KF 992 E - Fridge Scandomestic - Free user manual and instructions

USER MANUAL KF 992 E Scandomestic

1. Unplug the power plug.
2. Remove the screws on both end of the light cover, take down the lamp cover, pull out the wires, then take away the lamp.
3. Install the new lamp, connect the wires, place the lamp cover and fasten it.

CIRCUIT DIAGRAM

Model: Upright Glass door freezer (F5, F10)

(F5)

(F10/KF990)

Abstract gray curved shape on white background (no text or symbols)

• Do not allow children to play with the appliance, or to sit on it or to hang onto the door(s).
• Make sure there is a suitable power outlet (230 volts, 13 amps outlet) with proper grounding to power the refrigerator.
• Do not store explosive substances, such as aerosol cans with a flammable propellant in this appliance.
• Keep clear of obstruction all ventilation openings in the appliance enclosure or in the structure for building-in.
• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufactures.
• Do not damage the refrigerant circuit.
• Do not use electrical appliance inside the food storage compartment, unless they are of the type recommended by manufacturer.

BEFORE USING FOR THE FIRST TIME

Do not position this appliance with its rear panel directly against a wall.

For good circulation and operating efficiency, the ventilation grilles must never be blocked.

Remove all packaging and place the freezer on a stable, secure flat surface. Position the freezer away from hear sources, where the unit is well-ventilated and protected from moisture, or extremes of heat or cold. The refrigerator may not function properly if the temperature rises above +30 (standard models). The refrigerator meets the operating conditions according to the standard EN 441-4 in climate class 4.

A 15A fuse is fitted. Never replace with a fuse rated higher than this.

NEVER USE AN EXTENSION LEAD

If the mains cable will not reach the nearest socket, either rearrange your store layout or ask a qualified electrician to fit a new socket.

If power is cut off, wait for at least 5 minutes before plugging the unit in again to avoid damaging the compressor.

Do not place combustible, explosive or volatile articles, corrosive acid or alkali, or liquid in glass containers into the freezer. Always exercise caution if adjusting the temperature.

IMPORTANT: allow the refrigerator to stand upright for 8 hours before plugging

Place the shelves firmly on their supports. The maximum load for a shelf is 40Kg. Check that the refrigerator is functioning properly before installing and filling it. The electronic thermostat is located on kick plate of the unit. An optional light switch is beside

Never put warm or hot foods directly into the freezer.

ELECTRONIC THERMOSTAT

Press the "SET" key, the display will flash, select the desired target temperature by pressing the "SET" key again.

The thermostat has been pre-set and in most cases, it is not necessary to adjust the settings.

Alarm

Codes flashing on controller

"1H" - cabinet sensor short circuit warning or high interior cabinet alarm "1L" - cabinet sensor open circuit warning or high interior cabinet alarm "2H" - defrost sensor short circuit warning or high interior cabinet alarm "2L" - defrost sensor open circuit warning or high interior cabinet alarm Please call a qualified engineer to come and repair.

Defrost

The freezer is automatically defrost.

Only if the door is opened more frequently a manual defrost is requested. To go to manual defrost, by pressing the defrost button on controller.

CLEANING

1. Unplug your freezer and remove any stock to a suitable back-up freezer.

2. Wash the inner compartment with warm water and neutral detergent. DO NOT allow the control panel, cables or plug to get wet.
   NEVER use corrosive detergents, wire brushes, or abrasive scourers to clean your freezer.
   NEVER use metal or sharp implements to remove debris.

3. Dry all surface thoroughly
4. To ensure trouble-free operation the condenser should be cleaned every three months where appropriate using a vacuum hose. The condenser is located behind lower metal cover of the cabinet. In exceptionally dusty locations the condenser should be cleaned more often.
5. Use mild soapy water to clean the gasket and seals

Welcome to your new Freezer

Thank you for buying this commercial freezer. It has been designed and manufactured from many years of trouble-free service.

Operation is very simple, but please take a few minutes to read this booklet. It contains safety information and tips to ensure you receive from your freezer.

WARNING: RISK OF ELECTRICAL SHOCK HAZARD USHRS IN EUROPE This unit must be reached. If the power table is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard. Ensure that the appliance immediately if electric shock is left when touching the chiller.

DISPOSAL OF OLD APPLIANCES

BE SURE OF MAKE ANY LOCKS UNUSABLE, REMOVE ANY DOOR(S) AND DISCARD SEPARATELY.

WARNING-CHEMICAL HAZARD:DO NOT ALLOW CHILDREN TO PLAY WITH THE OLD APPLIANCE. CONTACT YOUR LOCAL AUTHORITY FOR DISPOSAL PROCEDURES.

Before disposing of an old appliance, please make sure it is switched off and safe. Unplug the appliance and break any locks in order to avoid children becoming trapped.

Please note: the refrigeration system contains gas and refrigerants which require specialist waste disposal. The valuable materials in a refrigerator can be recycled. Contact your local waste disposal depot for proper disposal of an old appliance and contact your local authority to dealer if you have any questions.

Please ensure the pipework of your refrigerator is not damaged prior to disposal. You can contribute to environmental awareness by insisting on an appropriate non polluting method of disposal.

DISPOSAL OF PACKAGING

Do not allow children to play the packaging, and destroy plastic bags safely.

The cardboard may be broken or cut into smaller pieces and given to a waste paper disposal service. The wrapping foil is made of polyethylene. The polyethylene pads and shuffling contain no fluorochloric hydrocarbons.

All these valuable materials may be taken in a waste collecting depot and used again after adequate recycling. Consult your local authority for the name and address of the waste paper disposal services nearest to you.

IMPORTANT SAFETY INSTRUCTIONS

Before switching on your freezer for the first time, read the information in this user manual carefully. The manual contains important observations relating to the assembly, operation and maintenance of the appliance.

Please keep this booklet in a safe place for future reference. If you ever sell your freezer hand this user manual to the new owner.

The manufacture does not accept responsibility for any damages that may arise due to non-observation of these instructions. The user is liable for any material damage or bodily (product liability) cause by using the refrigerator rarslessly or failing to follow instructions.

- Do not use damaged appliances. If you are in any doubt, consult an engineer.

- Connection and installation of your freezer are to be carried out in strict compliance with the relative instruction in this manual.

- For safety, the appliance must be properly earthed in accordance with specifications.

- Do not damage any parts of the appliance which can't refrigerant by piercing, perforating, crushing, twisting or scraping. If the refrigerant comes into contact with the eyes, it may cause serious eye injury.

- Always remember to unplug the appliance before cleaning. Never unplug your appliance by pulling on the power cable. Always grip plug firmly and pull straight out from the socket. Always check that the plug and cable are undamaged.

- All repairs must be carried out by qualified engineer. Inadequate repairs may be dangerous. Never try to repair the refrigerator yourself.

- Should the cover of the interior light or fan fall off or break, switch the refrigerator off immediately and replace the cover.

- Ensure your chosen location has a flat and stable surface. The unit may be leveled by turning either or both of the adjustable feet in the front corners. Check the unit is level using a spirit level.

- Do not obstruct or cover the ventilation aperture.

- Do not position this appliance with its rear panel directly against a wall. Maintain a gap of at least 50mm between the appliance and any adjacent wall.

- Position the freezer away from heat sources, where the units is well-ventilated and protected from moisture, or extremes of heat or cold. The refrigerator may not function properly if the temperature rises above +30°C (standard model)

DK

Adgang til professionel reparation, såsom internetsider, adresser, kontaktoplysninger

Model nr: KF 992 E

Access to professional repair, such as internet webpages, addresses, contact details.

Model no: KF 992 E

Aftersales service station list:

Address	Scandomestic A/S
Contact Number	7242 5571
Website	Scandomestic.dk
QR code	365523
Relevant information for ordering spare parts, directly or through other channels provided by the manufacturer, importer or authorised representative;	Scandomestic A/S
The minimum period during which spare parts, necessary for the repair of the appliance, are available;	8 years
Instruction on how to find the model information in the product database, as defined in Regulation (EU) 2019/2024 by means of a weblink that links to the model information as stored in the product database or a link to the product database and information on how to find the model identifier on the product.1	www.scandomestic.dk

Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.

DE