USER MANUAL TRÅDFRI 704.299.13 IKEA
Design and Quality
IKEA of Sweden
English 4 Svenska 28
Deutsch 7 Česky 31
Français 10 Español 34
Nederlands 13 Italiano 37
Dansk 16 Magyar 40
Íslenska 19 Polski 43
Norsk 22 Eesti 46
Suomi 25
Latviešu
Lietuvių 52
Português
Româna
Slovensky 61
Български 64
Hrvatski
49 Ελληνικα 70
Русский 73
55 Українська 76
58 Srpski 79
Slovenščina 82
Türkçe 85
67 88
عربي
FUNCTIONS MOTION SENSOR
Day/Night setting. During the daytime the lights will always turn on when triggered by motion. At night the lights will only turn on when it is dark and they are triggered by motion.
The light sources connected to the motion sensor can be easily set at either 30% or 100% brightness.
Button for pairing. Add IKEA Smart lighting products to your system. Follow the instructions below:
ADDING DEVICES TO YOUR MOTION SENSOR
Before you can use your motion sensor it must be paired to the light source you want to steer. If you want to add more light sources, just repeat the steps below for each individual light source.
- Make sure that your light source is installed and the power is turned on.
- Hold the motion sensor close to the light source you want to add (no more than 5 cm away).
- Press and hold the pairing button for at least 10 seconds. A red LED light will shine steadily on the rear side of the motion sensor.
- Your light source will flash one time to indicate that it has successfully paired.
Up to 10 light sources can be paired with 1 motion sensor.
Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.
FACTORY RESET
Lighting products:
Toggle the main power switch 6 times.
Motion sensor:
Press the pairing button 4 times within 5 seconds.
CHANGE BATTERY:
When unit is used regularly and as intended, the batteries will last for approximately 2 years.
A red LED indicator will shine steadily when it's time to replace the batteries.
Open the battery lid and replace the batteries with CR2032 type batteries.
IMPORTANT!
- The unit can be used in temperatures ranging from 0^ to 40^ .
- Do not leave the unit in direct sunlight or near any
heat source, since this can cause overheating.
- Do not subject the unit to wet or excessively dusty environments since this can cause damage to the unit.
- The range between this unit and the receiver are measured in open air.
- Different building materials and placement of the units can affect the wireless connectivity range.
CARE INSTRUCTIONS
To clean the motion sensor wipe with a soft dry cloth.
NOTE!
Never use abrasive cleaners or chemical solvents since this can damage the product.
TECHNICAL DATA
Type: E1745 TRÅDFRI motion sensor
Input: 3.0V, 2 x CR2032 Battery
Range: 10 m in open air.
Sensor view angle: 60^ - 120^
Sensor range: About 10 m
Operating frequency: 2405-2480Mhz
Output power: 3 dBm
IP-class: IP44
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
FUNKTIONEN DES BEWEGUNGSMELDERS
REPLACEMENT DES PILES
Fabricant : IKEA of Sweden AB
Adresse :
Box 702, 343 81 Älmhult, SUÈDE
Producent: IKEA of Sweden AB
Adresse:
Framleiðandi: IKEA of Sweden AB
Heimilisfang:
Box 702, SE-343 81 Älmhult, SWEDEN
Produsent: IKEA of Sweden AB
Adresse:
Boks 702, SE-343 81 ÄLMHULT
Producent: IKEA of Sweden AB
Adres:
Box 702, SE-343 81 Älmhult
Tootja: IKEA of Sweden AB
Aadress:
Box 702, SE-343 81 Älmhult
© Inter IKEA Systems B.V. 2018 AA-2145280-3
