CSU 36 - Portable audio player MPMAN - Free user manual and instructions

USER MANUAL CSU 36 MPMAN

USB/MP3/CD/Radio Portable Player INSTRUCTION MANUAL CSU-36 WARNING TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION

EXCLAMATION POINT - within an equilateral triangle, within an equilateral triangle, is intended to alert the is used to indicate that a specific component shall be user to the presence of uninsulated dangerous replaced only by the component specified in that voltage within the products enclosure that may be of documentation for safety reason. sufficient magnitude to constitude a risk of electric shock to persons. The following label has been affixed to the unit, listing the proper procedure for working with the laser beam: CLASS 1 LASER PRODUCT LABEL CLASS 1 LASER PRODUCT

KLASS 1 LASER APPARAT

LUOKEN 1 LAISERLAITE

KLASSE 1 LASER PRODUKT

This label is attached to the place as illustrated to inform that the apparatus contains a laser component. WARNING LABEL INFORMING OF RADIATION This label is placed inside the unit. As shown in the illustration. To warn against further measures on the unit. The equipment contains a laser radiating laser rays according to the limit of laser product of class 1. E-1 SAFETY INSTRUCTIONS

1. READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated.

2. RETAIN INSTRUCTIONS - The safety and operating instruction should be retained for future reference.

3. HEED WARNINGS - All warnings on the appliance and in the operating instructions should be adhered to.

4. FOLLOW INSTRUCTIONS - All operating instructions should be followed.

5. WATER AND MOISTURE - The appliance should not be used near water, for example, near a bathtub, washbowl,

kitchen sink, laundrytub, swimming pool or in a wet basement.

6. VENTILATION - The appliance should be situated so that its location or position does not interfere with its proper

ventilation. Do not place on bed, sofa, rug or similar surface that may block the ventilation openings, in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.

7. HEAT - The appliance should be situated away from heat sources such as radiators, stoves, or other appliances

(including amplifiers) that produce heat.

8. POWER SOURCE - The appliance should be connected to power supply only of the type described in the

operating instructions or as marked on the appliance.

9. POWER CORD PROTECTION - Power supply cords should be routed so that they are not likely to be walked

on or pinched by items placed upon or against them.

10. POWER LINES - An outdoor antenna should be located away from power lines.

11. OBJECT and LIQUID ENTRY - Care should be taken so that objects do not fall and liquids are not spilled into

the enclosure through openings.

12. ESD WARNING - The display does not function properly or no reaction to operation of any the control may due

to the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds.

13. DAMAGE REQUIRING SERVICE - The appliance should be serviced by qualified service personnel when:

a. The power-supply cord or plug has been damaged. b. Objects have fallen into, or liquid has been spilled into the appliance enclosure. c. The appliance has been exposed to rain. d. The appliance has been dropped, or the enclosure damaged. e. The appliance does not appear to operate normally.

14. SERVICING - The user should not attempt to service the appliance beyond that described in the user operating

instructions. All other servicing should be referred to qualified service personnel. Notes: a. Dirty or scratched CD may cause a skipping problem. Clean or replace the CD. b. If an error display or malfunction occurs, disconncet the AC cord and remove all the batteries. Then turn the power back on. BEFORE OPERATION Notes: CONCERNING COMPACT DISCS. Since dirty, damaged or warped discs may damage the appliance, care should be taken of the followings items: a. Usable compact discs. Use only compact disc with the mark shown below. b. CD compact disc only with digital audio signals. E-2 POWER SOURCES to a wall outlet Insert 6 x “C” size batteries into the battery compartment to AC IN AC POWER You can power your portable system by plugging the detachable AC power cord into the AC inlet at the back of the unit and into a wall AC power outlet. Check that the rated voltage of your appliance matches your local voltage. Make sure that the AC power cord is fully inserted into the appliance. BATTERY POWER Insert 6 x “C” size batteries into the battery compartment. Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove the batteries when appliance will not be used for a long period of time, as this will cause leakage to the batteries and subsequently damage to your set. Notes: - Use batteries of the same type. Never use different types of batteries together. - To use the appliance with batteries, disconnect the AC power cord from it. E-3

Set the “FUNCTION” selector to “RADIO” mode. Select desired band by using the “BAND” selector. Adjust radio frequency to your desired station by using the “TUNING” control. Adjust the “VOLUME” control to the desired level.

FM / FM-STEREO RECEPTION

- Set the “BAND” selector to FM mode for MONO reception. - Set the “BAND” selector to FM ST. mode for FM STEREO reception. The Stereo indicator light up to show FM ST. mode.

FOR BETTER RECEPTION

- Reorient the antenna for better reception. - Reorient the appliance to get better AM reception. E-5

Press to start playing CD / MP3 disc. Press again to stop playing CD / MP3 operation temporarily. Press again to resume playback. SKIP + SKIP - Press to go to the next track or back to the previous track. Press and hold while playing until you find the point of the sound.

Set the “FUNCTION” selector to “CD / MP3 / USB” mode. Open the CD door and place a CD / MP3 disc with the label up in the CD compartment. Close the CD door. Focus search is performed if disc is inside. For CD disc - Total number of tracks is read and appears on the display. For MP3 disc - “MP3” appears on the display.

5. Press the “PLAY / PAUSE / USB” button to start playing CD / MP3 disc.

6. Adjust the “VOLUME” control to the desired level.

7. Press the “PLAY / PAUSE / USB” button again when you want to stop playback temporarily.

8. Press the “STOP” button when finished.

PROGRAM Up to 20 tracks can be programmed for disc play in any order. Be sure to press the “STOP” button before use.

1. Press the “MODE” button, the display will show “P01” and flash.

2. Select desired track by using the “SKIP +” or “SKIP -” button. (You may select a desired album

by pressing the “ALBUM” button).

3. Press the “MODE” button again to confirm desired track into the program memory.

4. Repeat step 2 and 3 to enter additional tracks into the program memory.

5. When all the desired tracks have been programmed, press the “PLAY / PAUSE” button to play the

disc in the order you have programmed.

6. Press the “STOP” button twice to terminate programmed playback.

MODE Press the “MODE” button before or during playing CD / MP3 disc, each press switches the mode function as follows:

Press to start playing tracks from the USB . Press again to stop playing USB operation temporarily. Press again to resume playback. SKIP + SKIP - Press to go to the next track or back to the previous track. Press and hold while playing until you find the point of the sound.

STOP Press to stop all USB operation. PLAYBACK

Plug or slot in USB device to the port. (Make sure no disc on disc tray) Set the “FUNCTION” selector to “CD / MP3 / USB” mode. Press and hold the “PLAY / PAUSE / USB” button for a few seconds to entry USB mode. Playback will start automatically from the first track. Press the “STOP” button when finished. Press the “PLAY / PAUSE / USB” button again, playback will start from the first track. PROGRAM, MODE The operation of PROGRAM, MODE are as the same as that of CD / MP3. Please refer to CD / MP3 OPERATION. You can help protect the environment! Please remember to respect the local regulations: hand in the non-working electrical equipments to an appropriate waste disposal center. www.mpmaneurope.com E-8 Lecteur Portable USB/MP3/CD/Radio

MANUEL D INSTRUCTIONS

CSU-36 AVERTISSEMENT

CLASS 1 LASER PRODUCT

KLASS 1 LASER APPARAT

LUOKEN 1 LAISERLAITE

KLASSE 1 LASER PRODUKT

Presser pour aller à la piste suivante ou revenir à la piste précédente. SAUT - Presser et maintenir durant la lecture jusqu à ce que vous ayez atteint le point STOP Presser pour stopper tout fonctionnement CD / MP3. d écoute désiré. LECTURE

1. Set the “FUNCTION” selector to “CD / MP3 / USB” mode.

2. Open the CD door and place a CD / MP3 disc with the label up in the CD compartment.

3. Close the CD door.

4. Une recherché focalisée sera réalisée s il y a un disque à l intérieur.

Pour les disques CD – Le nombre total de pistes à lire apparaît à l écran. Pour les disques MP3 - “MP3” apparaît à l écran.

6. Adjust the “VOLUME” control to the desired level.

CLASS 1 LASER PRODUCT

KLASS 1 LASER APPARAT

LUOKEN 1 LAISERLAITE

KLASSE 1 LASER PRODUKT

CLASS 1 LASER PRODUCT

KLASS 1 LASER APPARAT

LUOKEN 1 LAISERLAITE

KLASSE 1 LASER PRODUKT