Question 1

What is the part number for the timer switch?

Accepted Answer

The manual for the YWED49STBW does not directly specify the part number for the timer switch. However, Whirlpool specifies that you should use genuine FSP parts only (Factory Specified Parts) to ensure compatibility and safety for your dryer.

To obtain the exact part number for the timer switch, please contact:

Whirlpool Canada LP: 1-800-807-6777
Website: www.whirlpool.ca
Your designated Whirlpool repair center

Have the model number YWED49STBW and your serial number (located on the nameplate inside the door or on the side of the drum) ready to accurately identify the compatible part for your appliance.

Question 2

Why is my Whirlpool WGD4800BQ dryer not heating and how can I resolve this issue?

Accepted Answer

If your Whirlpool WGD4800BQ dryer is not heating, several checks need to be performed in a logical order. Start with electrical power issues, as this dryer requires a 240 V supply to operate correctly. First, check that the two fuses in your home are not blown or that the circuit breaker has not tripped. Electric dryers use two fuses or breakers: the drum may turn without heat if one of the two is faulty. Replace both fuses or reset the circuit breaker. If the problem persists after this check, contact a qualified electrician, as incorrect 240 V supply may be the cause.

Next, check that the lint filter is clean. A clogged lint filter can significantly increase drying times and affect air circulation, thus reducing heating efficiency. Clean the filter before each load by pulling it straight up and rolling the lint off with your fingers, without rinsing or washing it. About every 6 months, also clean the filter with a nylon brush and hot water to remove any detergent or fabric softener residues that may accumulate.

Inspect the venting system and duct. This is crucial for proper heating operation. Run the dryer for 5 to 10 minutes and place your hand under the outside vent flap to check for air circulation. If you do not feel air movement, it means the vent duct is clogged with lint or blocked. The duct should be 4 inches (102 mm) in diameter, as short as possible, and have no more than four 90° bends, as each bend reduces airflow. Also, check that the duct is not crushed or deformed. Clean the venting system and the exterior vent flap grille to remove any lint buildup.

Ensure that the dryer door is fully closed and that you press firmly on the “PUSH to START” button without releasing it until the drum starts to turn. A poorly closed door or insufficient activation of the start can prevent heating. Additionally, make sure that the ambient temperature of the room where the dryer is installed does not drop below 7°C (45°F), as the proper functioning of all programs requires an ambient temperature above this threshold.

If you have selected the “Fluff Air” cycle or the “No Heat” temperature setting, there will naturally be no heating. Select an ACCUDRY™ automatic drying program with an appropriate temperature setting (High, Medium, or Low) according to your type of laundry. Finally, do not overload the dryer: clothes should be able to tumble freely for good hot air circulation.

If after checking all these items the problem persists, consult a certified Whirlpool service technician. The issue may be related to a faulty heating element, a defective thermostat, or a blown thermal fuse, which can only be diagnosed by a professional. For gas dryers (although the WGD4800BQ model is an electric or gas version depending on your setup), also check that the gas line shut-off valve is open.

User manual WHIRLPOOL Tumble drier : user manuals and guides in PDF

Models WHIRLPOOL Tumble drier most viewed

Other categories WHIRLPOOL

Recent questions about Tumble drier WHIRLPOOL