Question 1

Where is the start button on the STERWINS 36VBC233.1 grass trimmer and how do I use it?

Accepted Answer

The start button on the STERWINS model 36VBC233.1 grass trimmer is usually located on the handle of the device, within easy reach for convenient use.

Location of the start button

Look for a button or switch often marked with a power symbol (a circle with a vertical line).
It is usually found near the main handle for easy access during use.

How to start the grass trimmer

Make sure the battery is properly inserted and charged.
Press the start button while holding down the operating trigger.
Release the button once the motor starts.

This procedure allows for a safe and efficient start of your grass trimmer.

Question 2

How to install the cutting line on the STERWINS EGT2-25.4 lawn mower?

Accepted Answer

To install the cutting line on your STERWINS EGT2-25.4 lawn mower, first ensure that the device is completely turned off and unplugged from the electrical outlet. This precaution is essential to avoid any accidental start during the line installation operation.

Locate the cutting head and remove the spool cover by unscrewing or unclipping the fasteners. Once the protective cover is removed, you can access the cutting spool on which you need to wind the line. Prepare a new piece of line about 2 to 3 meters long, according to the manufacturer's recommendations.

To wind the line, insert one end into the first hole provided on the spool and wind it evenly and tightly, usually clockwise. Leave about 10 centimeters of line free on the outside so that it can deploy correctly. If the spool has a second hole, insert the other end of the line and continue winding in the same manner.

Once the winding is complete, secure both ends of the line in the notches provided on the spool to prevent it from unwinding during use. Check that the winding is tight and even. Then replace the spool cover and the protective casing on the cutting head, ensuring they are securely fixed. Tighten the retaining screw firmly with the provided screwdriver.

Important: Your EGT2-25.4 mower is equipped with an automatic cutting line feed head. Do not hit the cutting head on the ground, as this would damage this automatic distribution system. Once the installation is complete, you can plug in the mower and turn it on. The line will advance automatically as needed, extending about 8 millimeters with each stop and restart of the device to maintain optimal cutting length. Avoid frequently stopping and restarting the device to prevent unnecessary line waste.

User manual STERWINS Grass trimmer : user manuals and guides in PDF

Models STERWINS Grass trimmer most viewed

Other categories STERWINS

Recent questions about Grass trimmer STERWINS