NVR-9538 CR - Heating NEVIR - Free user manual and instructions

USER MANUAL NVR-9538 CR NEVIR

Exterior view of a Nevir electric heating fan with visible grille and control panel (no text or symbols on device body)

Important Safeguards

When using electrical appliances, in order to reduce the risk of fire, electric shock and/or injury to persons, basic safety precautions should always be followed, including the following:

- Children should be supervised to ensure that they do not play with the appliance.

• The product is for household use only.

- Connect the appliance to a single phase AC supply of the voltage specified on the rating label.

- In order to avoid overheating, do not cover the heater.

- Never leave the heater unattended whilst it is in use. Always turn the switch to the OFF position and unplug it from the electrical outlet when not in use.

- Extreme caution is necessary when any heater is used by or near children, invalids or an elderly person and whenever the heater is left operating and unattended.

- The heater must not be located immediately below an electrical socket outlet.

- Do not run the cable under carpet and do not cover it with rugs, runners or the like. Arrange the cable away from the traffic area and where it will not be tripped over.

- Do not operate the heater with a damaged cable or plug, if the supply cable is damaged, it cannot be replaced and the heater should be destroyed.

- The cable shouldn't be placed near the hot surface of the appliance.

- Avoid the use of an extension cable as this may overheat and cause a risk of fire.

- Use the heater in a well ventilated area. Do not insert or allow objects to enter any ventilation or exhaust opening. To prevent a possible fire, do not block air intakes or exhaust openings in any manner.

- Use the heater on flat, dry surfaces only.

- Do not place this heater near flammable materials, surfaces or substances as there may be a risk of fire.

- Do not use the heater in any areas where petrol, paint or other flammable liquids are stored, e.g., garages or workshops.

- Don't use the heater in the immediate surroundings of a bath, a shower, or a swimming pool. Never locate the heater where it may fall into the bath tub or other water container.

- This heater is hot when in use. To avoid burns and personal injury, do not let bare skin touch hot surfaces.

- Be sure that no other appliances as your product are in use on the same electrical circuit as an overload can occur.

- The heater should not be used in a room of which the floor area is less than 5 m^2 .

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

- Children of less than 3 years should be kept away unless they are continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

• Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
• CAUTION – Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
• Do not use this heater with a programmer, timer, separate remote control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.

Instructions for Use

NOTE : It is normal when the heaters are turned on for the first time or when they are turned on after having not being used for a long period of time that they may emit some smell and fumes. This will disappear when the heater has been on a short while.

Choose a suitable location for the heater taking into account the safety instructions above.

After inserting the plug, turn the control to the desired setting.

There are 5 settings:

OFF

OSCILLATION

FAN ONLY (COOL BLOW FUNCTION)

LOW SETTING 1

HIGH SETTING 2

This heater is equipped with a thermostat. Turning clockwise will increase the desired temperature (the heater will switch on more frequently). Turning anti-clockwise will cause the heater to switch on less frequently.

Tip: When the thermostat is turned completely anti-clockwise, the heater will only switch on when the ambient temperature in the room is about 5 degrees centigrade. This is sometimes handy as a frost prevention measure in greenhouses etc.

Oscillation Function

Pressing the oscillation button will make the heater sweep back and forth to spread the heat over a wider area.

Cleaning and Maintenance

Before cleaning, please unplug the heater first and wait for it to cool down completely.

The appliance needs only external regular cleaning.

Do not clean with abrasive cloths or cleaners. Do not use chemical solvents. A soft cloth moistened with a mild detergent solution is ideal.

On occasion, compressed air can be used to clear dust from the fan intake or heater vents. THE HEATER MUST BE COLD AND DISCONNECTED FROM THE MAINS SUPPLY BEFORE DOING THIS. ONLY PERFORM THIS OPERATION IN A WELL VENTILATED AREA.

Specification

Rated voltage : 220-240V \~ 50HZ

Power consumption : 1500 watts

Correct Disposal of this product

According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should be separately collected and treated. If at any time in future you need to dispose of this product please do NOT dispose of this product with household waste. Please send this product to WEEE collecting points where available.

In order to fulfill ruling UNE EN-60335, we indicate that if the flexible wire is damaged, it can only be substituted by a technical service recognized by NEVIR, S.A., as per special tooling is required