175W - Solar panel ECOFLOW - Free user manual and instructions

USER MANUAL 175W ECOFLOW

Disclaimer and Safety Instructions

QR code with embedded document icon in center, likely linking to a website or digital content

https://www.ecoflow.com/support/download

Disclaimer

Before using this product, please read and fully understand this document and all related documents of this product. After reading this document, please keep it well for future reference. Failure to properly operate this product could cause serious injury to yourself or others, or damage to this product and other property. By using this product, you are deemed to have understood, acknowledged and accepted all terms and contents of this document. The user undertakes to be responsible for his/her actions and all consequences arising therefrom. EcoFlow is not liable for all losses caused by the user's failure to use this product according to the disclaimer and safety instructions.

EcoFlow reserves the right of final interpretation of this document and all related documents of this product where permitted by laws and regulations. These documents are subject to update, revision or termination from time to time without prior notice, please visit EcoFlow website for the latest product information.

⚠ Safety Instructions

Installation

1. This solar system is to be installed by a qualified solar installation company.
2. Do not disassemble the module or nameplate by yourself, otherwise this may void the warranty.
3. Please make sure to use the installation components (including connectors, connecting cables, and brackets) provided by us. Before installation, the solar panel should be completely covered with opaque material and the positive and negative terminals disconnected to prevent power generation.
4. Please carefully check whether the solar panel has broken glass or a damaged back panel. If it does, please stop installing or using it immediately.
5. When installing, do not wear any jewelry made of metal, and only use insulated tools approved for electrical installation.
6. When multiple solar panels are installed in series or parallel, the cross-sectional area of the cable and the capacity of the connector must be appropriate to the maximum short circuit current of the system.
7. Do not install modules near open flames or inflammables and explosives. Do not install solar system in places with water immersion, watering devices, or sprinklers.
8. Do not let children approach the installation site or touch any electrical modules.
9. Do not step on the solar panel or any parts.
10. Do not use a sharp tool to score, cut, slice, or slash the module, especially the back plate.
11. You must comply with local and national regulations during roof and ground installations.
12. When installing on the roof or body of a vehicle, be sure to leave a gap between the solar panel and the roof or body to facilitate airflow and heat dissipation.

Usage

1. The module overcurrent protection rating applies to DC fuses.
2. Do not plug or unplug any system connectors while the circuit is under load.
3. Make sure the fire resistance rating of the system is up to standard, comply with local electrical safety regulations, and configure module accessories (such as fuses, circuit breakers, grounding connectors, etc.) as needed.
4. Please make sure that the installation area of the solar panel system is well ventilated and the connectors are clean and dry.
5. All solar system connections must be sealed to prevent moisture.
6. When installing and using solar system, be sure to follow the safety regulations for all other modules in the system, including connecting wires and cables, connectors, controllers, charging regulators, inverters, accumulators, and other rechargeable batteries.
7. Do not apply any substance that may block light (such as paint, adhesive, etc.) on the light-receiving surface of the solar panel.
8. Do not directly irradiate the surface of the module with artificially amplified sunlight.
9. Do not put heavy objects on the solar panel during use, to avoid damage to the panel.

Technical Specifications

General Information

Model EF-SG-M175-01

Rated Power 175W (±5W)

Open Circuit Voltage 25.5V

Short Circuit Current 8.3A

Maximum Operating Voltage 21.9V

Maximum Operating Current 8.0A

Temperature Coefficient of Rated Power -0.30%/ ℃

Temperature Coefficient of Open Circuit Voltage -0.25%/ ℃

Temperature Coefficient of Short Circuit Current 0.045%/ ℃

Maximum System Voltage 600VDC (UL)

Maximum Fuse Current 15A

Specifications

Net weight Approx. 9.3 kg (20.5 lbs)

Dimensions 1176*762*30 mm (46.3*30*1.2 in)

Testing and Certification

IP68

* Standard Test Conditions: 1000W/m², AM1.5, 25°C (77°F)

Haftungsausschluss