MW-1443 PK - Sorbet maker Maxwell - Free user manual and instructions

Product Type	Ice cream maker / Sorbet maker
Brand	Maxwell
Model	MW-1443 PK
Power Supply	220-240 V ~ 50/60 Hz
Maximum Power	150 W
Operating Time per Cycle	5 minutes maximum
Break Between Cycles	At least 5 minutes
Maximum Cycles Before Cooling	3 cycles, then cool completely
Capacity	For small batches (approximately 2 cups)
Material	Plastic body with stainless steel components
Included Accessories	Pusher, instruction manual
Safety Features	Automatic shut-off not specified; safety precautions include keep out of reach of children under 8, do not immerse in water
Cleaning Method	Wash removable parts with warm water and neutral detergent; wipe motor unit with damp cloth
Storage	Store in a dry, cool place away from children
Preparation of Ingredients	Freeze fruits at -18°C for at least 12 hours
Usage	For domestic use only; suitable for fruit sorbet, toppings, and pastes
Reparability	Do not disassemble; contact authorized service center if malfunction
Guarantee	Conditions provided by dealer; product life 2 years
Certification	Conforms to EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC
Country of Origin	Not specified

Frequently Asked Questions - MW-1443 PK Maxwell

How to assemble the sorbet maker?

Insert the screw into the unit head. Place the lid so that the arrow on the lid matches the mark on the head body, then turn the lid counterclockwise to the lock position. Install the assembled head into the motor unit, aligning the arrow with the "●" mark, and turn counterclockwise until it stops.

How to make sorbet?

Freeze ingredients at -18°C for at least 12 hours. Assemble the unit, plug it in, and switch on. Slowly feed frozen fruits into the head using the pusher. Do not operate longer than 5 minutes per cycle. Allow a 5-minute break between cycles and cool completely after 3 cycles.

What types of ingredients can be used?

The unit is designed for frozen fruits (e.g., bananas, strawberries, peaches) and berries. It can also make pastes from cooked ingredients like chicken liver. For best results, use slightly overripe bananas to achieve a creamy texture.

How to clean the sorbet maker?

Always unplug before cleaning. Wash all removable parts (lid, screw, head, pusher) in warm water with a neutral detergent. Clean the motor unit with a damp cloth and dry thoroughly. Do not use abrasive sponges or solvents.

What is the maximum operating time?

Do not exceed 5 minutes of continuous operation. Allow at least a 5-minute break between cycles. After 3 cycles, unplug the unit and let it cool down completely to prolong its life.

What should I do if no product comes out?

Unplug the unit. Remove the head and lid, take out the screw, and clear any obstruction. Wash all parts with warm water and neutral detergent, dry, and reassemble. Ensure ingredients are properly frozen.

Can children use this appliance?

No, it is not intended for use by children under 8 years. Children over 8 may use it only under supervision. Keep the unit and its cord out of reach of children during use.

What power supply is required?

The unit requires 220-240 V~ 50/60 Hz mains voltage. Ensure your outlet matches before use. Maximum power consumption is 150 W.

How should I store the sorbet maker?

Clean and dry all parts before storage. Store in a dry, cool place away from children. Avoid high humidity and direct sunlight.

What recipes are included in the manual?

The manual includes recipes: Banana-Chocolate Sorbet (2 frozen bananas + 30-40g chocolate), Peach Sherbet, Lemon-Raspberry Sorbet, Strawberry Sorbet, Tropical Sorbet, and a Chicken Liver Paste.

USER MANUAL MW-1443 PK Maxwell

graph LR
    A["Rolling Gear"] --> B["Chrofting Gear"]
    B --> C["Cutting Component"]

graph LR
    A["Household with housing"] --> B["Component with circular opening"]
    B --> C["Component with cylindrical part"]

Line drawing of a kitchen utensil and bowl (no text or symbols)

Simple line drawing of a mechanical component with two parts and a base, no text or symbols present

СОРБЕТНИЦА

The unit is intended for preparing fruit desserts, sorbet and paste. Fruit sorbet is fruit ice-cream that can be made in several minutes from any frozen fruits or berries.

DESCRIPTION

1. Lid
2. Screw
3. Sorbet-maker head
4. Pusher
5. Motor unit
6. Power switch (I/O)

PRECAUTIONS

Read this instruction manual carefully before using the unit and keep it for the whole operation period. Mishandling the unit can lead to its breakage and cause harm to the user or damage to his/her property.

To reduce the risk of fire, to prevent electric shock and to avoid other injuries, it is necessary to observe the following safety measures when using the unit.

• Before using the unit for the first time, make sure that the voltage in your mains corresponds to the operating voltage of the unit.
  • Use only the accessories supplied.
• To avoid electric shock, NEVER IMMERSE the unit, the power cord and the power plug into water or any other liquids.
• Use a damp cloth to clean the unit body and then wipe the unit body dry.
  • Never leave the operating unit unattended.
• The operation time of the unit should not exceed 5 minutes. Make at least a 5-minute break between operation cycles. After 3 operation cycles unplug the unit and let it cool down completely.
• Always switch the unit off and unplug it before assembling, disassembling and cleaning.
• Place the unit on a flat steady surface away from heat sources, open flame, moisture and direct sunlight.
• Do not set the unit on a heated surface or next to it (for instance, near gas or electric stove, near a heated oven or a cooking surface).

• Handle the power cord with care, prevent it from multiple twisting and straighten the power cord regularly.

• Do not use the power cord for carrying the unit.

• Do not let the cord hang from the edge of a table, and make sure it does not touch sharp furniture edges and hot surfaces.
• When unplugging the unit from the mains, hold the power plug but not the cord.
• Do not connect or disconnect the power cord from the mains and do not touch it with wet hands, this may cause electric shock.
• This unit is not intended for usage by children under 8 years of age.
• Do not allow children to use the unit as a toy and do not allow them to touch the unit body and the power cord during the operation.
• During the operation and the breaks between operation cycles the unit should be placed out of reach of children under 8 years of age.
• This unit is not intended for usage by people (including children over 8) with physical, neural and mental disorders or with insufficient experience or knowledge. Such persons may use this unit only if they are under supervision of a person who is responsible for their safety and if they are given all the necessary and understandable instructions concerning the safe usage of the unit and information about danger that can be caused by its improper usage.
• For children safety reasons, do not leave polyethylene bags used as packaging unattended.
• Do not disassemble the unit by yourself, if any malfunction is detected or after the unit was dropped, apply to the nearest authorized service center.
• Transport the unit in the original package only.
• Keep the unit out of reach of children and disabled persons.

Attention! Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!

• Before connecting the unit to the mains, make sure that the unit is switched off.
• Do not push the products with any foreign objects or your fingers, use only the pusher (4)

ENGLISH

supplied with the unit for pushing the products through.

• Do not immerse the unit body into water or other liquids.
• To avoid obstructions, do not apply excessive force while pushing products.

BEFORE USING THE UNIT

After unit transportation or storage under winter (cold) conditions, it is necessary to keep it for at least two hours at room temperature before switching on.

• Wash all the parts that will contact products with warm water and a neutral detergent and dry them thoroughly before use.
• Clean the unit body (5) with a soft, slightly damp cloth, and then wipe it dry.

OPERATING THE UNIT

• The unit is intended for making fruit sorbet, different toppings for ice-cream and pastes for domestic use only.
  • Install the screw (2) into the unit head (3).
• Set the lid (1) so that the arrow on the lid (1) matches the mark on the body of the head (3) and turn the lid (1) counterclockwise to the mark (fig. 1).
• Install the assembled head (3) into the unit body (5) so that the arrow on the head (3) body matches the mark «●» on the motor unit (5) and turn the head (3) body counterclockwise until it stops (fig. 2).
• Insert the power plug into the mains socket.
• Put a suitable bowl under the hole in the lid (1) (fig. 3).
• Switch the unit on, setting the switch (6) to the position «I».
• Slowly feed the products into the mouth of unit head (3) using the pusher (4) (fig. 4).
• During operation use only the pusher (4) supplied with the unit.
• Do not use any other objects to push products; do not push the products with your hands.
• Do not make excessive efforts to push the products.
• When processing products in the unit, the operation time should not exceed 5 minutes. Make at least a 5-minute break between operation cycles. After 3 operation cycles unplug the unit and let it cool down completely. This will prolong the operation life of the unit.

- After you finish operating, switch the unit off, setting the switch (6) to the position «0» and unplug the unit; only after that you may disassemble the unit.

Useful recommendations

• Before making sorbets, all ingredients should be frozen at a temperature not higher than -18°C for 12 hours or more, and stones should be removed from stone fruits (e.g., from cherries, peaches, apricots, etc.).
• Peel bananas before freezing.
• For best results, use bananas in all sorbet recipes. Bananas allow achieving more viscous and soft consistency of sorbet, we recommend using slightly overripe bananas.
• Using bananas and other sweet fruits and berries, chocolate and similar ingredients allows to reduce the amount of added sugar.

CLEANING THE UNIT

• Always switch the unit off and unplug it after operation or before cleaning.
- Clean, wash and dry all the used parts immediately after operation.
- It is recommended to wash all removable parts in warm water with neutral detergent.
- Clean the motor unit (5) with a damp cloth, and then wipe it dry.
- Do not use coarse sponges, abrasives and solvents to clean the unit.

STORAGE

• Clean the sorbet-maker before taking it away for storage.
• Keep the unit away from children in a dry cool place.

EXEMPLARY RECIPES

Banana-chocolate sorbet

Ingredients:

2 frozen bananas, 30-40 g of chocolate

Pass all the ingredients through the sorbet-maker.

Peach sherbet

Ingredients:

^1/_2 glass of frozen peach pieces

^1/_4 glass of frozen melon pieces

^1/_4 glass of vanilla ice-cream

Pass all the ingredients through the sorbet-maker.

Lemon-raspberry sorbet

Ingredients:

2 frozen bananas

1 tbs. of lemon zest

^1/_2 glass of frozen raspberry

Pass all the ingredients through the sorbet-maker.

Strawberry sorbet

Ingredients:

2 glasses of frozen strawberry

^1/_2 glass of vanilla ice-cream

Pass all the ingredients through the sorbet-maker.

Tropical sorbet

Ingredients:

^1/_2 glass of frozen pineapple pieces

^1/_2 glass of frozen mango pieces

^1/_4 glass of coconut flakes

^1/_4 glass of vanilla ice-cream

Pass all the ingredients through the sorbet-maker.

The unit can be also used for making paste.

Ingredients:

200 g of chicken liver

sour apple (1 pc.)

Salt, pepper, sugar to your taste

100 g of butter

Wash liver, combine with a sliced apple (without peel) and fry. Add salt, pepper and sugar to taste. Then pass twice through the unit, add some broth and combine with whipped pre-melted butter.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSES
No ready product goes out of the hole of the lid (1)	Obstruction may have built up in the body of the head (3). Unplug the unit, remove the head body, remove the lid (1), take out the screw and remove the obstruction. Wash all the parts with warm water and neutral detergent. Dry them and install back to their places.
Leaks can be seen between the lid (1) and the body of the head (3).	Make sure that the silicone gasket inside the lid (1) is installed evenly.
Sorbet is too soft	The ingredients had not been cooled well enough.

DELIVERY SET

Sorbet maker - 1 pc.

Pusher - 1 pc.

Instruction manual - 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220–240 V \~ 50/60 Hz

Maximal power: 150 W

The manufacturer preserves the right to change design and specifications of the unit without a preliminary notification.

Unit operating life is 2 years

Guarantee

Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

This product conforms to the EMC-

Requirements as laid down by the Council

Directive 2004/108/EC and to the Low

Voltage Regulation (2006/95/EC)

КАЗАКША

СОРБЕТ ДАЙЫНДАУГА АРНАЛГАН БІДЫС

A production date of the item is indicated in the serial number on the technical data plate. A serial number is an eleven-unit number, with the first four figures indicating the production date. For example, serial number 0606xxxxxxx means that the item was manufactured in June (the sixth month) 2006.

KZ