Q: When pairing the wind sensor with the motor, does the motor need to lower the awning or just be powered on?

When pairing your wind sensor ANEMO ZN DC116 , the motor simply needs to be powered on (energized) - it is not necessary for the awning to lower. Correct pairing procedure: Activate the power to the motor (without initiating any movement) Press 2 times on the P2 button of the remote control Press 1 time on the P2 button of the wind sensor to finalize the pairing Once the pairing is successful, the awning will lower when you press the UP button on the sensor, according to the configured wind speed threshold (15, 30, or 45 km/h depending on the chosen level).

Q: I can't pair my NATERIAL ANEMO ZN DC116 wind sensor and the UP button doesn't work as expected

The ANEMO ZN DC116 sensor is not a remote control - it is an automatic wind sensor. The UP button on the sensor closes the blind (instead of raising it like a remote control). Correct pairing procedure Turn on the motor (simple 230V power supply is sufficient) Press 2 times on the P2 button of your remote control Press 1 time on the P2 button of the sensor The LED will blink to confirm pairing Operation after pairing Once paired, the sensor monitors wind speed and automatically closes the blind according to the configured threshold: Threshold 0/1 : closes at 15 km/h Threshold 2 : closes at 30 km/h Threshold 3 : closes at 45 km/h Pressing the UP button on the sensor will also manually close the blind. To raise the blind, use your usual remote control. Troubleshooting If pairing fails: Check the 230V power supply to the motor Repeat the procedure (2x P2 remote control, then 1x P2 sensor) Ensure that the LED blinks at step 3

Question 1

When pairing the wind sensor with the motor, does the motor need to lower the awning or just be powered on?

Accepted Answer

When pairing your wind sensor ANEMO ZN DC116, the motor simply needs to be powered on (energized) - it is not necessary for the awning to lower.

Correct pairing procedure:

Activate the power to the motor (without initiating any movement)
Press 2 times on the P2 button of the remote control
Press 1 time on the P2 button of the wind sensor to finalize the pairing

Once the pairing is successful, the awning will lower when you press the UP button on the sensor, according to the configured wind speed threshold (15, 30, or 45 km/h depending on the chosen level).

Question 2

I can't pair my NATERIAL ANEMO ZN DC116 wind sensor and the UP button doesn't work as expected

Accepted Answer

The ANEMO ZN DC116 sensor is not a remote control - it is an automatic wind sensor. The UP button on the sensor closes the blind (instead of raising it like a remote control).

Correct pairing procedure

Turn on the motor (simple 230V power supply is sufficient)
Press 2 times on the P2 button of your remote control
Press 1 time on the P2 button of the sensor
The LED will blink to confirm pairing

Operation after pairing

Once paired, the sensor monitors wind speed and automatically closes the blind according to the configured threshold:

Threshold 0/1: closes at 15 km/h
Threshold 2: closes at 30 km/h
Threshold 3: closes at 45 km/h

Pressing the UP button on the sensor will also manually close the blind. To raise the blind, use your usual remote control.

Troubleshooting

If pairing fails:

Check the 230V power supply to the motor
Repeat the procedure (2x P2 remote control, then 1x P2 sensor)
Ensure that the LED blinks at step 3

User manual NATERIAL Wind sensor : user manuals and guides in PDF

Models NATERIAL Wind sensor most viewed

Other categories NATERIAL

Recent questions about Wind sensor NATERIAL