HG05036 - Uncategorized SILVERCREST - Free user manual and instructions

Product Type	Electric salt and pepper mill
Model Number	HG05036
Brand	SilverCrest
Power Supply	6 x AAA 1.5V batteries (included)
Operating Voltage	9V
Current Consumption	560 mA
LED Light	Yes, underneath the mill
Grinding Mechanism	Adjustable via screw on bottom
Material	Plastic and stainless steel (assumed)
Capacity	Fills up to max level mark in container
Use	For coarse salt and peppercorns
Not for Commercial Use	Yes
Safety Warnings	Keep away from children; do not immerse; do not recharge batteries
Cleaning	Wipe exterior with dry cloth only; do not use liquids
Repairs	Do not disassemble; contact specialist personnel
Disposal	Recycle batteries and device according to local regulations

Frequently Asked Questions - HG05036 SILVERCREST

How do I insert the batteries?

Open the battery compartment (located under the top part). Insert 6 AAA 1.5V batteries with correct polarity as indicated. Close the compartment securely.

How do I fill the salt or pepper mill?

Hold the base with container and turn the top part counterclockwise until the arrow points to the unlock symbol. Remove the top part, fill the container with coarse salt or peppercorns up to the max level mark, and reassemble by turning the top part clockwise.

How do I adjust the grinding coarseness?

Turn the adjustable screw on the bottom: clockwise for finer grind, counterclockwise for coarser grind. If the mechanism jams, loosen the screw and shake the mill to release stuck pieces.

How do I turn on the LED light?

The LED light under the mill automatically activates when the mill is turned on. It illuminates the salt/pepper being dispensed.

Can I use wet or damp salt/pepper?

No, the mill is intended for dry coarse salt and peppercorns. Moisture can damage the mechanism.

How do I clean the mill?

Only clean the exterior with a dry cloth. Do not use water, liquid cleaners, or immerse the device. The grinding mechanism should not be cleaned with liquids.

What should I do if the mill stops working?

First, check if the batteries are inserted correctly and have power. If the grinding mechanism is blocked, turn the adjustable screw to a coarser setting and shake the mill. If the issue persists, contact customer service.

Are the batteries rechargeable?

No, do not recharge the batteries. Use only standard 1.5V AAA alkaline batteries. Remove batteries if the device will not be used for a long time.

Is the mill safe for children?

This appliance can be used by children aged 8 years and above with supervision. Children should not play with the mill. Keep away from children under 8 years due to small parts and batteries.

How should I dispose of the mill?

Do not dispose of the mill or batteries in household waste. Recycle them at appropriate collection points according to local regulations. The device contains electronic components.

USER MANUAL HG05036 SILVERCREST

The product is not intended for commercial use.

● Technical specifications

Botteries: 6 x 1.5V/mmAAA (included)

Operating voltage: 9V

wavelength: 5 LEB x 0.00 W (250 Hz replaceable)

Rated input current: 560mA

[Non-Text]

• Description of parts

1 Top part

2 Switch 1 Bottom

4 Motor

5. Base with containers

6 Arondia seal cover 7 Containers crew

8 LED light

1. Adjusted SWE

Safety information

B

Children frequently underesti-

mate the dangers. Children

should be kept away from the product.

Tel: L1 L2 L3 L4

- This appliance can be used by children aged from 8 years and above and

persons with reduced physical sen-

sory of

experien

have been given supervision or

instruction concerning use of the appli-

ance in a safe way and understand

the hazards involved. Children shall

not play with the appliance. Cleaning

made by children without supervision

Do not use the device if it is damaged.

Damaged devices represent a danger

of death from electric shock!

Do not expose the device to

- extreme temperatures

- strong vibrations,

- strong mechanical stresses

- direct scoring,

- Moisture.

Otherwise the device may be dam-

aged.

Please note that the guarantee does

for cover damage caused by incorrect

handling, non-compliance with the

with the device by unauthorised indi

viduals

Under no circumstances should you

take the device apart. Improper repairs

may place the user in considerable

danger. Repairs should only be car

ried out by specialist personnel.

Please keep the product clean.

Please fill the salt and pepper mill

"

does not affect the taste and

aroma properties of foodstuffs.

- Switch off the appliance before char

ging accessories of approaching

Be careful when touching the sharp

blades of the grinding mechanism

and when emptying and cleaning

the device.

[Non-Text]

Safety instructions

for batteries

A WARNING DANGER TO LIFE

Batteries are be swallowed which

may represent a danger to life. If a

battery has been swallowed, medical

help is required immediately.

Remove the batteries from the device

If they are not going to be used for a prolonged period.

CAUTIONI DANGER OF

EXPLOSION! The batteries

must never be recharged!

When inserting the batteries, ensure

the correct polarity! Damage to the

device could result! The correct po-

larity is shown inside the battery

compartment 1

- If necessary, clean the batteries and

device contacts before inserting the

batteries.

- Remove spent batteries immediately

from the device. There is an increased degree of local damage to

the device could result

- Batteries must not be disposed of in

the normal domestic waste!

= Every consumer is legally obliged to

dispose of batteries in the proper

manner!

CAUTION! DANGER OF

EXPLOSION! Keep batteries

IAN 273559

amounts of water and/or a doctor

contacted if necessary!

。

Use

- Insert Batteries / Filling of the

salt and pepper mill (fig. A+B)

Indications The salt and pepper mill is intended for

reddescents or coagins sa

Proceed as follows:

1. Hold the base with container S still and turn the

top part □ blindocrawe until the arrow on the top set □ points to the array where the C symbol on

part □ points to fill draw above the ■ symbol on the base with container □5.

1. Now pull the top part 1 off the base with container 5

2. Pull the container cover [7] off the base with con-

3. Fill the have with restrictions 5 with necessary use

4. The bar bale with conlalve (2) well pepper cens of coarse salt. The best results are obtained when you be

the base with container 5 up to the maximum level

mark.

1. Place the container cover [7] back onto the base with containers [8].

2. Insert 6 new AAA 1.5V batteries

Notes: Ensure correct polarity. This is indicated in the

battery compartment 3

1. Place the top part □ back onto the base with

2. Hold the base with container □ still and tighten

the top part 1 clockwise until the arrow on the top

part ± points to the onow above the ■ symbol on

the base with container 5

[Non-Text]

- Usin

and pepper mill (fig. A+C)

B574

Full on the dlated seal cover [8] not in the box with curtains [9] before up.

Please keep the button 2 pushed to ac

and pepper mill. At the same time, the LED light ☐

underneath the salt/pepper mill is activated.

Notes: Use the mill only when the container 5 is full

and do not leave the mill switched on uninterrupted

for longer than 1 minute so that it does not overheat. After using the mill for one minute, let it gool down for

After using the mirror one throw, at 1:00 a diameter of at least 3 minutes before switching it on again.

a. The 2017 Annual EPS estimate is \$0.85.

2.1.1

- Adjusting the grinding level (fig. D)

(1)

finer grinding level.

□ T

a coarser grinding level.

Note! Choose a cooser setting if the grinding mechanism stops starting when you are using a very fine

where steps finishing over you are using a very short setting. If the grinding mechanism still refuses to rotate.

1

able screw (♀) and loosen the grinding mechanism.

Rescise the truck pieces by soaking the grinding proving, free fitter the tilvatable compa ^5 varia

He mechanism, the schematic capable of again

[Non-Text]

[Non-Text]

- Cleaning and maintenance

(1)

■ Under no circumstances should you use liquids or

The device should only be cleaned on the outside

with

[Non-Text]

● Disposal

The Ground Truth image displays a single, solid horizontal line. According to Rule 2 (UNDERSCORE & LINE RULES), this is a stylistic or background line, not a placeholder underscore. Therefore, the OCR result must ignore it and output nothing or only meaningful text. The provided OCR content is "\_\_\_\_", which consists of four underscores. This is an incorrect interpretation of the line as a placeholder, violating the rule that stylistic lines must be ignored. The OCR has hallucinated underscores where none should exist based on the GT's visual context. Hence, the OCR result is inconsistent with the Ground Truth.

©

C

广力云智慧零售收银系统

Contact your local refuse disposal authority for more data

of how to

表决

宜

reached the end of its useful life and not in the

household waste. Information on ca

points and half opening keys could obtained from your local authority.

1. 2017年1月1日星期四

Faulty or used batteries must be recycled in accordance

with Directive 2006/66/EC and its amendments. Pleas

return the batteries and/or the device to the available

convention

Environmental damage through

incorrect disposal of the batteries

In millions

Buchelles Hwy. Waste They

ject to harpard

The chemical

Cd = codmium should differ

point

purs.

m = 311

Warro

The division is

lines and net

event of prod

[Non-Text]

Gib

m = 311

-

-

m = 311

Vnasp

nost, d

= Upošte

čenči

con the

Bik

20

poc

obr

No

lia

lohl

100

nev

No

= Izdc

= Mli

pop

。

m = 311

• • • • • •

:

1.04514

LIMM L Stöbelg

74167M

Deutschlo

•

Serviano

:

•

1.5 sec

Co.

molar

YOZU

pog

101

2. Gor

jo.

J. Gorv

doie

4. Kupe

•

-

m = 311

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]

[Non-Text]