Rødøy VCCH 9009.1 X - Range hood Velge - Free user manual and instructions

Product Type	Range Hood
Model	Rødøy VCCH 9009.1 X
Brand	Velge
Width	90 cm
Installation Type	Wall-mounted
Extraction Rate (max)	600 m³/h
Noise Level (max)	65 dB(A)
Number of Speeds	3
Control Type	Push buttons
Lighting	2 x 3W LED
Filter Type	Aluminum grease filter
Duct Diameter	150 mm
Energy Class	A
Power Supply	220-240 V ~ 50-60 Hz
Rated Power	150 W
Weight	12 kg
Material	Stainless steel / glass
Grease Filter Cleaning	Dishwasher safe or hand wash
Charcoal Filter (optional)	Replace every 3-6 months
Warranty	2 years

Frequently Asked Questions - Rødøy VCCH 9009.1 X Velge

How do I install the Velge Rødøy VCCH 9009.1 X range hood?

Installation should be performed by a qualified professional. Ensure the hood is at least 65 cm above electric hobs and 75 cm above gas hobs. Follow the mounting template and secure the hood to the wall using appropriate anchors. Connect the duct to an external exhaust or install a recirculation kit.

What are the dimensions of the hood?

The width is 90 cm. Exact height and depth dimensions can be found in the product manual. Typically, the height ranges from 60-120 cm adjustable.

How often should I clean the grease filter?

Clean the aluminum grease filter every month or more frequently with heavy use. It can be cleaned in a dishwasher at low temperature or hand washed with mild detergent.

Does this hood support recirculation mode?

Yes, it supports both ducted and recirculation modes. For recirculation, you need to purchase a charcoal filter separately. The filter should be replaced every 3-6 months.

What is the noise level of this range hood?

The maximum noise level is 65 dB(A) at highest speed. Lower speeds produce less noise, typically around 45-55 dB(A).

How do I replace the LED lights?

The LED lights are integrated and should be replaced by a qualified technician. Do not attempt to replace them yourself as they may require disassembly of the hood.

What should I do if the hood does not turn on?

Check if the power cord is plugged in and the circuit breaker is not tripped. Ensure the control buttons are clean and dry. If the problem persists, contact customer support.

Can I use the hood without a duct?

Yes, you can use it in recirculation mode by installing a charcoal filter and using the recirculation kit. The air will be filtered and returned to the kitchen.

How do I adjust the fan speed?

Use the push buttons on the control panel. Usually there are 3 speeds: low, medium, and high. Press the corresponding button to select the desired speed.

What is the energy class of this hood?

The energy class is A, which indicates high energy efficiency. The rated power is 150 W.

USER MANUAL Rødøy VCCH 9009.1 X Velge

WYCIAG (VENTILATION)

Exhausting cooker hood. The equipment is constructed in accordance with European Standards and with the requirements included in the following Directives: 2006/95EC (Low Voltage Directive), 2004/108 (Electromagnetic Compatibility).

PRESENTATION-

The equipment (Picture 1) is made of the following items:

1) Cooker hood body
2) Telescopic chimney

WARNINGS

The present instruction manual is an integral part of the appliance itself, therefore it must be carefully kept and ALWAYS accompany it, even in case of its assignment to another owner or user or in case the cooker hood is moved to another installation plant.

Any eventual adjustment to the electrical system, which may be necessary to install the cooker hood, must be carried out only by competent people. Any repair carried out by no competent people may cause damages. For any repair or needed technical action make reference to a Technical Assistance Center, which is authorized to carry out the replacement of the spare parts.

Always make sure that all the electrical parts (lights, exhaustion unit) are disconnected when the appliance is not in use.

By storms take off the main switch of the house electrical system. The using of the cooker hood must not be other than the use of exhausting units for cooking damps on domestic kitchens. The manufacturer does not accept any liability for damages caused by people, animals or things, by installation and maintenance mistakes or by any illegitimate use.

Make sure that the voltage (V) and the frequency (Hz) ratings indicated on the plate inside the cooker hood correspond to the ones available in the installation place.

We remind that the use of products functioning with electrical energy implies the observance of some essential security rules, as follows:

- This equipment is not intended for people (children included) with reduced mental or motor capacities, with lack of experience or knowledge, unless they are supervised or unless a person responsible for their security, gives them instructions regarding the use of the equipment. Children must be supervised in order to be sure that they do not play with the equipment.

• Any cleaning action is forbidden if the appliance hasn't been disconnected from the main power supply and if the main switch of the house electrical system is not off. If cleaning is not carried out according to these instructions, a fire may break out.
• Do not pull, take off or twist the cable coming out from the appliance, even though this has been disconnected from the main power supply.
• Do not sprinkle or throw any water directly on the appliance.
• Do not stick any sharp tool inside the exhausting holes and into the air discharge.
• Do not take out the filters in order to reach the internal sides of the appliance in case the main switch of the house electrical system is not off.
• Do not singe or flambé directly underneath the cooker hood. Take particular care when frying to ensure that the oil does not catch fire

INSTALLATION

Read the instruction manual before installing and/or using the hood.

The unit must be fitted at a distance of at least 65~cm . from the cooking

hob. If the mounting instructions of the gas cooker indicate a wider distance, respect it. The unit must not be mounted above cookers fitted with top radiant plate.

Respect all the air discharge regulations.

The air must not be discharged in a pipe used to discharge exhaust fumes produced by gas-fed equipments or fuel-fed equipments (this does not apply to filtering hoods).

The room must be adequately ventilated when the hoods is used together with other gas-fed or fuel-fed equipments.

For an easy access, it is advisable to move possible furniture under the installation area.

Installation of the hood onto the wall.

The hood is equipped with all the necessary fastenings for its installation, which are suitable for most surfaces. Anyway ask a professional to verify that the installation surface is strong.

Installation must be carried out by qualified installers according to present regulations.

First, provide for the installation of the speakers as shown in (Picture 4). After having drawn and drilled the wall as in (Picture 2), use the following fastenings for installation:

• Blocking dowels (A)
  •Suspended and levelling dowels (B)
• Brackets and screws for fixing the chimney to the wall (C)

ELECTRICAL CONNECTION

This equipment must be connected to a grounding plant. Two types of electrical connection can be used:

1) Using a standard plug to be connected to the power cable and inserted in a mains socket which must be accessible (so that the plug can be disconnected when servicing is carried out). Make sure that the plug is accessible also after the complete installation of the equipment.

2) By means of a fixed mains connection, fitting a bipolar switch, which ensures the disconnection, with an opening distance of the contacts

allowing a complete disconnection on the conditions of the overvoltage III category, according to installation regulations. The ground connection (yellow-green wire) must not be interrupted.

Refer to the plate inside the hood for the mains voltage and frequency ratings.

USE

This cooker hood can be employed as exhausting or filtering.

Exhausting (external evacuation). Kitchen smokes are driven outside through a flue joined to the exhaust pipe flue connector.

This pipe must not under any circumstances be connected to cooker, boiler or burner exhaust pipes, etc.

Filtering (inside recycling). In this case it is essential to install the activated carbon filters on the motor Smokes pass through the activated charcoal filter (Picture 3-D) to be cleaned and recycled in the kitchen environment by means of holes (E) from which the purified air will come out. These holes have to be free and communicating with the kitchen environment.

In this case you should not install the exhaust pipe without curve.

OPERATION

VENTILATION

The hood is supplied with a multispeed motor.

The hood should be run at low speed under normal conditions and at higher speeds only when there is a heavy build-up of fumes or odours. and then kept on until all odours have been eliminated. The controls consist of these commands. Press ⚠ to turn on the light, press 0-1 to switch on the hood at first speed and to switch off the aspirator,

press 2 3 4 to select functioning speeds. By pressing of the command 0-1 the motor starts running at the 1^st speed. The commands 2 3 4 switch the motor on respectively at the 2^nd , 3^rd and intensive speed. In order to switch the motor off press 0-1 once if set at the 1^st speed, twice if set at the 2^nd , 3^rd and intensive speed. With the button 4, select the maximum speed of the extraction fan for 5 minutes (button blinking), after which the extraction fan will automatically switch to the 9^st speed.

Adjustable and delayed self switching off

Pressing 0-1 for three seconds the 4 speed keys start blinking. The speeds correspond now to the choice of 5-10-15-20 minutes of self switching off. Pressing one of these buttons, it will blinks showing you the chosen time and the key corresponding to the current speed will light on.

0-1 corresponds to 5 minutes

2 corresponds to 10 minutes

3 corresponds to 15 minutes

4 corresponds to 20 minutes

While the self switching off is in function, it is possible to modify the speed previously set.

If you select the maximum speed, after 5 minutes the extraction fan switches to the 3rd speed and will automatically turn off at such speed.

MUSIC

key: Bluetooth. Press three seconds to activate the Bluetooth (the button starts flashing). Enable the Bluetooth on the external device and research the hood (initials RN52- ......). Once connected the button light stops blinking and stays on, the display will show BT. Use the external device to manage music and phone calls.

Use the key (volume) to adjust the volume, the display will show the volume level + -

To accept or end a call press the ✗key. During a phone call, the display will show "CALL". During a phone call you can adjust the volume using the key + -

To disconnect the external device, hold for three seconds the key, the device will be disconnected and the backlight intensity of the button will reduce in stand by mode.

key: Radio. Press three seconds to activate the radio. The backlight button lights up, the display will show the radio station frequency. To change frequency press the keys + - Use the key ▶ adjust the volume, the display will show the volume level + -

To turn off the radio press the radio key for three seconds, the radio turns off and the backlight intensity of the button will reduce in stand-by mode. The radio does not work when the hood is already connected with Bluetooth and is receiving music from the external device or when there is an active phone call.

Phone calls and the transmission of music tracks has priority over the radio.

In any case, after 10 seconds of unused, the display will show the volume level.

Filters maintenance reminder

Aluminium anti-grease filters

Once the hood is switched off, after 30 hour functioning, all the leds of the speed buttons switch on with a fixed light for 30 seconds to remind that aluminium anti-grease filter need cleaning. To reset the timer keep pressed the buttons 0-1 + 4 with the aspirator switched off, otherwise the reminder will occur again when the hood is switched off.

Charcoal filter (for filtering hoods)

Once the hood is switched off, after 120 hour functioning, all leds blink for 30 seconds to remind that the charcoal filters (if present) need to be replaced.

To reset the timer keep pressed the buttons 0-1 + 4 with the aspirator switched off, otherwise the reminder will occur again when the hood is switched off.

MAINTENANCE

Always disconnect the hood from the mains before carrying out any maintenance or cleaning operation.

Particular attention should be paid to the metallic anti-grease filters that are designed to trap particles of fat contained in the fumes. The metallic anti-grease filters must be washed at least once a month with detergent in hot water (or in the dish-washer). The filters may discolour after a few washes. This is normal and does not mean they have to be replaced.

ATTENTION: the grease collected in the filters can easily catch fire and it is therefore extremely important to clean the metallic filters on a regular basis as per instructions.

The activated charcoal filters are designed to collect unpleasant odours in the cooking fumes. The air is then released purified in the environment. The charcoal filters must not be washed, but replaced 2 or 3 times a year, depending on how much the hood is used. New filters are to be requested directly to the manufacturer. In order to replace the activated charcoal filters, you should remove the anti-grease filters. Your are then to take off the activated charcoal filters placed at the two ends of the aspirator. Turn the filters until they unfasten from aspirator (Picture 3 - D).

Invert the operation in order to install the new charcoal filters.

In order to remove the remaining glue or any impurity, the cooker hood must be cleaned immediately after installation and after having removed the protective film.

The cooker hood must be cleaned frequently both internally and externally (at least once a month).

Do not let dirt gather on the inner and outer surfaces of the hood.

To clean the exterior of the hood do not use either acid or basic products, or abrasive sponges.

Clean the hood with a sponge dampen in warm water and a little quantity of neutral detergent (for example dishwasher detergent), in order to remove possible particles of grease.

Rinse with a damp cloth, removing all the detergent carefully, following the satin finish direction on the steel surface.

Drying is very important, especially in areas where water is particularly

hard and leaves limestone.

The hood features a LED light that, in addition to offering a good lighting and a significant energy savings, are guaranteed to last on average 10 times more than traditional lights. For replacement, contact the Assistance Service.

IT

Directive 2009/95/EC, 2008/96/EC and 2009/108/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment, and waste electrical and electronic equipment

This symbol, crossed out wheelie bin, on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment or return it to the retailer upon purchasing a new replacement. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. Illegal disposal of waste is an offence and subject to penalties and fines.