User manual H.KOENIG Beer dispenser : 3 free PDF user manuals

Q: In what order should I put the water and the keg in the H.KOENIG BW1880?

Yes, you must always fill the water reservoir before inserting the keg . Here is the correct order: Make sure the drain switch is set to OFF Pour 800 ml of clear water into the reservoir Once the water is in place, you can then insert the keg (compatible 5L universal kegs or 5L Heineken kegs) The system cooling usually takes 19 to 21 hours . For the best result, it is recommended to chill the keg for 12 hours before installing it in the device. To empty the water from the reservoir, open the drain by pulling the tap 90 degrees towards the drip tray.

Q: The piercing needle of the CO2 cartridge has come off, what should I do?

If the piercing needle (spillo perforatore) of your H.KOENIG BW1880 has come off, please note that the manual strongly advises against disassembling the CO2 cartridge piercing system. This can be dangerous. Recommended solution: Simply replace the defective CO2 cartridge with a new compatible 16g cartridge. Here’s how to proceed: Loosen the sleeve of the CO2 cartridge Insert a new 16g CO2 cartridge into the sleeve Tighten the sleeve firmly until you hear a distinct click, confirming that the cartridge has been pierced and that the gas is flowing correctly Replace the assembly under the machine cover The new piercing system of the new cartridge will work without any issues. According to the manual, each 16g cartridge can dispense over 5 liters of beer. If you prefer to have the original piercing system repaired, please contact the official H.KOENIG customer service.