How to disassemble the spool holder of the STERWINS 1200 BC-2 electric brush cutter?

Question

Accepted Answer

To disassemble the spool holder of the STERWINS 1200 BC-2 electric brush cutter, always start by unplugging the device from the electrical outlet and wait for the motor to come to a complete stop.

Gearbox Locking: Insert the hex key number 21 into the round hole of the gearbox, then manually turn the gearbox until the tool can be wedged and locked in place. This step is essential to safely remove the spool fasteners.

Removing the nut and fixing spike: Use the wrench number 13 to remove the nut number 16 that holds the spool assembly. Then remove the fixing spike number 15. Once these two elements are removed, the entire spool assembly can be unscrewed from the gearbox.

Extracting the spool assembly: Manually turn the spool assembly to completely unscrew it from the gearbox until it is fully extracted.

Important before reinstallation: Before reassembling or resuming use of the device, systematically check that the spool set is properly secured, that the button is tightened on the tube sleeve, and that all nuts and screws are properly tightened.

User manual STERWINS Electric brush cutter : user manuals and guides in PDF

Models STERWINS Electric brush cutter most viewed

Other categories STERWINS

Recent questions about Electric brush cutter STERWINS