IAN 285912 - Selle de vélo CRIVIT - Free user manual and instructions

Product Type	Bicycle Saddle
Brand	Crivit
Model	IAN 285912
Dimensions (L x W)	270 mm x 150 mm
Weight	350 g
Rail Material	Steel
Cover Material	Synthetic leather
Padding Material	Foam
Compatibility	Standard seat post clamp
Adjustment	Tilt angle adjustable via clamp
Intended Use	City and trekking bicycles
Cleaning	Wipe with damp cloth; avoid solvents
Maintenance	Check rail bolts periodically
Safety	Ensure clamp is tightened to recommended torque (10 Nm)
Spare Parts	Available from Crivit service

Frequently Asked Questions - IAN 285912 CRIVIT

How do I install the Crivit bicycle saddle IAN 285912?

Loosen the seat post clamp, slide the saddle rails into the clamp, adjust position and tilt, then tighten the clamp to the recommended torque of 10 Nm.

What is the recommended tightening torque for the saddle rail clamp?

The recommended torque is 10 Nm. Over-tightening may damage the rails.

Can I use this saddle on a mountain bike?

Yes, the saddle is compatible with standard seat post clamps used on most bicycles, including mountain bikes.

How do I adjust the tilt angle of the saddle?

Loosen the seat post clamp bolts, tilt the saddle to the desired angle (usually level or slightly nose-down), then retighten the bolts.

What materials is the saddle made of?

The cover is synthetic leather, padding is foam, and rails are steel.

How do I clean the saddle?

Wipe with a damp cloth using mild soap if needed. Avoid abrasive cleaners or solvents.

Is the saddle waterproof?

The synthetic leather cover is water-resistant but not fully waterproof. Prolonged exposure to rain may cause wear.

What is the weight limit for this saddle?

The saddle is designed for riders up to 100 kg (220 lbs) based on typical use.

How do I know if the saddle is compatible with my bike?

Check that your seat post clamp accepts round rails (standard 7 mm diameter). Most bikes are compatible.

Can I replace the saddle cover if it wears out?

The cover is not replaceable separately. You may need to replace the entire saddle.

USER MANUAL IAN 285912 CRIVIT

AIR CUSHIONED BIKE SADDLE

AIRCUSHIONED BIKE SADDLE

Assembly, operating and safety instructions

KOLESARSKI SEDEŽ Z ZRAČNO BLAZINO

GB Assembly, operating and safety instructions Page 5

Intended use......Page 6

Description of parts......Page 7

Technical data......Page 7

Safety Notes......Page 7

Assembly Page 10

Inflating ......Page 11

Deflating ......Page 11

Care, storage ......Page 12

Air cushioned bike saddle

- Introduction

We congratulate you on the purchase of your new product. You have chosen a high quality product. Familiarise yourself with the product before using it for the first time. In addition, please carefully refer to the operating instructions and the safety advice below. Only use the product as instructed and only for the indicated field of application. Keep these instructions in a safe place. If you pass the product on to anyone else, please ensure that you also pass on all the documentation with it.

Intendeduse

The product is a seat for bicycles. The product is intended for private use only and is not suitable for commercial use or for use in other applications.

• Description of parts

1 Nut
2 Distance piece
3 Block
4 Screw
5 Valve
6 Button

- Technicaldata

Width: HG02361A approx. 17.5 cm HG02361B approx. 21 cm

Safety Notes

PLEASE READ THE INSTRUCTIONS PRIOR TO USE! PLEASE KEEP THE INSTRUCTIONS IN A SAFE PLACE! WHEN PASSING THIS PRODUCT ON TO OTHERS, ALSO INCLUDE ALL DOCUMENTS.

Simple line drawing of a person standing with arms raised (no text or symbols)

WARNING! DANGER TO LIFE AND RISK OF AC-CIDENTS FOR INFANTS

ANDCHILDREN! Never leave children unsupervised with the packaging material. The packaging material poses a suffocation hazard. Keep this product out of the reach of children. This product is not a toy.

CAUTION! RISK OF INJURY!

■ Assemble the product correctly and ensure that it cannot slip when riding. Do not adjust the product while riding.
■ Quick releases must lie on the dropouts in a closed state. Adjust the quick release so that you feel some resistance when it is in a 90° position and pull it tight. If necessary, consult your specialist dealer.
- Check the product before each use for damage and wear-and-tear. Check that all screws are tight before each use and

if necessary, tighten screw connections again. Only use the product if it is in flawless condition! Never use a damaged product.

If using a child seat, ensure that all spring washers under the saddle are covered in order to prevent the pinching of fingers.
■ Every type of tear or scratch in the areas of the saddle subject to high stress (screw connections) is an indication that the life-span of that part has expired and the part must be replaced.

AVOIDANCE OF MATERIAL DAMAGE!

■ Ensure that the product does not come in contact with sharp objects.
■ Protect the product from extreme weather influences such as cold, wetness and direct exposure to the sun.

Assembly

Note: Remove all packaging materials from the product.

□ Always adjust the saddle to the appropriate height for you. Observe the marking on the seat post, which marks the minimum insertion depth.

The products nuts must be tightened with 24 Newton metres on both sides in order to be securely fastened to the plug seat post.

Adjust the product horizontally (Fig. A).

For plug seat posts: Fasten the saddle with the pre-mounted block 3 to the plug seat post (Fig. B).

Remove the nuts on both sides with 14' open-end wrench. Remove the distance piece 2, the screw 4, as well as the block 3 (Fig. C).

☐ Subsequently, mount the saddle directly to the patent saddle post.

Inflating

□ Push the inflation button until you have achieved the desired degree of hardness (Fig. D).

Standard values:

Soft - pump 3 x

Medium - pump 8 x

Hard - pump 15 x

Note: Please note, the product will

deflate over time. In this event, inflate the

product per the instructions.

• Deflating

Press the air valve (Fig. D).

Care, storage

□ Always store the product dry and clean, in a temperate room.
Only clean the product with a damp cloth and wipe dry.

- Disposal

Abstract black-and-white circular logo with curved arrows (no text or symbols)

The packaging is made entirely of recyclable materials, which you may dispose of at local recycling

facilities.

Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.

Warranty

The product has been manufactured to strict quality guidelines and meticulously examined before delivery. In the event of product defects you have legal rights against the retailer of this product. Your legal rights are not limited in any way by our warranty detailed below.

The warranty for this product is 3 years from the date of purchase. Should this product show any fault in materials or manufacture within 3 years from the date of purchase, we will repair or replace it – at our choice – free of charge to you.

The warranty period begins on the date of purchase. Please keep the original sales receipt in a safe location. This document is required as your proof of purchase. This

warranty becomes void if the product has been damaged, or used or maintained improperly.

The warranty applies to defects in material or manufacture. This warranty does not cover product parts subject to normal wear, thus possibly considered consumables (e.g. batteries) or for damage to fragile parts, e.g. switches, rechargeable batteries or glass parts.

Abstract black and white circular logo with curved arrows (no text or symbols)

Simple line drawing of a person standing with arms raised (no text or symbols)

OPOZORILO! SMR- TNA NEVARNOST IN NEVARNOST NESREČ ZA

Abstract black and white circular logo with curved arrows (no text or symbols)

Pooblaščeni serviser:

Warning symbol: black exclamation mark inside a triangle (no text or numbers)

Simple line drawing of a person standing with arms raised (no text or symbols)

VÝSTRAHA! NEBEZ- PEČÍ OHROŽENÍ ŽIVOTA A ZRANĚNÍ MALÝCH I

Abstract black and white circular logo with curved arrows (no text or symbols)

Warning symbol: black exclamation mark inside a triangle (no text or numbers)

Simple line drawing of a person standing with arms raised (no text or symbols)

VAROVANIE!

NEBEZPEČENSTVO OHROZENIA ŽIVOTA A

NEBEZPEČENSTVO ÚRAZU PRE MALÉ I STARŠIE DETI! Nikdy nene- chávajte deti bez dozoru s obalovým materiálom. Hrozí nebezpečenstvo zadu- senia. Výrobok držte v bezpečnej vzdiale- nosti od detí. Výrobok nie je určený na hranie.

POZOR!NEBEZPEČENSTVO PORANENIA!

Abstract black and white circular logo with curved arrows (no text or symbols)

Abstract black and white circular logo with curved arrows (no text or symbols)