How to configure the BeamZ Phantom 10000B laser for use with an ILDA interface?

Question

Accepted Answer

The BeamZ Phantom 10000B is equipped with a DB25 type ILDA connector, allowing it to be controlled via a compatible ILDA interface. Here are the general steps to configure your laser with an ILDA interface:

1. Physical connection

Use a standard DB25 cable to connect the ILDA output of your laser controller to the ILDA input of the Phantom 10000B.
Ensure that the connectors are securely attached to avoid any signal interruption.

2. Software configuration

Your laser control software must be configured to use the ILDA protocol.
Check that the software is compatible with the hardware and is set up to send signals via the DB25 port.
Adjust the ILDA output settings in the software according to the specifications of the Phantom 10000B.

3. Power on and test

Turn on the laser after connecting the ILDA cable.
Test the communication by sending signals from the software and observe the laser's response.
If the laser does not respond, check the connections, software settings, and ensure the cable is functional.

Important notes

The manual for the Phantom 10000B does not provide in-depth details on ILDA configuration, so it is advisable to consult the documentation of your laser control software for specific settings.
If you encounter difficulties, contact BeamZ support for technical advice tailored to your model.
The Phantom 10000B also supports DMX control via a 3-pin XLR connector, which can be an alternative if you do not have an ILDA interface.

User manual BeamZ Lighting : user manuals and guides in PDF

Models BeamZ Lighting most viewed

Other categories BeamZ

Recent questions about Lighting BeamZ