Q: How to operate the Jandy VSFHP185DV2AS pump?

Before starting: Ensure that the pump cover is securely fastened, all valves are open, and the connections are tight. Priming procedure based on pump position Pump located above water level: Fill the clear basket with water Check that the O-ring of the cover is free of debris Secure the cover with the locked indicators aligned Power the pump and start it Close the air relief valve of the filter when water flows Check for leaks Pump located below water level: Open the isolation valves between the pump and the pool drains/skimmers Open the air relief valve of the filter Power and start the pump Close the air valve when water appears Check for leaks Operating parameters The default priming speed is 2,750 RPM and takes about 15 minutes to prime the pump at a height of 3 meters. The operational speed range is from 600 to 3,450 RPM. The pump continues to operate until the power supply is stopped. Critical warning: Never run the pump dry - this will cause serious damage and void the warranty. The pump must always be supplied with water before starting.

Question 1

How to control and use the speeds of this Jandy VSFHP185DV2AS pump?

Accepted Answer

This variable speed pump does not have "programs" in the traditional sense. It operates by speed selection between 600 and 3,450 RPM, adjustable according to your needs.

Controlling the pump

Three control methods are available:

SpeedSet Controller (included) - local control via 6 m RS-485 cable
Jandy Automation Systems (AquaLink RS, TCX, etc.) - integrated control
External Switches (dry relays) - manual control via external switches

Speeds and auxiliary functions

The pump offers two built-in auxiliary relays that automatically activate external equipment at specific speeds:

Auxiliary 1: 1,725 RPM
Auxiliary 2: 2,250 RPM

For example, you can set up a booster pump or a chlorinator to automatically activate at these speeds.

Default speed

The default starting speed (priming) is 2,750 RPM.

For precise programming instructions for your SpeedSet controller or integration with Jandy automation, refer to the manual provided with your pump.

Question 2

How to operate the Jandy VSFHP185DV2AS pump?

Accepted Answer

Before starting: Ensure that the pump cover is securely fastened, all valves are open, and the connections are tight.

Priming procedure based on pump position

Pump located above water level:

Fill the clear basket with water
Check that the O-ring of the cover is free of debris
Secure the cover with the locked indicators aligned
Power the pump and start it
Close the air relief valve of the filter when water flows
Check for leaks

Pump located below water level:

Open the isolation valves between the pump and the pool drains/skimmers
Open the air relief valve of the filter
Power and start the pump
Close the air valve when water appears
Check for leaks

Operating parameters

The default priming speed is 2,750 RPM and takes about 15 minutes to prime the pump at a height of 3 meters. The operational speed range is from 600 to 3,450 RPM. The pump continues to operate until the power supply is stopped.

Critical warning: Never run the pump dry - this will cause serious damage and void the warranty. The pump must always be supplied with water before starting.

Question 3

How to lock and unlock the keypad of the Jandy JEPR pump?

Accepted Answer

Locking the Keypad

To activate the keypad lock and prevent accidental changes to the settings:

Press both directional buttons (up and down arrows) simultaneously
Hold them down for 5 seconds
Release the buttons

The screen will then display "KEYPAD LOCKED" to confirm that the keypad is locked.

Unlocking the Keypad

To deactivate the lock, repeat the same procedure: press both directional buttons (up and down) together for 5 seconds. The screen will return to the normal pump status display.

User manual Jandy Pump : user manuals and guides in PDF

Models Jandy Pump most viewed

Other categories Jandy

Recent questions about Pump Jandy