SD-50 - Synthesizer ROLAND - Free user manual and instructions

USER MANUAL SD-50 ROLAND

15 Bouton [ ] (STOP)

18 Bouton [▶] (NEXT)

Réglage

Mic/Line Input

MP3/Audio Player

SMF Player

Réglages audio (p. 59)

Réglage

Mic Input SW

Mic Echo Level

Audio Input Att

Direct Mon Sw

Direct Mon Level

TG to COMPUTER

Kit de studio (p. 54)

Timbre solo

Function...		Transmitted	Recognized	Remarks
Basic Channel	Default Changed	X	1-16
		X	1-16
Mode	Default Messages Altered	X	Mode 3	*1
		X	Mode 3, 4 (M=1)
Note Number	True Voice	X	0-127
		**********	0-127
Velocity	Note ON Note OFF	X	O
		X	O
Aftertouch	Key's Channel's	X	O
		X	O
Pitch Bend		X	O
Control Change	0,32	O	O	Bank select Modulation Portamento time Data entry Volume Panpot Expression General purpose controller 1 General purpose controller 2 General purpose controller 3 General purpose controller 4 Hold1 Portamento Sostenuto Soft Legato foot switch Resonance Release time Attack time Cuto Decay time Vibrato rate Vibrato depth Vibrato delay General purpose controller 5 General purpose controller 6 General purpose controller 7 General purpose controller 8 General purpose control General purpose e ects 1 General purpose e ects 3 Increment, Decrement NRPN LSB,MSB RPN LSB,MSB
	5	X	O
	6,38	X	O
	7	X	O
	10	X	O
	11	X	O
	16	X	O (Tone Modify 1)
	17	X	O (Tone Modify 2)
	18	X	O (Tone Modify 3)
	19	X	O (Tone Modify 4)
	64	X	O
	65	X	O
	66	X	O
	67	X	O
	68	X	O
	71	X	O
	72	X	O
	73	X	O
	74	X	O
	75	X	O
	76	X	O
	77	X	O
	78	X	O
	80	X	O (Tone Modify 5)
	81	X	O (Tone Modify 6)
	82	X	O (Tone Modify 7)
	83	X	X
	84	X	O Portamento control
	91	X	O (Reverb)
	93	X	O (Chorus)
	96,97	X	X
	98,99	X	X
	100,101	X	O
	102-119	X	X
Program Change:	True Number	O**********	O 0-127	Program Number 1-128
System Exclusive		O	O
System Common :	Song Postion	X	X
	Song Select	X	X
	Tune	X	X
System Realtime :	Clock Command	X	O X
Aux Messages :	All Sound O Reset All Controllers Local ON/OFF Active Sensing System Reset	X X X X	O O X O (123-127) O X
		X X X X	O X
Notes		*1 Recognized as M=1 even if M1.

SD-50 :

Section Interface audio

Section SMF/Audio Player

Format de fichier

DECLARATION OF CONFORMITY Compliance Information Statement

Model Name: SD-50

Type of Equipment : Sound Module with Audio Interface

Responsible Party: Cakewalk, Inc.

Address: 268 Summer Street Boston, MA 02210

Telephone: [phone]

For EU Countries

This symbol indicates that in EU countries, this product must be collected separately from household waste, as defined in each region. Products bearing this symbol must not be discarded together with household waste.

This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.

IMPORTANT: THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE.

BLUE: NEUTRAL

BROWN: LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

Under no circumstances must either of the above wires be connected to the earth terminal of a three pin plug.

-For EU Countries

This product complies with the requirements of EMC Directive 2004/108/EC.

For the USA

FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit di erent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Unauthorized changes or modi cation to this system can void the users authority to operate this equipment.

This equipment requires shielded interface cables in order to meet FCC class B Limit.

For Canada

NOTICE

This Class B digital apparatus meets all requirements of the Canadian Interference-Caising Equipment Regulations.

AVIS

This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.

Roland