How to automatically tune the channels?

Question

Accepted Answer

To automatically tune the channels of your AIWA 70QS8093UHD:

First, make sure that your antenna is properly positioned for better signal reception
Press the Menu button on the remote control
Navigate to Settings (use the directional buttons)
Select Channels
Choose Automatic channel search
Select the broadcast type: Digital (DTT) or Cable depending on your reception source
Press OK to start the search

The automatic search then begins and scans all available frequencies. This process usually takes 5 to 10 minutes. During this time, your television displays in real-time the number of detected channels. Once the search is complete, a confirmation message appears and the found channels are automatically saved.

Practical tip: Upon first startup, a setup assistant appears. You can directly access the automatic channel search through this assistant by following the on-screen instructions. If you need to perform a search again later, simply follow the menu procedure described above. Wait for the search to complete before turning off the television or moving the antenna to avoid interrupting the process.

User manual AIWA TV : user manuals and guides in PDF

Models AIWA TV most viewed

Other categories AIWA

Recent questions about TV AIWA