Question 1

How to refill the rinse aid (Klarspüler) if the machine is currently running on the TELEFUNKEN TFGS60SI10A++?

Accepted Answer

If you have started a wash cycle and then noticed that the rinse aid (Klarspüler) is low, here’s how to safely refill it on your TELEFUNKEN TFGS60SI10A++:

Procedure

Stop the current program by pressing the On/Off button. The machine will interrupt the cycle and drain the water.
Open the door once the stop is complete and access the rinse aid compartment.
Fill the Klarspüler reservoir up to the indicated mark.
Close the door and press the On/Standby button (button 3) again to restart the program.

Good to know: The dishwasher will automatically resume the cycle from the step where it was interrupted. There is no risk in stopping the appliance to perform this operation - it is designed for this purpose by the manufacturer.

Question 2

Why is the program flashing but the TELEFUNKEN TFGS60SI10A++ dishwasher not starting?

Accepted Answer

If the program is flashing but the machine does not start, first check these simple points:

Door closed properly - Make sure the door is securely locked. An incomplete lock will prevent starting even if the program is selected.
Water supply - Check that the water supply tap is open and that the inlet filter is not blocked by debris or limescale.
Drain hose - Ensure that the drain hose is not bent, twisted, or clogged. A blocked drain can prevent starting.
Pump filter - Clean the filter located at the bottom of the inner tub to ensure no debris is obstructing the pump.

If after these checks the flashing persists and the machine still does not start, this may indicate a specific error code. In this case, refer to the error code table in your manual to identify the exact malfunction.

Question 3

Why is the end indicator flashing on the TELEFUNKEN TFGS60SI10A++ dishwasher?

Accepted Answer

The flashing end indicator on your TELEFUNKEN TFGS60SI10A++ dishwasher may indicate several situations:

1. End of wash cycle

The flashing may simply signal that the wash cycle is complete. You can then open the door and remove your dishes.

2. Door not properly closed

If the dishwasher door is not properly closed, the end indicator may flash to alert you. Check that the door is securely locked.

3. Water supply issue

A water supply issue, such as insufficient pressure or a clogged inlet filter, can cause this flashing. Ensure that the water supply is correct and that the filter is clean.

4. Drainage issue

If the dishwasher is unable to drain water, the indicator may flash. Check that the drain hose is not blocked and that the pump filter is clean.

5. Error signal

The flashing may also indicate an error code related to a malfunction. If other indicators are flashing or if you hear beeping, this may help identify the fault.

In summary, a flashing end indicator is a signal of attention that may correspond to the end of the cycle or a problem requiring verification. Check the door, water supply, drainage, and be attentive to other signals to accurately diagnose the cause.

User manual TELEFUNKEN Dishwasher : user manuals and guides in PDF

Models TELEFUNKEN Dishwasher most viewed

Other categories TELEFUNKEN

Recent questions about Dishwasher TELEFUNKEN