PF7400 COMFORT SERIES PLUS - Rasoir électrique REMINGTON - Free user manual and instructions

USER MANUAL PF7400 COMFORT SERIES PLUS REMINGTON

Thank you for choosing Remington®. Our products are designed to meet the highest standard of quality, functionality and design. We hope you enjoy using your new Remington® product. Please read the instructions for use carefully and keep in a safe place for future reference.

F IMPORTANT SAFETY INSTRUCTIONS

1 WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS: 2 This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years. 3 Do not use attachments other than those we supply. 4 Do not use this product if it is not working correctly, if it has been dropped or damaged, or dropped in water. 5 An appliance should never be left unattended when plugged in to a power outlet, except when charging. 6 Keep the power plug and cord away from heated surfaces. 7 Make sure the power plug and cord do not get wet. 8 Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres. 9 Do not twist or kink the cable, or wrap it round the appliance. 10 Store the product at a temperature between 15°C and 35°C. Suitable for use in a bath or shower.

Trimmer button Charging pins Charging stand Adaptor Head guard Cleaning brush

Head and Cutter assembly Individual flexing heads Hairpocket Charging indicator light & low battery indicator (XR1330) 6 Fuel gauge (XR1350) 7 LED display (XR1370)

ENGLISH C GETTING STARTED For best shaving performance, it is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system.

, CHARGING YOUR SHAVER • Ensure the appliance is turned off. • Connect the charging stand to the adaptor and then to the mains. • Place the shaver in the charging stand. • Charge for at least 24 hours when using for the first time. • Allow 90 minutes for a full charge (XR1350 and XR1370) and 4 hours for XR1330. The charging indicator light (XR1330), fuel gauge (XR1350) or LCD display (XR1370) will indicate when the shaver is fully charged. • To preserve the life of your batteries, let them run out every 6 months then recharge for 24 hours. • The shaver automatically adjusts to a mains voltage between 100V and 240V. O This appliance should be charged by approved safety isolating adaptors PA-0510E(K) with the output capacity of 5.0 dc; 1.0A.

F INSTRUCTIONS FOR USE

, SHAVING Note: This shaver is for cordless use only. • Make sure your shaver is properly charged. • Switch the shaver on. • Stretch the skin with your free hand so the hairs stand upright • Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and make them vulnerable to breakage). • Use short, circular strokes. , SHAVING WITH SHAVING GEL • Follow the same instructions as dry shaving if using with gel. FCAUTION: After use with shaving gel, please rinse the head and cutters under warm water to clean away any excess gel and debris. , TRIMMING • Push the trimmer button to release the detail trimmer. • Hold the trimmer at right angles to the skin. 4

Run shaver until the motor stops. Remove the head from the shaver (Pull head up and off ). Using a small screwdriver, pry the ‘collar’ off of the top of the handle. Using a small screwdriver, pry the front cover from the body. Remove three screws located on front of shaver.

• Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil. Replacement parts and accessories available to buy at www.remington.co.uk/ parts-accessories.

• Ensure the shaver is switched off. • Hold the head and gently pull up on the ribbed area to remove the hairpocket from the head. • Slide the cutter locking mechanism to remove the cutters. • Tap out excess hair shavings and use a cleaning brush if necessary. • Close head assembly.

GR Care for your appliance to ensure a long lasting performance. We recommend you clean your appliance after each use. The easiest and the most hygienic way to clean the appliance is by rinsing the appliance head after use with warm water.

SL C CARE FOR YOUR SHAVER HR E Tips for best results

Use moderate to slow stroking movements. The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line. DO NOT press hard against the skin in order to avoid damage to the rotary heads.

• Place the trimmer at desired trim line for a quick, easy, professional trim.

• To retract and switch off the trimmer, push the trimmer down and lock into place.

• Using a small screw driver, pry up the newly unsecured inner housing to expose the battery.

• Pry battery free from circuit board. • Dispose of battery properly.

H ENVIRONMENTAL PROTECTION To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol must not be disposed of with unsorted municipal waste, but recovered, reused or recycled.

C UW APPARAAT VERZORGEN GR F MISES EN GARDE IMPORTANTES

C DÔLEŽITÉ FUNKCIE SL OCHRANA ŽIVOTNÉHO PROSTREDIA C POMEMBNA VARNOSTNA NAVODILA