Pingi Vida 2 - Dehumidifier

Vida 2 - Dehumidifier Pingi - Free user manual and instructions

Find the device manual for free Vida 2 Pingi in PDF.

English EN ⬇ Download 💬 AI Question ❓ 10 questions ⚙️ Specs
📄

Document temporarily unavailable

The manual is currently being transferred to our new server. It will be accessible again in a few hours. Thank you for your patience.

Pick your language and provide your email: we'll send you a specifically translated version.
Product Type Thermoelectric Dehumidifier
Model Vida 2 (CXTV-N1000EU)
Brand Pingi
Power Supply AC-DC Adapter 9V, 2A (100-240V, 50/60Hz)
Energy Consumption 18 W
Tank Capacity Approximately 1000 ml
Dehumidification Capacity Up to 250 ml per day
Operating Modes Normal, Turbo, Night
Auto Shut-off Yes, when tank is full
Continuous Drainage Yes, via drainage hose (diameter 10 mm)
Wall Mount Yes, wall mount included (VSB-1S)
Noise Level Not specified
Dimensions Not specified
Weight Not specified
Warranty 2 years (limited)
Frost Protection Yes, can operate at temperatures > 0°C
Cleaning Wipe the exterior with a damp cloth

Frequently Asked Questions - Vida 2 Pingi

The device does not turn on, what to do?
Check that the AC-DC adapter is properly plugged in and that the mains socket works. Ensure the tank is correctly inserted and that the ON/OFF switch at the back of the device is in the ON position.
I emptied the tank but the light remains red, why?
There may still be water in the float compartment. Remove the tank and completely empty the small white cylinder near the drainage cap. Also check that the float is not stuck.
My dehumidifier collects less than 250 ml per day, is this normal?
Yes, this is normal. Efficiency depends on ambient temperature and humidity. In cooler weather, the air contains less water, so collection is slower.
Can I use the device in an unheated room in winter?
Yes, thanks to frost protection, the device operates at temperatures above 0°C. However, its efficiency decreases in very cold weather because the air contains less humidity.
How to empty the tank?
Turn off the device, remove the tank by the handle, then remove the small cap marked 'DRAIN TANK' on top. Empty the water and replace the tank.
How to use continuous drainage?
Attach a 10 mm diameter drainage hose to the tank (instead of the plug). Place the other end in a bucket or sink. Note: the auto shut-off is deactivated in continuous drainage mode, monitor the container.
What are the different modes?
Press the main button once for Normal mode (blue flashing), twice for Turbo mode (steady blue, maximum speed), three times for Night mode (reduced speed, lights off).
How to dim the tank light?
Use the sliding button on the front, above the tank. Move it to the right to decrease light intensity (day/night mode).
Where to install the device?
Place it on a dry, flat surface in an upright position. Ensure good air circulation and do not block the vents. You can also mount it on the wall using the included wall mount.
How to clean the device?
Unplug the device before cleaning. Wipe the exterior with a damp cloth. Never immerse the device or adapter in water.

User questions about Vida 2 Pingi

0 question about this device. Answer the ones you know or ask your own.

Ask a new question about this device

The email remains private: it is only used to notify you if someone responds to your question.

No questions yet. Be the first to ask one.

Download the instructions for your Dehumidifier in PDF format for free! Find your manual Vida 2 - Pingi and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Vida 2 by Pingi.

USER MANUAL Vida 2 Pingi

Manual assistant
Powered by Anthropic
Waiting for your message
Product information

Brand : Pingi

Model : Vida 2

Category : Dehumidifier