IAN 323157 - Light Decoration MELINERA - Free user manual and instructions

Product Type	Self-inflating LED Halloween figure
Model Numbers	10483A (Pumpkin with ghost), 10483B (Witch), 10483C (Ghost)
Total Power Consumption	7.2 W
Operating Voltage	12 V (figure), 3 V (LEDs)
Mains Adapter Input	220–240 V~, 50 Hz
Mains Adapter Output	12 V ===, 7.2 W
Protection Rating (Figure)	IP44 (splash-proof)
Protection Rating (Adapter)	IP20 (indoor only)
Illuminant	4 x 3 V LEDs, 0.06 W, 20 mA each (non-replaceable, non-dimmable)
Delivery Contents	Halloween figure, mains adapter, 4 ground stakes, 2 cords, operating instructions
Intended Use	Decorative lighting for indoor and outdoor use; not for room illumination
Installation	Plug in to inflate; secure with ground stakes and cords; ensure fan unobstructed
Cleaning	Use a clean, dry, lint-free cloth; do not immerse in water
Storage	Store in dry location; keep fan uncovered
Safety Features	Sandbag for stability; sealing rings required; adapter plug for indoor use
Warranty	36 months from date of purchase
Disposal	Do not dispose with household waste; recycle according to WEEE Directive
Manufacturer	Uni-Elektra GmbH, Kirchstrasse 48, 72145 Hirrlingen, Germany
Service Contact	Tel: [phone]; Email addresses for GB, IE, NI

Frequently Asked Questions - IAN 323157 MELINERA

How does the figure inflate itself?

The figure contains a built-in fan that operates when the mains adapter is plugged in. Make sure the fan opening is unobstructed and the zipper is closed for proper inflation.

Can I use this product outdoors?

Yes, the figure has an IP44 rating for splash-proof use outdoors. However, the mains adapter is IP20 and must be used only indoors or in a dry location.

What should I do if the LEDs stop working?

The LEDs are not replaceable. If they fail, the entire figure must be disposed of according to WEEE regulations and replaced.

How do I clean the Halloween figure?

Unplug the adapter first. Use a clean, dry, lint-free cloth to wipe the surface. Do not use water or any liquids to avoid electric shock.

Can I leave the figure plugged in continuously?

It is recommended to unplug the adapter regularly to allow the fan and adapter to cool down, preventing overheating and potential damage.

What is the warranty period and how do I claim?

The product has a 36-month warranty. Contact your retailer or Uni-Elektra GmbH service address (Tel: [phone]) before returning the product. Keep your receipt and item number.

How do I secure the figure in windy conditions?

Use the supplied ground stakes and cords. Tie the cords to the eyelets under the figure's arms and secure the stakes into the ground. Wear safety gloves when inserting stakes.

Is it safe to use if the power cable is damaged?

No. Never use the product if the power cable or any part is damaged. Dispose of the product properly if damaged.

Can I replace the sandbag inside the figure?

No. The sandbag is sewn in to provide stability. Do not remove it, as the figure may not stand properly.

What should I do if the figure does not inflate?

Check that the mains adapter is properly connected and the plug socket is working. Ensure the fan is not blocked and the zipper is fully closed. If it still does not inflate, contact service.

USER MANUAL IAN 323157 MELINERA

SELF-INFLATING LED HALLOWEEN FIGURE

GB IE NI

Operation and safety notes

DE AT CH

SELBSTAUFBLASENDE LED-HALLOWEENFIGUR

Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device.

DE AT CH

GB/IE/NI Operation and safety notes

Intended use......Page 7

Parts description ...... Page 7

Technical data......Page 8

Delivery contents...... Page 8

Safety information......Page 9

Installation Page 11

Storage, cleaning and care......Page 12

Disposal Page 12

Warranty and service......Page 13

Service address......Page 14

Manufacturer......Page 14

List of pictograms used
	Please read the operating instructions!		Suitable for indoor and outdoor use.
	Volts(alternating voltage)		Splash-proof
	Volts (direct current)		Power adaptor only suitable for indoor use
	Hertz (frequency)		Short-circuit proof safety transformer
	Watts(effective power)		Separate control unit
	Protection class II		Outlet connection polarity
	Observe the warnings and safety notices!		Power cable length
	Warning!Danger of electric shock!		Wear safety gloves!
	Never leave children unattended with the packaging material or the product.		Dispose of the packaging and product in an environmentally-friendly manner!

Self-inflating LED Halloween figure

- Introduction

Congratulations on the purchase of your new product. You have chosen a high-quality product. The instructions for use are a part of this product. They contain important information about safety, use and disposal. Before using the product, please familiarise yourself with all the instructions for use and safety instructions. The product must only be used as described and for the specified applications. When passing this product on to third parties, please be sure to include all documentation.

Intendeduse

This product is suitable for use as decorative lighting, indoors and outdoors. This product is not intended to light rooms. Any modifications to the product are considered improper use and may result in significant accident risks. The manufacturer assumes no liability for damages arising from improper use. The product is only intended for private household use and not intended for commercial use.

Suitable for indoor and outdoor use.

- Parts description

1 Ground stake
2 Cord
3 Figure

4 Mains adapter
5 Power cable

- Technical data

Model numbers: 10483A (Pumpkin with ghost)

10483B (Witch)

10483C (Ghost)

Total power consumption: 7.2 W

Voltage: 12V

Fairy lights:

Operating voltage: 3 V

Illuminant: 4 x 3 V, 0.06 W and 20 mA per LED

Protection type: IP44 (splash-proof)

Mains adapter:

Primary rated voltage: 220-240 V\~, 50 Hz

Secondary rated voltage: 12 V ===

Total power consumption: 7.2 W

Protection class: II/

Protection type: IP20 (only suitable for indoor use)

Model no.: ED-120072-IP20

- Delivery contents

1 Halloween figure

1 Mains adapter

4 Ground stakes

1 Set of operating instructions

2 Cords

Safety information

READ THE INSTRUCTIONS BEFORE USING THE PRODUCT! KEEP ALL SAFETY INFORMATION AND INSTRUCTIONS FOR FUTURE REFERENCE!

DANGIBLE LIFE AND RISK

OF ACCIDENTS FOR INFANTS AND CHILDREN!

Never leave children unsupervised with the packaging

material. There is a danger of suffocation. Children frequently underestimate the dangers. Always keep children away from the product.

This product may be used by children aged 14 and over as well as by persons with physical, sensory or mental impairments or lacking experience and knowledge provided that they are supervised or instructed in the safe use of the product and they understand the associated risks. Do not allow children to play with the product. Cleaning and user maintenance must not be performed by children without supervision.
■ The product must be set up out of the reach of children.
■ The assembly or operation of the decorative item must be performed by an adult.

CAUTION! RISK OF OVERHEATING! Do not operate the

product whilst it is still in the packaging.

■ Store the product in the original packaging after use to prevent damage.
- Do not hang anything from the product and do not cover the product, especially the fan.
■ Protect the product against extreme temperatures, direct sunlight, strong vibrations, high levels of humidity, moisture, flammable gases, vapours and solvents.
- Keep the product away from fire and open flames!

■ Handle the product with care. Impacts, blows or falls, even from low heights, can damage the product.
■ Ensure that the power cable and the cords are not crushed, kinked or damaged by sharp edges during installation.
■ Always lay the power cable and the cords in such a way that no one can trip over them or get caught on them. There is a risk of injury.
A sandbag is sewn into the product's interior. Its purpose is to weigh the product down and to stabilise it. Do not remove the sandbag from the product.
The product may not be used unless all sealing rings are properly installed.
■ Never install or use the product in or under water.
■ Make sure that the power cable always hangs loosely and is not too taut. Otherwise the cable may break.

Avoid the risk of fatal injury from electric shock!

WARNING! This product may not be used unless all sealing rings are properly installed!

• Check that the product is intact before use. A damaged product increases the risk of an electric shock.
  Before using the product, ensure the available mains voltage matches the operating voltage required by the mains adapter (220–240V\~, 50Hz).
• Never use the product if it is damaged in any way. If the power cable is damaged, the product must be rendered useless and disposed of appropriately.
• Protect the power cable from sharp edges, mechanical strain and hot surfaces.

• Do not secure with sharp staples or nails.
  ■ Always unplug the mains adapter from the socket before disassembling or cleaning.

• Never touch either the product's mains adapter or the product itself with wet hands.
  ■ Only use the product with the supplied mains adapter (model number: ED-120072-IP20).

• Plug only suitable for indoor use.
  ■ IP44 can only be achieved with a sealing ring on the connection to the plug-in mains adapter.
  ■ The LEDs are neither dimmable nor replaceable.
  If the LEDs fail at the end of their useful life, the entire product must be replaced.

- Installation

☐ Insert the plug of the power cable 5 into the socket of the mains adapter 4. Please note the notches when doing this.
☐ Tighten the union nut by turning it clockwise.
☐ Plug the mains adapter 4 into an easily accessible plug socket. Choose a plug socket from which you can easily remove the mains adapter 4 in order to switch off the product.
☐ The product inflates on its own and remains upright thanks to the fan. So that the product fills up with air without problems, make sure that the fan is unobstructed and the zipper is closed.
☐ The product can be fixed to the ground using the ground stakes 1 and the cords 2. To do this, tightly tie the cords 2 to the eyelets underneath the arms of the figure 3. Then attach the cords 2 to the ground stakes 1.
WEAR SAFETY GLOVES! Wear safety gloves to

insert the ground stakes 1. Do not install the ground stakes 1 if the ground is frozen.

☐ Push the grounds stakes 1 far enough into the ground (e.g. lawn, flowerbed) in the desired location so that they are stable in the ground. Check that they are firmly positioned. Do not use excessive

force, e.g. strike with a hammer, when you are pushing the ground stakes 1 into the ground. This will damage the product.

☐ Unplug the mains adapter 4 from the plug socket to switch the product off.
RISK OF INJURY! When dismantling the product, be sure to also remove the ground stakes 1 so that they cannot pose a hazard (e.g. tripping).
☐ Allow both the mains adapter 4 and the fan to cool down at regular intervals by removing the mains adapter 4 from the plug socket, in order to prevent overheating and potential damage.

● Storage, cleaning and care

WARNING! DANGER OF ELECTRIC SHOCK! Unplug the mainsadapter 4 from the plug socket before cleaning.

WARNING! DANGER OF ELECTRIC SHOCK! For electrical safety reasons, never clean the product with water or other liquids, or immerse it in water.

☐ Only use a clean, dry, lint-free cloth for cleaning.
☐ Regularly check the product for holes or other potential damages.
□ Keep the fan uncovered and free of dirt.
Store the product in a dry location while it is not in use.

●Disposal

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.

Observe the marking of the packaging materials for waste separation, which are marked with abbreviations (a) and numbers (b) with following meaning: 1–7: plastics / 20–22: paper and fibreboard / 80–98: composite materials.

The product and packaging materials are recyclable, dispose of it separately for better waste treatment. The Triman logo is valid in France only.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

Do not dispose of electrical equipment in the household waste!

In accordance with the European Directive 2012/19/EC on waste electrical and electronic equipment and its translation into national law, used electrical equipment must be collected separately and recycled in an environmentally responsible way.

To help protect the environment, please dispose of your product properly when it has reached the end of its useful life, and not in the household waste. Please contact your municipality for information on collection facilities and their opening hours.

- Warranty and service

Note: This product includes a 36-month warranty from the date of purchase. The product has been manufactured with care and thoroughly inspected prior to delivery. However, if defects in manufacturing or material arise during the warranty period, please contact your retailer immediately.

The warranty does not cover damages due to improper handling, failure to comply with the operating instructions, or manipulation by unauthorised persons. Most malfunctions are caused by incorrect operation. Therefore please first refer to the operating instructions if a malfunction occurs.

Please contact the Uni-Elektra GmbH service address before returning products. The product may only be returned to us after contacting us. Shipments that are sent carriage forward will not be accepted. The performance of services under the warranty does not extend or restart the warranty period of 36 months.

Service address

Uni-Elektra GmbH

Kirchstrasse 48

72145 Hirrlingen

GERMANY

Tel.: [phone]

GB [e-mail]

IE [e-mail]

NI [e-mail]

IAN 323157_1901

Please have your receipt and the item number (e.g. IAN 123456_7890) ready as your proof of purchase when contacting us.

Manufacturer

Uni-Elektra GmbH

Kirchstrasse 48

72145 Hirrlingen

GERMANY

CE

CE

Uni-Elektra GmbH

Kirchstr. 48

72145 Hirrlingen

GERMANY

Last Information Update · Stand