Libeccio Remote G50046 - Fan G3 Ferrari - Free user manual and instructions

USER MANUAL Libeccio Remote G50046 G3 Ferrari

White outdoor fan with a circular fan and four blades, standing on a stand (no text or symbols visible)

Safety instructions.... p. 7

General information.... p. 9

G50046 p. 9

Assembling.... p. 10

Operating.... p. 10

Oscillation.... p. 10

Sleep and Natural Mode.... p. 10

Timer.... p. 10

Remote Control p. 10

Cleaning.... p. 11

Technical features....p. 11

Waste of electric and electronic equipment (WEEE

Directive).... p. 25

PORTUGUES:....p. 11

FRANCAIS ...... p. 15

DEUTSCH p. 20

CLASSI DI PROTEZIONE / PROTECTION CLASSES

ATTENZIONE RISCHIO DI SCOSSE ELETTRICHE NON ESPORRE A PIOGGIA E UMIDITA'

WARNING ELECTRIC SHOCK RISK DO NOT EXPOSE TO RAIN OR MOISTURE

ATTENZIONE: NON APRITE L'APPARECCHIO. ALL'INTERNO NON VI SONO COMANDI MANIPOLABILI DALL'UTENTE NE' PARTI DI RICAMBIO. PER TUTTE LE OPERAZIONI DI SERVIZIO RIVOLGERSI AD UN CENTRO DI ASSISTENZA AUTORIZZATO.

This symbol warns the user that un-insulated dangerous voltage inside the system may cause an electrical shock. Do not open the case.

Class II Appliance symbol. The double insulated electrical appliance is one which has been designed in such a way that it does not require a safety connection to electrical earth/ground.

Caution: this symbol reminds the user to read carefully the important operations and maintenance instructions in this owner's guide.

AVVERTENZE DI SICUREZZA

ENGLISH: SAFETY INSTRUCTIONS

The following are important notes on the installation, use and maintenance; save this instruction manual for future reference; use the equipment only as specified in this guide; any other use is considered improper and dangerous; therefore, the manufacturer cannot be held responsible in the event of damages caused by improper, incorrect or unreasonable use.

Before use, ensure the equipment is undamaged; if in doubt, do not attempt to use it and contact the authorized service center; do not leave packing materials (i.e. plastic bags, polystyrene foam, nails, staples, etc.) within the reach of children as they are potential sources of danger; always remember that they must be separately collected. Make sure that the rating information given on the technical label are compatible with those of the electricity grid; the installation must be performed according to the manufacturer's instructions considering the maximum power of the appliance as shown on the label; an incorrect

installation may cause damage to people, animals or things, for which the manufacturer cannot be considered responsible thereof.

If it is necessary to use adapters, multiple sockets or electrical extensions, use only those that comply with current safety standards; in any case do not exceed the power consumption limits indicated on the electrical adapter and / or extensions, as well as the maximum power shown on multiple adaptor.

Do not leave the unit plugged; better to remove the plug from the mains when the device is not in use. Always disconnect from power supply if you leave it unattended.

Cleaning operations should be carried out after unplugging the unit.

If the unit is out of order and you do not want to fix it, it must be made inoperable by cutting power cord.

- Do not allow the power cord to get closer to sharp objects or in contact with hot surfaces; do not pull it to disconnect the plug.

- Do not use the appliance in the event of damage to the power cord, plug, or in case of short circuits; to repair the product only address an authorized service center.

- Do not handle or touch the appliance with wet hands or bare feet. Do not expose the appliance to harmful weather conditions such as rain, moisture, frost, etc.. Always store it in a dry place.

-Children must not play with appliance. Keep appliance and its cord out of reach of children less than 8 years.

- This appliance can be used by children of 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they received supervision or instruction concerning use of the appliance in a safe way and understand hazards involved; children shall not play with the

appliance; cleaning and user maintenance shall not be made by children without supervision.

If the power cord is damaged, or in case of failure and / or malfunction do not tamper with the unit. The reparation must be done by manufacturer or by service center authorized by the manufacturer in order to prevent any risk. Failure to comply with the above may compromise the unit safety and invalidate the warranty.

• This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; by clients in hotels, motels and other residential type environments; farm houses, bed and breakfast type environments.
• The appliance is not intended to be operated by means of an external timer or separate remote-control system.
• Before every use, unroll the power cord.
• Use original spare parts and accessories only.
• Do not subject the product to strong impacts, serious damages may result.

GENERAL INFORMATION

Do not connect the electric plug since the installation is not complete. Do not leave the appliance unattended while it is running. Unplug after each use.

Unplug unit by pulling the plug and not the power cord.

Do not immerse product in water or other liquids and avoid splashing liquids reach the unit.

Place on solid and stable surfaces and away from windows or drafts. Before carrying out any cleaning, disconnect the unit from the electrical outlet.

Before each use, unroll the power cord. Do not insert anything through the protection grids.

Do not obstruct in any way the protection grids.

DESCRIPTION G50046

1 Front protection grid

4 Motor protection

2 Fan

5 Remote control

3 Rear protection grid

6 Motor body

7 Motor unit fixing knob	8 Upper tube	9 Adjusting height knob
10 Fixing ring 11 Lower tube	12 Screw for the base
13 Drive shaft 14 Control panel	15 Rear grid stopper
16 Fan stopper 17 Front grid fixing screw	18 Base
19 Button OSC	20 Button MODE	21 Button TIMER
22 Button SPEED	23 Button ON/OFF	24 Light oscillation
25 Light Mode	26 Lights Timer	27 Lights speed

ASSEMBLING

The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the maximum safety, perform the installation completely before operating.

1) Place the lower tube (11) at the center of the base (18). Turn the base upside down and place the ring (10), then insert the screw (12) in the ring and screw to link the tube and the base.
2) Unscrew the height adjustment knob (9), take out the upper tube (8) from lower tube (11) to the desired length and secure by tightening the knob (9). Insert the motor unit into the upper tube (8) and tighten the locking knob of the motor housing (7) to lock both sides.
3) Place the rear grid (3) near the plastic of motor (4) with metal handle facing upwards. Fit the holes placed in the central part of grid with the pins in plastic protection (4) and secure the parts with the stopper (15).
4) Insert the fan (2) in the drive shaft (13) and thread the stopper (16) to the threaded end of the crankshaft.
5) Remove the fixing screw (17). Place the front grid (1) in front of rear grid (3) matching holes on the grids.
6) Close the locking pins and fasten the two grids tightening the securing screw (17) previously removed. The fan is now correctly assembled.

OPERATING

Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical outlet. The control panel (14) and the remote control (5) operate the various functions of the fan.

Press button ON/OFF (23). The fan switches on.

Press the button SPEED (22) to adjust the wind power different speeds.

L: low speed M: medium speed H: high speed

OSCILLATION The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the button OSC (19). Push again to disable the oscillation.

TIMER The fan is equipped with a 7.5 hours timer. Press button TIMER (21) if you want the appliance to turn off after a certain period of time (between 30 minutes and 7.5 hours). Press once to set it off after 30 minutes, twice to set 1 hour, 3 times for 2 hours, and so on up to 7.5 hours. The sum of the times associated to the switched on lights (26) indicate the time set for the timer.

NATURAL AND SLEEP MODE

Pressing one time the button MODE (20) the fan enters in NATURAL mode and the light (25) switches on. In this mode the fan reproduces the natural breath of the wind, according to some preset cycles.

Pressing again the button MODE (20) the fan enters in SLEEP mode and the light (25) switches off. This function is ideal during the night, for better comfort during sleep. The ventilation cycles are preset

REMOTE CONTROL

Open the cover on the back of the remote control and insert 1 battery 3V type CR2032 oe CR2025 following the correct polarity (+/-). Close the battery cover before using the remote control.

• Remove the batteries if you will not use the remote for an extended period of time.
• Whatever the type of exhausted battery, it must not be thrown in the household waste, in the fire or in the water. Exhausted battery must be recycled or disposed of in the appropriate dedicated collection centers.

CLEANING

Disconnect the plug from the electrical outlet before attempting any cleaning operation.

Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor body. Do not clean the unit with metallic sponges or abrasive cleaners, only use neutral detergents and a soft cloth moistened with water to clean the outer parts. Dry the product completely before operating the unit.

TECHNICAL FEATURES

• Power supply: AC 230V\~50-60Hz. Power 45W
• Fan diameter: 40cm – 3 operation speeds – Oscillation
- Timer – Functions Sleep e Natural – Remote control

PORTUGUES: ADVERTÊNCIAS

The product is made of non-biodegradable and potentially polluting substances if not properly disposed of; other parts can be recycled. It’s our duty to contribute to the ecological health of the environment following the correct procedures for disposal. The crossed out wheelie bin symbol indicates the product complies with the requirements of the new directives introduced to protect the environment (2002/96/EC, 2003/108/EC, 2002/95/EC, 2012/19/EC) and must be properly disposed at the end of its lifetime. If you need further information, ask for the dedicated waste disposal areas at your place of residence. Who does not dispose of the product as specified in this section shall be liable according to the law.

To find the nearest service center, please call the telephone number 0541 694246, fax number 0541 756430 or contact us at [e-mail] asking for the service centers supervisor.

Appliance is conform to the pertinent European regulation and is therefore marked with the CE mark.

www.g3ferrari.it TREVIDEA S.r.l.

TREVIDEA S.R.L. – Strada Consolare Rimini – San Marino n. 62 – 47924 – RIMINI (RN) - ITALY

MADE IN CHINA