OKP9321T - Range hood AMICA - Free user manual and instructions

USER MANUAL OKP9321T AMICA

OKP6655S / KHF 695 600 S / SKZ 67 XBG

OKP9655S / KHF 695 900 S / SKZ 97 XBG

OKP8655S / KHF 695 800 S / AH0129

IO-HOO-0716/6 (05.2019) EN- Table of contents

NOTES ON SAFETY

DISPOSAL OF OLD APPLIANCE

CLEANING AND MAINTENANCE

WARRANTY AND AFTER SALES SERVICE

GWARANCJA, OBSŁUGA POSPRZEDAŻOWA

GARANTIE, NACHVERKAUF-SERVICE

Dear customer, From now on, your daily housework will be easier than ever before. Your appliance is exceptionally easy to use and extremely efficient. After reading these Operating Instructions, operating the appliance will be easy. Before being packaged and leaving the manufacturer, the appliance was thoroughly checked with regard to safety and functionality. Before using the appliance, please carefully read these Operating Instructions. By following these instructions carefully you will be able to avoid any problems in using the appliance. It is important to keep these Operating Instructions and store them in a safe place so that they can be consulted at any time. Follow these instructions carefully in order to avoid possible accidents. Sincerely,

NOTES ON SAFETY

• Before using the appliance, please carefully read this manual!
• The appliance is designed for household use only.
• The manufacturer reserves the right to introduce changes, which do not affect operation of the appliance.
• The manufacturer shall not be liable for any damage or fire caused by the appliance resulting from failure to follow instructions in this manual.
• Cooker hood is designed to remove cooking odours. Do not use cooker hood for other purposes.
• Connect the cooker hood operating in extraction mode to a suitable ventilation duct (do NOT connect the cooker to smoke or flue gas ducts, which are in use). It requires installation of the air extraction duct to the outside. The length of the duct (usually a pipe of Ø 120 or 150 mm) should not be longer than 4-5 m. An air extraction duct is also required for telescopic and furniture hoods in absorption mode.
• Cooker hood operating in air recirculation mode requires the installation of an activated charcoal filter. In this case, installing an extractor duct is not required, however it is recommended to install an air guide vane (Mainly in chimney cooker hoods).
• The cooker hood features independent lighting and exhaust fan that can be operated at one of several speeds.
• Depending on the type, the hood is designed to be permanently attached to a vertical wall over a gas or electric stove (chimney and universal hoods); on the ceiling over a gas or electric stove (island hoods); on the vertical built in furniture over a gas or electric stove (telescopic and builtin hoods). Before installing, make sure that the

wall/ceiling structure is strong enough to suspend the hood. Some hoods are very heavy. For details of the installation distance above an electric hob please refer to product technical sheet If the installation instructions of the gas cooker specify a greater distance, this must be taken into account (Fig. 1). Do not leave an open flame under the hood. When the pots are removed from the burner, set the minimum flame. Always make sure that the flame does not extend outside the pot, because it causes unwanted loss of energy and a dangerous concentration of heat. When cooking on fat, supervise the pans constantly, because overheated fat can ignite. Unplug the appliance before any cleaning, replacing the filter or repair work. Cooker hood grease filter should be cleaned at least once a month, because the filter saturated with fat is flammable. Ensure adequate ventilation (air flow) if other equipment such as liquid fuel stoves or heaters are operated in the room in addition the cooker hood. When the cooker hood is simultaneously operated with burning appliances requiring adequate fresh air from the room to work properly, their safe operation is possible if under pressure around these appliances is a maximum of 0.004 mbar (this does not apply when the cooker hood is used as an odour filter) Do not lean on the hood. The hood should be cleaned regularly both inside and out (AT LEAST ONCE A MONTH, following the indications concerning maintenance provided in this manual)..Failure to adhere to the rules concerning cleaning the hood and replacing filters results in a fire risk. If the power cord is damaged it should be replaced by a specialised service centre. Ensure that it is possible to disconnect the ap-9-

pliance from the mains by removing the plug or switching off the bi-polar switch. This appliance is not intended for use by persons (including children) with physical, mental or sensory handicaps, or by persons inexperienced or unfamiliar with the appliance, unless under supervision or in accordance with the instructions as communicated to them by persons responsible for their safety. Particular attention should be paid not to allow unaccompanied children to use the appliance. Make sure voltage indicated on the nameplate corresponds to the local mains supply voltage. Before use, extend and straighten the power cord. Packaging materials (bags, polyethylene, polystyrene, etc.) should be kept away from children during unpacking. Before connecting the hood to the mains power supply always check that the power cord is properly installed and is not trapped by the appliance. Do not connect the appliance to the mains until assembly is complete. Do not operate your kitchen hood without the aluminium grease filters. It is strictly forbidden to cook dishes under on an open flame (flambé) under your kitchen hood. Always strictly adhere to regulations issued by the competent local authorities regarding the technical and safety requirements for fume extraction. Failing to tighten bolts and fasteners in accordance with these instructions may endanger life and health. Hanging kitchen hoods operate only in air circulation / odour absorber mode WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

UNPACKING During transportation, protective packaging was used to protect the appliance against any damage. After unpacking, please dispose of all elements of packaging in a way that will not cause damage to the environment. All materials used for packaging the appliance are environmentally friendly; they are 100% recyclable and are marked with the appropriate symbol. Important! Packaging materials (bags, polyethylene, polystyrene, etc.) should be kept away from children during unpacking.

DISPOSAL OF OLD APPLIANCE

In accordance with European Directive 2012/19/EU and local legislation regarding used electrical and electronic goods, this appliance is marked with the symbol of the crossed-out waste container. This marking indicates that the appliance must not be disposed of together with other household waste after it has been used. The user is obliged to hand it over to waste collection centre collecting used electrical and electronic goods. The collectors, including local collection points, shops and local authority departments provide recycling schemes. Proper handling of used electrical and electronic goods helps avoid environmental and health hazards resulting from the presence of dangerous components and the inappropriate storage and processing of such goods.

OPERATION Cooker hood controls Control Panel is shown in Figure 4, for reference it is also shown below: This appliance features gesture control:

1. Gesture sensors for switching the

2. Gesture sensors for fan speed control

The control panel is equipped with touch controls: Control functions are described below: 3456789- Off-Timer sensor Reduce fan speed sensor Increase fan speed sensor Display Gesture control management sensor Light control sensor StandBy mode sensor When you plug in your appliance, will be shown on the display for a fraction of a second, then the display will go off. Only the gesture control sensor is illuminated on the control panel. Touch to activate the appliance — the pictogram will light up When activated, touch to start the fan. Available fan speeds:

• Low speed (1). Use this speed when cooking a little food with hardly any fumes.
• Medium speeds (2 - 3). Use this speed when cooking multiple dishes at the same time with moderate amount of fumes.
• Turbo ( ) — use this speed when frying or grilling with large amount of fumes. Use the and sensors to increase or reduce fan speed. Note: The Turbo speed is active only for 5 minutes (the dot on the display flashes), then the fan speed will be reduced. Turbo speed operation is time limited. By activating the Turbo speed again and again, you can use it for a maximum of 30 minutes (including the Turbo off intervals if shorter than 5 minutes). After this time, Turbo speed will not be available for the next 30 minutes — during this time, the maximum possible fan speed is 3.

To turn off the fan, touch zero , or touch . repeatedly until fan speed is reduced to Touch to turn the lighting on. Touch again to turn the lighting off. The lighting operates independently of the on/off sensor. Off-Timer Use Off-Timer to turn off the hood after a specified time. Use Off-Timer to filter the fumes out of the air after cooking. The Off-Timer can be set to 5, 10 or 15 minutes. Touch to activate the Off-Timer at any time. The sensor will flash and the display will show . Now use the and sensors to select the Off-Timer delay: Display indication Touch to confirm your Off-Timer setting (according to the above table). A flashing dot will appear by the fan speed on the display and the sensor will flash. Touch to deactivate the Off-Timer at any time — the dot by the fan speed and will stop flashing. Gesture control When you plug in your appliance gesture control is active and indicator is on. Touch to turn off the gesture control. Touch again to reactivate gesture control. You can use gestures to control the fan speed and lighting. When gesture control is active, you can also control the appliance using the touch sensors. Gesture control works correctly when you move your open hand about 5 cm from the surface of the control panel.

Note: Depending on the function you want to activate you need to move your hand near the sensors (Figure 4, item 1, or Figure 4, item 2). The area over which to move your hand is marked on the figures presented below in this manual. When activating a certain function (such as turbo speed) requires multiple hand gestures, reposition your hand for another gesture away from the control panel to avoid triggering the motion sensors). Hand movements must not be too fast. Preferably, a single gesture should take about 1 second. To activate the appliance, move your hand from left to right. The display will show . To turn on the fan or increase fan speed, move your hand from left to right several times in standby mode. The display will show the current fan speed after each hand gesture. To turn off the fan or reduce fan speed, move your hand from right to left several times in standby mode until the display shows . Move your hand one more time and the appliance will turn off (gesture control will still be active)

Move your hand from the bottom up to turn on the lighting Move your hand from the top to bottom to turn off the lighting

Other important information concerning the operation of the hood Operation in air circulation / odour filter mode. In this mode, the filtered air returns to the room through the outlets. Install activated charcoal filter in this setting. It is recommended to install the air guide (available depending on the model, mainly in chimney cooker hoods). Air extraction operation: When cooker hood operates in extraction mode, air is discharged outside through an extraction duct. Remove activated charcoal filter in this setting. The cooker hood is connected to the air outlet opening using a rigid or flexible extraction duct with a diameter of 150 or 120 mm, and the appropriate clamps, which must be purchased at a hardware store. The appliance should be installed by a qualified installer. Fan speed: Lowest and medium fan speed is used in normal conditions and less intense odours, while the highest speed is used only when cooking odours are very intense, such as during frying or grilling. Note (applies to universal hoods only): Due to the design of universal hoods you need to manually change the mode of operation. See Figure 8 for instructions on how to change the mode. Note (only applies to telescopic and in-built kitchen hoods): Furniture and telescopic cooker hoods operating in air recirculation mode require installation of the exhaust duct. The other end of the duct should be directed to the room as it will discharge filtered air. Note: Hanging kitchen hoods operate only in air circulation / odour absorber mode

CLEANING AND MAINTENANCE Maintenance Regular maintenance and cleaning of the appliance will ensure trouble-free operation of the cooker hood and extend its life. Especially make sure that the grease filter and activated charcoal filter are replaced according to manufacturer's recommendations.

Do not use a soaked cloth, sponge, or water jet. Do not use solvents or alcohol, as they may tarnish lacquered surfaces. Do not use caustic substances, especially for cleaning stainless steel. Do not use a rough or abrasive cloth. It is recommend to use a damp cloth and a neutral detergent. Note: After several washes in the dishwasher, the colour of the aluminium filter may change. The change of colour does not indicate improprieties or the necessity to change it. Grease filter For normal hood operation, aluminium grease filter should be cleaned every month in the dishwasher or by hand using a mild detergent or liquid soap. Dismantling of aluminium grease filter is shown on Figure 5. Acrylic filter is used in some models. This filter should be replaced at least once every two months or more frequently if the appliance is used intensively. Activated charcoal filter Charcoal filter is used only when the cooker hood is not connected to the ventilation duct. Activated charcoal filter can absorb odours until saturated. Charcoal filter is not suitable for washing or regeneration and should be replaced at least once every two months or more frequently if the appliance is used intensively. Dismantling of charcoal filter is shown on Figure 6. Light Use incandescent / halogen / LED modules of the same specification as those factory-installed in the appliance. See Figure 7 for details how to replace lights. If there is no such figure in this manual, please contact authorised service to replace the lighting module.

WARRANTY AND AFTER

SALES SERVICE Warranty Warranty service as stated on the warranty card. The manufacturer shall not be held liable for any damage caused by improper use of the product. The manufacturer recommends that all repairs and adjustments be carried out by the Factory Service Technician or the Manufacturer's Authorized Service Point. Repairs should be carried out by a qualified technician only. Manufacturer’s Declaration The manufacturer hereby declares that this product meets the requirements of the following European directives:

Low Voltage Directive 2014/35/EC Electromagnetic Compatibility (EMC) Directive 2014/30/EC ErP Directive 2009/125/EC Directive RoHS 2011/65/EC and has thus been marked with the symbol and been issued with a declaration of compliance made available to market regulators.

directive directive directive directive Chimney Mounting Bracket Chimney Mounting Bracket Hood Mounting Bracket (2) M4*6 Decorative Chimney Top

Decorative Chimney Bottom (2) M4*6 Decorative Chimney Top Chimney Mounting Bracket Chimney Mounting Bracket 3b5、

5、3、 Chimney Mounting Bracket (2) ST2.9*14 Chimney Mounting Bracket (2) ST2.9*14 (2) ST2.9*14

Bracket (2) ST3*6 (2) M4*6 Decorative Chimney Top Decorative Chimney Hood Mounting Decorative Top Bracket Chimney Bottom Decorative Chimney Bottom Hood Mounting Bracket Decorative Chimney Bottom

Decorative Chimney Bottom Hood Mounting Bracket Hood Mounting Bracket (2) ST3*6 Chimney Mounting Bracket

(2) M4*6 Decorative Chimney Top Decorative Chimney Bottom

Aluminum Cassette Filter