AM-51C - Security Camera Vivotek - Free user manual and instructions

USER MANUAL AM-51C Vivotek

VIVOTEK Fixed Dome & Fisheye Series Mounting Cap

Installation Guide

Using AM-51C mounting cap and compatible accessories

Rev.

Rev. 1.0

Ordering part no.:100140100G

Part no.: 625032200G

Revision History:

* Rev. 1.0: Initial Release

AM-51C Mounting Cap Mechanical Drawings

Ø155.00 12.20 45.00 45.00

Compatible VIVOTEK Cameras

Fixed Dome series	FD9381 / FD9371 / FD836B / FD8382
Fisheye	FE8191 / FE8181

You may also refer to VIVOTEK's website for the list of supported models. Support for other models can be available through time.

Package Contents: AM-51C, Installation Guide, 3x panhead M4x7, double-sided tape, plastic stopper

II Installation

Mounting Hole Definitions

initions User a the kno

User a hammer and screwdriver to open the knock out holes you prefer to use.

Above are the locations of different groups of mounting holes for matching different junction boxes:

Hole Type	Applicable Box Drawings Screw No. of				screws
1	4" square and round box			#8-32, L15(User-supplied)	2
2	4" octagon box			#8-32, L15(User-supplied)	2
3	1" single gang box			#6-32, L15(User-supplied)	2

Hole Type	Applicable Cameras Screw No. of screws
A	FD9171, FD816B, FD8182	#8-32, L15 (User-supplied)
B	FE8191, FE8181	#8-32, L15 (User-supplied)

NOTE:

1. Route cables before you secure the accessories to a wall.
2. For details on the cable connections with network cameras, please refer to their Quick Installation Guide.

Installing the Mounting Cap

1. Route cables through the junction box.

Line drawing of a rectangular electronic device with circular cutouts and a USB cable, no text or symbols present

1. Install the mount cap to the junction box. Use screw holes specified on page 3 depending on the type of junction box.

Technical line drawing of a circular mechanical component with attached wires and connectors (no text or symbols)

431. FE8181 and FE8191.

3-1-1. Install the camera to the mount cap by fastening two screws to the threaded holes on the copper spacers.

Technical line drawing of a mechanical assembly with internal components and wiring (no text or symbols)

3-1-2. Connect the cables and install the top cover.

Technical line drawing of a mechanical device interior with no visible text or symbols

3-2. FD836B/FD8382/FD9381/FD9371.
3-2-1. Fasten screws to the mounting cap. Do not completely tighten the screws. Leave part of the screws out.

Diagram of a mechanical assembly with a tool and circular component, no text or symbols present

Attach the plastic stopper to the opening at the bottom of the camera.

Technical line drawing of a mechanical assembly with internal components and directional arrows (no text or symbols)

3-2-2. Install the camera to the mounting cap by turning it counter-clockwise so that the screw heads fit in the keyhole slots. Fasten the screws, and then connect the cables.

Technical line drawing of an electronic device interior showing internal components and wiring (no text or symbols)

Technical diagram of a mechanical assembly with rotational arrows indicating motion (no text or symbols)

Refer to the camera's Quick Installation Guide for how to make the waterproof connections.

3-2-3. Install the dome cover. Tune the focus, and refer to the documentation that came with your cameras for the rest of configuration details.

Technical line drawing of a mechanical component with concentric rings and a handle (no text or symbols)