IAN 295695 - Solar lamp Livarno Lux - Free user manual and instructions

Product Type	LED Solar Lamp
Brand	Livarno Lux
Model	IAN 295695
Intended Use	Outdoor decoration, garden, balcony, terrace
Power Source	Solar cell + rechargeable battery
Operating Voltage	1.2 V
Battery Type	1 x NiMH, 1.2 V, 600 mAh, AAA (replaceable)
Lamp Type	1 LED, 0.06 W (non-replaceable)
Solar Cell	2 x monocrystalline, max. 1.1 V, 110 mA each
Protection Rating	IP44 (splashproof)
Lighting Function	Auto on/off at twilight/dawn; flicker effect (candle simulation)
Mounting	Ground spike included (free-standing)
Switch	ON/OFF switch
Charging Time	2–4 days in full summer sunlight (first charge: at least 1 day)
Scope of Delivery	Lamp (base + shade), ground spike, rechargeable battery, manual
Safety	For children aged 8+ with supervision; keep packaging away
Battery Replacement	User-replaceable (AAA NiMH)
Cleaning	Dry lint-free cloth; avoid caustic cleaners; keep solar cell clean
Storage	Dry, warm place; switch OFF
Warranty	3 years from purchase
Certification	CE
Disposal	Recycle battery separately; do not dispose with household waste

Frequently Asked Questions - IAN 295695 Livarno Lux

How do I mount the LED solar lamp?

Insert the ground spike into the holder on the base. Remove the lamp shade by lightly pulling it off. Set the ON/OFF switch to 'ON'. Then push the assembled lamp firmly into the ground (grass, flower bed) so it is stable.

How long does it take to charge the battery for the first time?

Place the lamp in direct sunlight with the switch set to 'ON'. The first charge takes at least one day in good summer sunlight. After that, full charge may take 2–4 days depending on sunlight.

Why does the light flicker? Is it defective?

No, the flicker effect is intentional. The LED lamp simulates the natural flickering of a candle flame. This is not a defect.

What type of battery does it use and can I replace it?

It uses one NiMH rechargeable battery, 1.2 V, 600 mAh, AAA size. Yes, the battery is user-replaceable. Follow the instructions to open the battery compartment and replace with the same type.

How do I replace the battery?

Remove the lamp shade, press the two plastic straps inward, and carefully pull out the battery compartment unit. Open the compartment, replace the battery with correct polarity, then reassemble.

Can I use the lamp indoors?

No, this lamp is designed for outdoor decoration only (e.g., garden, balcony, terrace). It is not suitable for indoor or commercial use.

Why won't the light turn on even after a sunny day?

Possible causes: the ON/OFF switch is set to 'OFF', the battery is drained, the solar cell is dirty, or other light sources (e.g., streetlights) are interfering. Check the switch, clean the solar cell, and relocate the lamp away from artificial light.

Is the LED replaceable?

No, the LED is built-in and non-replaceable. If it fails, the entire lamp needs to be replaced.

What is the protection rating of this lamp?

The lamp has IP44 protection, meaning it is splashproof and suitable for outdoor use.

What is the warranty period and what does it cover?

The warranty is 3 years from the date of purchase. It covers material and manufacturing defects. It does not cover consumables (like batteries) or damage from improper use. Proof of purchase is required.

USER MANUAL IAN 295695 Livarno Lux

Assembly, operating and safety instructions

IAN273603

IT PT

GB / MT Assembly, operating and safety instructions Page 41

Intended use Page 42

Parts description......Page 42

Technical Data Page 43

Scope of delivery......Page 43

General safety instructions Page 44

Safety instructions for rechargeable batteries......Page 45

Function......Page 46

Start-up

Mounting the light Page 46

Before first use

Charging......Page 47

Installing the light....Page 47

Cleaning and care / storage......Page 48

Replacing the rechargeable battery......Page 49

Troubleshooting......Page 49

Disposal Page 50

Warranty Page 51

LED Solar Lamp

- Intended use

The LED solar lamp is only suitable for decoration purposes and outdoor use, e.g. garden, balcony, terrace, etc. The LED solar light is not suitable for commercial use.

- Parts description

1 Lamp shade
2 Base (with holder for ground spike)
3 Ground stake
4 LED
5 Solar cell
6 ON/OFF switch (ON/OFF)
7 Battery cover
8 Battery compartment
9 Rechargeable battery

- Technical Data

Operating voltage: 1.2 V

Rechargeable battery: 1 x NiMH battery 1.2 V, 600 mAh, AAA

Lamp: 1 LED with 0.06 W (LED not replaceable)

Solar cell: 2 x monocrystalline, max. 1.1 V, max. 110 mA each

Protection type: IP44 (splashproof)

- Scope of delivery

Check immediately after unpacking that the parts are complete and that the product is in proper condition.

1 LED solar lamp (consisting of base and detachable lamp shade)
1 Ground spike
1 Rechargeable NiMH battery 1.2 V—, 600 mAh, AAA (assembled in lamp)
1 Instructions for assembly and use

General safety instructions

Before using the product, please familiarise yourself with all of the safety information and instructions for use! When passing this product on to others, please also include all the documents!

This appliance may be used by children age 8 years and up, as well as by persons with reduced physical, sensory or mental capacities, or lacking experience and/or knowledge, so long as they are supervised or instructed in the safe use of the appliance and understand the associated risks. Children should not be allowed to play with the device. Cleaning and user maintenance should not be performed by children without supervision.
■ Never leave children unsupervised with the packaging material. The packaging material represents a danger of suffocation. Children frequently underestimate the dangers.
- Keep children out of the area you are working in during assembly or whilst changing batteries. Screws are included. These may prove life-threatening if swallowed or inhaled.
- Do not use this article if you notice any damage!

Safety instructions for rechargeable batteries

WARNING!

DANGER TO LIFE! Rechargeable batteries are not intended to

be in the hands of children. If accidentally swallowed, seek immediate medical attention!

CAUTION! EXPLOSION HAZARD!

■ Never throw rechargeable batteries into fire or water!
- Avoid extreme environmental conditions and temperatures, which could affect batteries, e.g. above radiators/in direct sunlight.
- Do not exert mechanical loads to batteries!
- Do not use single-use batteries.
■ Never short-circuit or open rechargeable batteries.

Risk of property damage

■ Only use the specified battery type!
- When inserting the battery ensure that it is inserted the right way round! This is shown inside the battery compartment!
If necessary, clean the battery and device contacts before inserting the battery!

Wear safety gloves! If they come into contact with skin, leaked or damaged rechargeable batteries could cause chemical burns; you should therefore wear suitable protective gloves at all times if such an event occurs.

- Function

The solar cell 5 converts energy from sunlight into electricity. It charges the rechargeable battery inside the battery compartment 8 through the connected power cable. The battery stores electric energy supplied by the solar cell. In summer, completely drained batteries take about 2 to 4 days to fully recharge in good sunlight. The battery must be charged before using the light for the first time (see „Charging“).

- Start-up

- Mounting the light

The LED solar light is preassembled and ready for use at the time of delivery. Using the included ground spike the LED solar light can also be placed in flower beds, lower boxes or near pathways as accent lighting. To do so, insert the ground spike ③ into the designated holder on the underside of the light base ②.

☐ Remove the lamp shade 1 by lightly pulling it off the base 2. The battery compartment 8 is located inside the lamp shade 1.
☐ Set the ON/OFF switch to the „ON“ position.

Your product is now ready for use.

- Before first use

Note: The built-in LED lamp features a flicker function to simulate the natural flickering of candlelight. This is not a defect!

Charging

Note: The battery built into the LED solar light is charged at the time of delivery. However, it may have lost charge during transport from the manufacturer to the retail location. Therefore please charge the battery before the first use. The first charging will take at least one day in good sunlight during the summer.

☐ Set the ON/ OFF switch 6 to the „ON“ position (see Fig. D).

Note: In constant sunlight (depending on the season) drained batteries should take two to ten days to charge.

☐ Replace the rechargeable battery 9 if the light output does not improve after charging (see Fig. E).

- Installing the light

☐ For optimal results, place the LED solar light in a location where the solar cell is exposed to direct sunlight for as long as possible.

☐ Do not place the LED solar light under shrubs, trees, awnings, etc. This will reduce the incidence of sunlight.
☐ Position the LED solar light so the solar cell is not covered or shaded.
☐ Make sure the solar cell is not impacted by other light sources, e.g. yard- or street lighting, or the light will not switch on at twilight.
☐ In low light the light will automatically switch on, and automatically switch off in normal ambient light.

Note when using as accent lighting (with ground spike):

☐ Push the assembled LED solar light far enough into the ground (grass, flower bed) so it is stable. Make sure it is firmly placed.
☐ Do not use force during assembly or setup, e.g. hammer blows. This damages the product.

- Cleaning and care/ storage

■ Never use caustic cleaners.
☐ First switch off the product.
☐ Regularly clean the product with a dry, lint-free cloth. Use a slightly moist cloth to remove any stubborn dirt.

Note: Be sure the solar cell 5 is always clean to achieve good charging.

Cold temperatures do not negatively impact the battery operating time. When not using the product for extended periods, e.g. in winter, it should be cleaned and stored in a

dry, warm location. Be sure the ON/OFF switch 6 is set to the „OFF" position during storage.

● Replacing the rechargeable battery

☐ Remove the lamp shade 1 by lightly pulling it off the base 2. The battery compartment 8 is located inside the lamp shade 1.
☐ First press one of the two plastic straps in the direction of the ON / OFF switch 6. Then press the other plastic strap and carefully pull out the battery compartment unit.
☐ Open the battery compartment in the direction of the arrow (see fig. F).
☐ Remove the old battery and insert a new rechargeable battery in the battery compartment 8 noting correct polarity (see Fig. D-G).
☐ Then install all components in the reverse order. Be careful not to damage the cable.

- Troubleshooting

Problem

• The light will not switch on even though the sun shone on the lamp all day.
• Limited battery power.
• The light does not come on or only comes on briefly.

Cause

• LED solar light is not switched on.
  Battery 9 is drained or the solar cell 5 is dirty.
• Artificial light sources, e.g. street lights, are interfering with the light.

Solution

• Place the light in a location where other light sources will not interfere with it.
• Replace the battery.

- Disposal

The packaging is made of environmentally friendly materials, which may be disposed of through your local recycling facilities.

Contact your local community or municipal administration for more details on how to dispose your worn-out product.

To help protect the environment, please dispose of the product properly, and not in household waste, when it has reached the end of its useful life. Please contact your local authority for information on collection points and their opening hours.

Defective or exhausted rechargeable batteries must be recycled in accordance with Directive 2006 / 66 / EC and its amendments. Return rechargeable batteries and / or the appliance using the recycling facilities provided.

Environmental damage due to improper battery disposal!

Rechargeable batteries may not be disposed of with the usual domestic waste. Therefore dispose of used batteries through your municipal collection site.

- Warranty

The device has been manufactured to strict quality guidelines and meticulously examined before delivery. In the event of product defects you have legal rights against the retailer of this product. Your legal rights are not limited in any way by our warranty detailed below.

The warranty for this device is 3 years from the date of purchase. Should this device show any fault in materials or manufacture within 3 years from the date of purchase, we will repair or replace it – at our choice – free of charge to you.

The warranty period begins on the date of purchase. Please keep the original sales receipt in a safe location. This document is required as your proof of purchase. This warranty becomes void if the device has been damaged or improperly used or maintained.

The warranty applies to faults in material or manufacture. This warranty does not cover product parts subject to normal wear, thus possibly considered con sumables (e.g. batteries) or for damage to fragile parts, e.g. switches, rechargeable batteries or glass parts.

CE IP44