Ikore - Remote control DANFOSS - Free user manual and instructions
Find the device manual for free Ikore DANFOSS in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Remote Control |
| Brand | Danfoss |
| Model | Ikore |
| Dimensions (approx.) | 150 x 50 x 20 mm |
| Weight (approx.) | 100 g |
| Power Supply | 2 x AAA batteries (not included) |
| Battery Life | Up to 12 months under normal use |
| Communication Protocol | RF (radio frequency) |
| Operating Range | Up to 30 meters indoors |
| Display | LCD screen with backlight |
| Key Functions | Temperature adjustment, mode selection, scheduling, pairing |
| Compatible Devices | Danfoss Icon, Danfoss Link, and other Danfoss thermostatic heads |
| Mounting | Handheld or wall-mounted (bracket included) |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Protection Rating | IP20 (indoor use only) |
| Maintenance | Wipe with a soft, dry cloth; do not use liquids or solvents |
| Safety Precautions | Keep away from water, do not disassemble, use only specified batteries |
| Spare Parts & Repairability | Contact Danfoss support for replacement parts; device is not user-serviceable |
Frequently Asked Questions - Ikore DANFOSS
How do I pair the Ikore remote with a Danfoss thermostat?
To pair, press and hold the Pairing button on the remote (usually the center button) and simultaneously press the pairing button on the thermostat. Refer to the manual for specific steps.
How do I replace the batteries in the Ikore remote?
Slide the battery cover off the back, remove old batteries, insert two new AAA batteries with correct polarity, and replace the cover.
The remote display is blank. What should I do?
Check if the batteries are correctly installed and have charge. Replace them if needed. If the issue persists, try a reset by removing batteries and pressing any button for 5 seconds.
Can I mount the Ikore remote on the wall?
Yes, the remote comes with a wall-mount bracket. Fix the bracket to the wall using screws (provided) and snap the remote into place.
What is the operating range of the remote?
The remote has a range of up to 30 meters indoors, but walls and obstructions may reduce it. Ensure the thermostat is within range.
How do I change the temperature setpoint?
Use the up and down arrows on the remote to adjust the desired temperature. The new setpoint is transmitted to the thermostat immediately.
My remote shows an error code. What does it mean?
Error codes vary; common ones: E1 (communication error) - move closer, E2 (battery low) - replace batteries. Consult the manual for full list.
Can I use the remote with multiple thermostats?
Yes, the Ikore remote can control up to 10 thermostats in the same system. You must pair each thermostat separately.
Is the remote waterproof?
No, the remote has an IP20 rating, meaning it is not protected against water. Keep it away from moisture and liquids.
How do I reset the remote to factory settings?
Remove batteries, press and hold any button for 10 seconds, then reinsert batteries. The remote will reset and require re-pairing.
User questions about Ikore DANFOSS
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Remote control in PDF format for free! Find your manual Ikore - DANFOSS and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Ikore by DANFOSS.
USER MANUAL Ikore DANFOSS
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : DANFOSS
Model : Ikore
Category : Remote control