ur (30 % dip in Ur) for 25 cycles
	<5 % Ur (>95 % dip in Ur) for 5s	<5 % Ur (>95 % dip in Ur) for 5s
Power frequency (50/60 Hz) magnetic field IEC 61000-4-8	3 A/m	3A/m	Power frequency magnetic fields should be at levels characteristic of a typical location in a typical commercial or hospital environment.

GUIDANCE AND MANUFACTURER'S DECLARATION ELECTROMAGNETIC IMMUNITY

The Ultra Nomade is intended for use in the electromagnetic environment specified below. The customer or the user of the Ultra Nomade should assure that it is used in such an environment.

IMMUNITY TEST	IEC 60601 TEST LEVEL	COMPLIANCE LEVEL	ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
Conducted RF IEC 61000-4-6	3 Vrms 150 kHz to 80 MHz	Not applicable	Portable and mobile RF communications equipment should be used no closer to any part of the Ultra Nomade, including cables, than the recommended separation distance calculated from the equation applicable to the frequency of the transmitter.Recommended separation distanced=12√Pd=1.2√P80 MHz to 800 MHzd=2.3√P80 MHz to 2.5 GHzwhere P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer and d is the recommended separation Distance in metres (m).Field strengths from fixed RF transmitters, as determined by an electromagnetic site survey,a should be less than the compliance level in each frequency range.bInterference may occur in the vicinity of equipment marked with the following symbol:
Radiated RF IEC 61000-4-3	3 V/m 80 MHz to 2.5 GHz	3V/m

NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.

NOTE 2 These guidelines may not apply in all situations.

Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.

a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the Ultra Nomade is used exceeds the applicable RF compliance level above, the Ultra Nomade should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-orienting or relocating the Ultra Nomade.

b. Over the frequency range 150kHz to 80MHz , field strengths should be less than 3V / m .

GUIDANCE AND MANUFACTURER'S DECLARATION ELECTROMAGNETIC EMISSIONS

The Ultra Nomade is intended for use in the electromagnetic environment specified below. The customer or the user of the Ultra Nomade should assure that it is used in such an environment.

EMISSIONS TEST	COMPLIANCE	ELECTROMAGNETIC ENVIRONMENT - GUIDANCE
RF emissions CISPR 11	Group 1	The Ultra Nomade uses RF energy only for its internal function. Therefore, its RF emissions are very low and are not likely to cause any interference in nearby electronic equipment.
RF emissions CISPR 11	Class B	The Ultra Nomade is suitable for use in all establishments, including domestic establishments and those directly connected to the public low-voltage power supply network that supplies buildings used for domestic purposes.
Harmonic emissions IEC 61000-3-2	Not applicable
Voltage fluctuations/ flicker emissions IEC 61000-3-3	Not applicable

RECOMMENDED SEPARATION DISTANCES BETWEEN PORTABLE AND MOBILE RF COMMUNICATIONS EQUIPMENT AND THE ULTRA NOMADE

The Ultra Nomade is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the Ultra Nomade can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the Ultra Nomade as recommended below, according to the maximum output power of the communications equipment.

RATED MAXIMUM OUTPUT POWER OF TRANSMITTER (W)	SEPARATION DISTANCE ACCORDING TO FREQUENCY OF TRANSMITTER (M)
	150 KHZ TO 80 MHz d=[3,5] √P V1	80 MHz TO 800 MHz d=[3,5] √P E1	800 MHz TO 2,5 GHz d=[7] √P E1
0.01	0.12	0.12	0.23
0.1	0.38	0.38	0.73
1	1.2	1.2	2.3
10	3.8	3.8	7.3
100	12	12	23

For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 - At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 - These guidelines may not apply in all situations.
Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.

CARTE DE GARANTIE / GARANTIE-KARTE / SCHEDA DI GARANZIA / GARANTIEKAART

24 MOIS / 24 MONATE / 24 MESES / 24 MAANDEN

Nom / Name / Nome / Namn

Adresse / Adresse / Indirizzo / Adres

Code Postal / Postleitzahl / Codice postale / Postcode