GP20 - Cooker Duronic - Free user manual and instructions

USER MANUAL GP20 Duronic

Contents3 English Manual4 Important Safeguards When using electrical appliances, basic safety precautions should always be followed, including the following:

2. To protect against electrical shock, do not immerse cord or plugs,

or temperature control probe in water or other liquid.

3. This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

4. Close supervision is necessary when any

appliance is used by or near children.

5. Unplug from outlet when not in use and before cleaning.

Allow to cool before putting on or taking off parts, and before cleaning the appliance.

6. Do not operate any appliance with a damaged cord or plug or after the

appliance malfunctions, or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or adjustment.

7. The use of accessory attachments not recommended

by the appliance manufacturer may cause injuries.

8. Do not use outdoors.

9. Do not let cord hang over the edge of a

table or a counter, or touch hot surfaces.

10. Do not place on or near a hot gas or electric burner, or in a heated oven.

11. Extreme caution must be used when moving

an appliance containing hot oil or other hot liquids.

12. Always attach temperature control probe to appliance rst,

then plug cord in the wall outlet. To disconnect, turn temperature control probe to OFF, then remove the plug from wall outlet.

13. Do not use appliance for other than intended use.

Use with wall receptacle only.5 Additional Important Safeguards

1. All users of this appliance must read and understand this

Instruction Manual before operating or cleaning this appliance.

2. The cord to this appliance should be plugged

into a 220-240 V AC electrical outlet only.

3. If this appliance begins to malfunction during use,

immediately unplug the cord. Then remove the temperature control probe. Do not use or attempt to repair the malfunctioning appliance.

4. Do not leave this appliance unattended during use.

5. If the electrical circuit is overloaded with other appliances, your appliance

may not operate properly. It should be operated on a separate electrical circuit from other appliances. This appliance generates heat and escaping steam during use. Proper precautions must be taken to prevent the risk of burns, res or other injury to persons or damage to property. This appliance is hot during operation and retains heat for some time after turning OFF. Always use oven mitts when handling hot materials and allow metal parts to cool before cleaning. Do not place anything on top of the appliance while it is operating.6 Temperature Control Probe

1. The temperature control probe is the nerve center and brain of the

electric Griddle. Treat it carefully. Dropping or banging it could change its calibration and make the temperature settings inaccurate.

2. Rotate the dial to select the temperature as called for in the recipe.

3. The indicator light on the temperature control probe

will illuminate as soon as the dial is rotated. The light will go out once the selected temperature has been reached.

4. Allow the Griddle to cool before removing the temperature control probe.

5. To clean the temperature control probe, simply wipe down with a soft,

damp cloth. Make sure you dry it thoroughly before using again. Plasticize Warning User Maintenence Instructions Specications To prevent Plasticize from migrating to the nish of the counter top or table top or other furniture, place NON-PLASTIC coasters or place mats between the appliance and the nish of the counter top or table top. Failure to do so may cause the nish to darken; permanent blemishes may occur or stains can appear. This appliance requires little maintenance. It contains no user serviceable parts. Do not try to repair it yourself. Any servicing requiring disassembly other than cleaning must be performed by a qualied appliance repair technician. Operating Voltage : 220-240V~ 50/60Hz Power: 2000W7 Before using for the rst time:

1. Carefully unpack the Griddle and remove all packaging materials.

2. Place the non-stick Griddle on a clean, at working surface.

NOTE: Some countertop and table surfaces, such as Corian® and other surfaces, are not designed to withstand the prolonged heat generated by this Griddle. We recommend placing a hot pad or trivet under the Griddle beforehand to avoid possible damage to the surface. Be sure the sides and back of the Griddle are at least 4 inches away from any walls, cabi- nets, or objects on the counter or table.

3. Before rst use, see Hints For Care and Use of Non-Stick Surface and

Care & Cleaning Instructions sections of this Instruction Manual.

4. Before cooking in the Griddle for the rst time, wash the non-stick

Griddle in mild dishwashing soap, wipe and allow to dry. NOTE: The Griddle (without the temperature control probe) is dishwasher safe.

5. Insert drip tray into rails under the Griddle’s side,

positioned directly under the grease drain.

6. Turn the temperature control knob on probe

to OFF position and attach securely in place.

7. Coat the non-stick surface with vegetable shortening before heating.

If necessary, remove excess oil with a paper towel. The temperature control probe is not submersible. Use the temperature control probe supplied with this Griddle only. The use of any other temperature control probe may cause re, electric shock, or injury.8 Hints For Care and Use of Non-Stick Surface Operating Instructions

1. To avoid scratching the non-stick surface,

do not stack objects on the Griddle.

2. Use medium to low heat for best cooking results.

Very high temperatures can cause discoloration and shorten the life span of any non-stick surface. If higher temperatures are necessary, preheat on medium heat for a few minutes.

3. Use only nylon, plastic, or wooden utensils with care to avoid

scratching the non-stick surface. Never cut food on the Griddle.

4. Remove stubborn stains with a plastic scouring pad and mild dish washing

liquid; DO NOT USE STEEL WOOL.

1. Turn temperature control probe to the OFF position.

2. Plug the temperature control probe

securely into Griddle’s control probe socket.

INTO GRIDDLE FIRST, THEN INTO WALL OUTLET.

4. Preheat Griddle for approximately 5 minutes before cooking. To preheat,

turn the temperature control to desired temperature. The indicator light on the temperature control probe will illuminate as soon as the dial is rotated. The light will go out once the selected temperature has been reached. NOTE: During cooking, the light will go on and off indicating that the Griddle is maintaining proper temperature. CAUTION: Griddle surfaces are hot during use.

5. When cooking bacon or foods containing large quantities of grease,

it may be necessary to check the drip tray to make sure it is not full. Remove drip tray; empty contents and wash if needed. See the Time/ Temperature Chart for basic suggested cooking information.

6. When cooking has been completed,

turn the temperature control to the OFF position. The indicator light on the temperature control probe will turn off.

7. Unplug cord from wall outlet. Let the Griddle cool completely.

8. Remove temperature control probe from Griddle.

Follow the Care & Cleaning Instructions described.9 Warranty 1 Year Guarantee from Shine-Mart Ltd, Trademark owners of Duronic Products. NOTE: THESE STATEMENTS DO NOT AFFECT YOUR STATUTORY RIGHTS AS A CONSUMER This product has been manufactured under the strictest or quality control procedures, and using the highest quality of materials, to ensure excellent performance and reliability. It will give very good and long lasting service, provided it is properly used and maintained. The product is guaranteed for 1 years from the date of original purchase. If any defect arises due to a faulty materials or poor workmanship, the faulty product must be returned to the original place of purchase. Refund or replacement is at the discretion of that company. Duronic Products are offered with a 1 year guarantee under the following conditions:

1. The product must be returned to the retailer with original proof of purchase.

2. The product must be installed and used in accordance with the instructions

contained in this operating manual.

3. It must be used only for domestic purposes.

4. It does not cover wear and tear, malicious damage, misuse, neglect,

inexpert repairs or consumable parts.

5. Shine-Mart Ltd has no responsibilities for accidental or consequential loss or damage.

6. Shine-Mart Ltd are not liable to carry out any type of servicing work,

7. Valid in the UK only

This product is tted with CE:1363 plug and fuse Imported by Shine-Mart Ltd, RM3 8SB Information on waste Disposal for Consumers of Electrical & Electronic Equipment. This mark on a product and/or accompanying documents indicates that when it is to be disposed of, it must be treated as Waste Electrical & Electronic Equipment, (WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for the treatment, recovery and recycling of the materials used. For proper treatment, recovery and recycling; please take all WEEE marked waste to your Local Authority Civic waste site, where it will be accepted free of charge. If customers dispose of Waste Electrical & Electronic Equipment correctly, they will be helping to save valuable resources and preventing any potential negative effects upon human health and the environment, of any hazardous materials that the waste may contain.10 Manuel d’utilisation en français11 Avertissements de sécurité Lorsque vous utilisez des produits électriques, des précautions basiques de sécurité doivent toujours être observées :