How to connect two indoor handsets to a street panel on a HAGER MHF01X intercom?

Question

Accepted Answer

To connect two indoor handsets to a street panel on a HAGER MHF01X intercom, follow these steps:

1. Check the wiring

Ensure that the street panel and the two indoor handsets are correctly wired according to the diagrams provided with the product. Each handset must be connected to the panel via the designated connections (usually wires for power, audio communication, and triggering the latch).

2. Power supply

Check that the street panel and the handsets are powered correctly. A stable power supply is necessary to ensure the simultaneous operation of the handsets.

3. Handset configuration

If the handsets have settings (such as dip switches or address selections), configure them to recognize the same street panel.
Generally, for a multi-handset system, they should be wired in parallel on the audio and control line, allowing all to ring simultaneously.

4. Functionality test

Press the button on the street panel to check that both handsets ring and allow communication. Also test the door opening from each handset if this function is available.

5. Additional settings

If necessary, adjust the volume or contrast of the handsets for optimal comfort. Ensure that communication is clear on both handsets.

By following these steps, you should be able to effectively connect two indoor handsets to your HAGER MHF01X street panel.

User manual HAGER Intercom : user manuals and guides in PDF

Models HAGER Intercom most viewed

Other categories HAGER

Recent questions about Intercom HAGER