ESPRESSO SUPER AUTOMATIC - Super Automatic Coffee Machine POLTI - Free user manual and instructions

USER MANUAL ESPRESSO SUPER AUTOMATIC POLTI

1. button long coffee selection
2. button 1 coffee request
3. button 2 coffees request
4. button water dispensing
5. button steam dispensing
6. button (washing cycle
7. indicator light ON machine switched on
8. indicator light OK heating
9. indicator light lack of water
10. indicator light maintenance
11. Water container
12. Coffee grounds container
13. Drip-tray
14. Steam dispenser
15. Cover

16. Coffee beans container

17. Access cover to the infusion chamber

18. Coffee compression piston
19. Infusion chamber
20. Coffee slide
21. Coffee dispensers
22. Coffee length regulator handle
23. Grinding regulator handle
24. Grinding degree indicator
25. Warm plate for cups
26. Brush
27. Container unhooking lever
28. Mains ON/OFF switch
29. Power supply cable

Technical characteristics:

Power supply: 220-240V / 50Hz

Max power: 1700 W

Polti S.p.A. reserves the right to change specifications without prior notice.

PRECAUTIONS

Attention! Do not use the appliance without reading the instructions.

• Before using the POLTI Super Automatic read this manual carefully and store it for future use.
• Before connecting the appliance, ensure that the mains power supply and the power supply stated on the appliance match and that the mains socket is equipped with an earth.
• Do not touch the appliance with wet hands or feet when it is plugged into the mains.
• Do not place the appliance in water or in any other liquid.
• Unplug the appliance before performing any maintenance.
• Do not allow children to use the machine or any others who may not know how to operate it.
• Should the Super Automatic not be in use, it is advisable to unplug it from the mains.
• Do not touch the hot parts, the steam pipe and the water after use.
• Do not operate the coffee grinder without container and its cover.

PREPARATION OF THE MACHINE

1a. Before starting the operations, make sure that all the components are correctly placed, as shown in the picture in the KEY.
2a. Fill the container (11) (fig. 1) with tap water. The capacity is of about 2,6 ~L which allows a good operating range. It is also possible to remove the container (11) and fill it directly under the tap, carefully replacing it in its position.
3a. Open the coffee container (16) (fig. 2) by lifting the cover. Pour the coffee beans into the container and close it.

NOTE: the grinding and the amount of water are set during factory testing in order to make a good espresso. You can change these parameters according to your taste or to the necessity of particular blends as described in paragraph 4a and 6a.

4a. Open the access cover to the infusion chamber (17) (fig.3) by pushing in the middle of the left side. Now you can operate the grinding regulator handle (23). With this handle you can regulate the grinding degree and the amount of coffee that you want to use for each dose (fig. 4). By turning it clockwise (low numbers on the indicator "24"), you can have a coarser grinding. By turning it anti-clockwise (high numbers) you can have finer grinding. With finer grinding, the coffee will have a deeper and stronger taste, with coarser grinding the coffee will have a light and delicate taste. According to regulation of the type of grinding, the machine automatically chooses the right dose of coffee powder.
5a. After regulating, close the cover (17) putting it back in its position.
6a. Open the cover (15) by pulling and turning it outwards (fig.5). In this way you can reach the coffee length regulator handle (22). With this handle (22) you can set as you like the amount of water to be used for the preparation of your coffee: by turning the handle clockwise, more water will be used and so the coffee will be longer. Anticlockwise rotation will produce a stronger coffee.

NOTE: the regulator remains set for the next request. The machine is equipped with a selection button (1) for automatic dispensing of longer coffee. After regulating, close the cover (15).

7a. Connect the power supply cable (29) to the mains.

ENGLISH

8a. Push the mains ON/OFF switch (28). The ON indicator light will light up making a BEEP. The indicator light (7) will remain on.
9a. Wait a few minutes for the OK indicator light to be on.
10a. Push the washing cycle button (6) by using a cup to collect the water coming out from the dispensers (21); this operation is made for cleaning the machine and taking it to an optimum condition for the dispensing of the first coffee.

PREPARATION OF ONE COFFEE

Operate with the OK indicator light on.

1b. Put the cup on the drip-tray (13) underneath the coffee dispensers (21) (fig. 6bis).
2b. For a long coffee, preset by pushing the button (1).
3b. Push the button (2): in this way the machine makes all the steps in sequence until the dispensing of the desired dose in the cup.

The dispensing of the drink can be stopped by pushing any button (1-2-3-4-5-6)

PREPARATION OF TWO COFFEES

Operate with the OK indicator light on.

The dispensing of two coffees happens with two consecutive preparation cycles divided into two cups.

1c. Put two cups on the drip-tray (13), each one underneath a coffee dispenser (21).
2c. For two long coffees, preset by pushing the button (1).
3c. Push the button (3), the machine will make two consecutive operation cycles. Then wait until the complete dispensing of the desired dose in the cups.

HOT WATER DISPENSING

Operate with the OK indicator light on.

1d. Turn the steam dispenser (14) outwards.
2d. Put the cup or an empty container under the dispenser (14).
3d. Push the button (6), the dispensing of hot water will start and will last until it gets to 200 cc. To stop earlier, push the button again.
4d. Remove the container only when the water jet is exhausted.

STEAM DISPENSING

Operate with the OK indicator light on.

1e. Rotate the steam dispenser (14) outwards (Fig. 8).
2e. Put the container with the liquid under the dispenser (14) and push the steam button (5).
3e. After a few minutes, the steam will come out until you push the button again.
4e. The steam lance is set for frothing milk, allowing easier frothing during the steam heating of the milk.
5e. Should the machine be used for the dispensing of one coffee immediately after the steam dispensing, it is advisable to do a washing cycle by pushing the button (6) to restablish the correct water temperature.

CLEANING THE MACHINE

Washing button

The machine is equipped with a button (6) which operates the washing of the filters and of the infusion chamber. Simply push the button (6) and put an empty cup under the dispensers to collect the water (fig.6).

Cleaning the machine inside

1f. Disconnect the power supply cable from the mains.
2f. Open the cover (17) by pushing on the left side.
3f. Clean the piston (18) and the top side of the chamber (19) of coffee residue by using the brush (26) supplied (fig. 7).

Cleaning the drip-tray and the coffee container

1g. Disconnect the power supply cable from the mains.
2g. Remove the drip-tray (13), separate the grill, wash with warm water and then wipe it well.
3g. Remove the coffee grounds container (12), empty it, wash it with warm water and wipe it.
4g. Put both containers back in their correct position.
5g. Carry out this operation with the same frequency you fill the coffee container.

Cleaning the coffee container

1f. Disconnect the power supply cable from the mains.
1h. Open the cover (17) by pushing in the middle of the left side (fig.3).
2h. Pull the container unhooking lever (27) (fig.10).
3h. Lift the coffee container upwards (fig. 11), empty it of any residue, wash it with warm water and soap, rinse it and wipe it well.
4h. Put the container back in its correct position.
5h. Push the container unhooking lever (27). Close the cover (17).

LUMINOUS SIGNALS

This indicator light indicates the connection of the machine to the mains and the end of the control test.

When you open the cover, the indicator light will go out because the presence of a safety device cuts the power supply from the machine.

Lack of water. The indicator light will light up together with a sound signal to advise that the machine is out of water. Before restoring the level of the container, remember to switch off the mains ON/OFF switch and disconnect the power supply cable from the mains.

Serious alarm. When this indicator light lights up together with a siren sound, it indicates probable damage to an internal component. Contact the nearest Polti Authorised Service Centre.

GUARANTEE

The Vaporella is guaranteed to the original purchaser for one year from purchase date against manufacturing or raw material defects. The guarantee is not valid if the appliance has been misused in any way. Unauthorised alterations or repairs to the machine will automatically invalidate this guarantee.

• Polti declines liability for any damage or accident derived from any use of ESPRESSO SUPER AUTOMATIC which is not in conformity with the instructions contained in this booklet.

ESPRESS

SUPER AUTOMATIC

LEGENDA

PRODUKTIE VAN WARM WATER

OK