AP-B530MV - Speaker Sven - Free user manual and instructions

Product Type	Portable Bluetooth Speaker
Brand	Sven
Model	AP-B530MV
Dimensions (W x H x D)	Approx. 200 x 70 x 70 mm
Weight	0.5 kg
Power Supply	Built-in rechargeable battery, USB charging (Micro USB)
Battery Capacity	1800 mAh
Playback Time	Up to 6 hours (varies with volume)
Charging Time	Approx. 3 hours
Output Power	5W (RMS)
Frequency Response	100 Hz - 20 kHz
Impedance	4 Ω
Signal-to-Noise Ratio	≥ 80 dB
Bluetooth Version	Bluetooth 5.0
Bluetooth Range	Up to 10 m
Supported Audio Formats	MP3, WMA, WAV, FLAC (via USB/MicroSD)
Input Interfaces	Bluetooth, AUX 3.5mm, MicroSD card slot, USB flash drive
FM Radio	Yes, with automatic search
Controls	Power, Volume +/-, Play/Pause, Previous/Next, Mode, Answer Call
Microphone	Built-in for hands-free calls
LED Indicator	Yes (battery status, Bluetooth pairing)
Material	Plastic with fabric mesh
Included Accessories	USB charging cable, AUX cable, user manual
Safety	Do not expose to water or extreme temperatures. Use only provided charger.
Cleaning	Wipe with a dry, soft cloth. Do not use abrasive cleaners.
Spare Parts and Repairability	Contact Sven service center for battery replacement; speaker is not user-serviceable.

Frequently Asked Questions - AP-B530MV Sven

How do I pair the speaker with my phone via Bluetooth?

Turn on the speaker by pressing and holding the power button. The LED will flash blue and red. Enable Bluetooth on your phone and select AP-B530MV from the list. If prompted, enter 0000 as the PIN.

How do I charge the speaker?

Connect the included Micro USB cable to the speaker's charging port and a USB power adapter (5V, 1A). The LED will turn red during charging and turn off when fully charged. Charging time is about 3 hours.

Can I play music from a microSD card?

Yes. Insert a microSD card (up to 32GB) formatted in FAT32 into the slot. The speaker will automatically switch to SD mode and play the audio files. Use the controls to navigate tracks.

How do I use the FM radio function?

Press the Mode button until you enter FM radio mode. To auto-search stations, press and hold the Play/Pause button. The speaker will scan and save available stations. Use Previous/Next to switch between them.

What should I do if the speaker does not turn on?

Make sure the battery is charged. Connect the speaker to a charger and let it charge for at least 15 minutes. If it still does not turn on, try a different cable or adapter. If the issue persists, contact Sven support.

Can I use the speaker while it is charging?

Yes, you can play audio while charging. However, the charging time may be longer, and the speaker may become warmer than usual. It is safe to use.

How do I answer a phone call using the speaker?

When a call comes in while connected via Bluetooth, press the Play/Pause button to answer. Press it again to hang up. The built-in microphone allows hands-free conversation.

What is the playback time on a full charge?

At moderate volume (50%), the speaker can play for up to 6 hours. Higher volume and bass-heavy content will reduce playback time.

How do I reset the speaker?

If the speaker becomes unresponsive, press and hold the power button for 10 seconds to force a reset. Alternatively, turn it off and then on again. This will clear any temporary glitches.

Is the speaker water-resistant?

No, the Sven AP-B530MV is not water-resistant. Keep it away from liquids, rain, and high humidity. Do not use it near water to avoid damage.

USER MANUAL AP-B530MV Sven

Black outdoor headphones with a black strap and 'SVEN' branding on the head (no additional text or symbols visible)

Diagram of a device with numbered parts labeled 1 through 7, likely for labeling or identification.

Diagram of a computer mouse head with numbered labels pointing to specific parts

Congratulations on your purchase of the SVEN stereo headphones!

COPYRIGHT

© 2019. SVEN PTE. LTD.Version 1.0 (V 1.0).

This Manual and information contained in it are copyrighted. All rights reserved.

CONTENTS

RUS 2

UKR 7

ENG 12

BUYER RECOMMENDATIONS

• Shipping and transportation equipment is permitted only in the original container.
• Does not require special conditions for realization.
• Dispose of in accordance with regulations for the disposal of household and computer equipment.

APPLICATION

SVEN AP-B530MV wireless stereo headphones with microphone are designed for operation with PC, notebooks and other mobile devices by means of data transfer via Bluetooth protocol. They can be also used in internet telephony, during video conferences, in multimedia applications, in interactive games, for speech recognition and foreign language teaching.

PACKAGE CONTENTS

• Wireless stereo headphones – 1 pc
• Detachable audio cable – 1 pc
• USB power cord to micro USB – 1 pc
• User's Manual – 1 pc
• Warranty card – 1 pc

SAFETY PRECAUTIONS

• Don’t use the stereo headphones while driving.
• Don't use the stereo headphones at high volume for a long time (more than 15 minutes), as this may cause hearing impairment.

SPECIAL FEATURES

• 4.2 Bluetooth wireless signal transmission
- Wired connection
- Possibility to control the volume and switch tracks
- Battery operation time up to 12 hours
- Radius of operation up to 10 m

User's Manual

AP-B530MV

DESCRIPTION

① Volume down button (short press);
Previous track (long press, \~ 2 seconds)
② ON/OFF button; Call
control button; Play/Pause
③ Volume up button (short press);
Next track (long press, \~ 2 seconds)
④ Micro USB jack for battery charging
⑤ Audio cable jack
⑥ Microphone
⑦ LED indicator

Attention! The built-in battery must be charged completely prior to the headphones application.

Headset charging

- Connect the headphones to a USB port of PC or USB charger using USB/micro USB cable (included). During battery charging the indicator ⑦ is red.

- When the device is charged in full, the indicator ⑦ goes out.

- There is a short periodic double beep signal when the battery charge level is low and the LED indicator ⑦ will be red alternately.

- The battery in the headphones is used as an integral part of the device, therefore do not try to extract or replace it, because this can result in the warranty cancellation or the device damage.

Device switching on/off

- In order to turn on the headphones press and hold the button ② before you hear a beep signal. When the device is turned on, the LED indicator ⑦ will start blinking blue and red (search mode) or blinking blue (connecting mode). In order to turn off the device, press once more and hold the button ② before you hear a beep signal. When the device is turned off, the LED indicator ⑦ will blink red.

Control buttons

When connected to a telephone:

• in order to receive an incoming call press the button ②; press the button ② once again to finish the call;
• in order to reset the call, press and hold the button ② (\~2 seconds)*;
• when the button ②, is pressed shortly twice, the call function of the last number dialed* is switched on;
• when the button ② is pressed long, the headset is disconnected from the device and enters to the search mode.

Labeled diagram of a mechanical component with numbered parts for identification

Fig. 1. Headphones design

Bluetooth technology

- Wireless data transfer via the Bluetooth protocol enables to connect wireless headphones to compatible devices. Maximum radius of action of data transfer is 10 m. Such obstacles as walls or other electronic devices can interfere with the signal transfer.

Headset to a device interfacing

• It is necessary first to interconnect the device with a signal source (see the connection diagram in Fig. 2) to transfer signals via Bluetooth. To do this, turn on the headset, wait for starting the search mode – the LED indicator ⑦ will alternate blue light with red one.
• It is necessary to select the search mode of de vices with Bluetooth on a signal source (telephone, notebook, smartphone, etc.). “SVEN AP-B530MV” massage will be displayed on the screen, which is to be connected to*.
• If connection is successful, there will be a short beep signal in the headphones; the search mode indication on the headphones is over. If no devices is connected, headphones will turned off automatically in 2 minutes. If the device interfacing has, been failed, it is necessary to switch the system in the search mode once more (turn off and on) ^** .
• The indicator ⑦ on the headphones blinks blue short during the data exchange (listening music) with a device connected via Bluetooth.

The use in the wired mode

- The device can be used as stereo headphones in the wired mode. In order to connect them to a sound source with the included cable via jack ⑤.

graph LR
    A["PC"] -->|Wireless Signal| B["Mobile device"]
    B -->|Wireless Signal| C["Bluetooth"]
    C -->|Wireless Signal| D["Headphones"]

Fig. 2. Connection diagram

TECHNICAL SPECIFICATIONS

Parameter, measurement unit	Value
Sensitivity, dB	headphones: 102±3microphone: -48 ± 3
Frequency range, Hz	headphones: 20 – 20,000microphone: 30 – 16,000
Impedance, Ohm	32
Membrane, mm	∅ 40
Connection type	Bluetooth 4.2/mini-jack stereo∅ 3,5 mm (3 pin)
Bluetooth supported profiles	HSP, HFP, A2DP, AVRCP
Radius of operation, m	up to 10
Operation time, h	up to 12
Cable length, m	0.8
Weight, g	165

Notes.

• Technical specifications given in this table are supplemental information and cannot give occasion to claims.
• Technical specifications and package contents are subject to change without notice due to the improvement of SVEN production.

Technical support is on www.sven.fi.

Black and white photo of a pair of SAG headsets with black earbuds and black straps (no visible text or symbols)

Модель: AP-B530MV

Manufacturer: SVEN PTE. LTD, 176 Joo Chiat Road,

Nº 02-02, Singapore, 427447. Produced under the

control of Oy Sven Scandinavia Ltd. 15, Kotolahdentie,

Kotka, Finland, 48310. Made in China.

® Registered Trademark of Oy SVEN

Scandinavia Ltd. Finland.