ME80 - Coffee machine Mestic - Free user manual and instructions

USER MANUAL ME80 Mestic

3. Capsule compartment

5. Used capsule compartment

6. Espresso coffee cup tray

Your coffee maker Please study these operating instructions before using the coffee maker. By following them carefully, and by paying special attention to the safety instructions, you will ensure that this coffee maker will go on making perfect coffee for years to come.

1. Read all instructions.

2. Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the coffee maker.

3. Do not put the appliance, the power cable or the plug in water or any other liquid.

4. Unplug from outlet when not in use and before cleaning.

5. Do not operate any appliance with a damaged cord or plug, or in abnormal state. If the main cord is

damaged, it must be replaced by the manufacturer, the nearest service agent or a similarly qualied person.

6. The use of accessory is not recommended by the appliance manufacturer. It may result inre, electric shock

and/or personal injury.

7. Do not let cord hang over edge of table or counter, or touch hot surface.

8. To disconnect, remove plug from wall outlet. Always hold the plug; never pull the cord.

9. Do not use the appliance for other than its intended use and place it in a dry environment.

10. Do not leave the coffee maker unattended while it is operating; the appliance must not be operated by

11. Be careful not to get burned by the steam.

12. Do not touch the hot surface. Use handles or knobs only.

13. Never use your coffee maker without water in it.

14. Make the appliance stand on a table or a at surface.

15. Do not use outdoors.

16. Save these instructions.

17. This appliance is not intend for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance by a person responsible for their safety.

18. Children should be supervised to ensure that they do not play with the appliance.

ENGLISHUsing your coffee machine for the rst time. Conrm whether any accessories are missing and the appliance is not damaged. Then clean the inner parts, then install and operate the machine as per following steps.

1. Rinse the water tank then lling with water.

2. Install the water tank, drip tray and capsule container in proper position on the machine.

3. Turn the machine ON by connecting the plug into mains, both coffee buttons blink for three times.

4. Press any coffee button to start heating up.

5. When buttons stop blinking and shows steady light, The machine is ready for use.

6. Press and hold the two coffee buttons simultaneoulsy to turn OFF the machine.

Using Coffee machine: Before making any coffee, make sure to rinse your machine by

• Placing a container under coffee extraction nozzle.

• Closing the operating lever and pressing the Lungo button to rinse the machine.

• Repeat this three times. ENGLISHMaking coffee Open the water reservoir lid and ll the water tank with the desired amount of water. You repeat the previous steps from step 3 to 5.

1. Turn the machine ON by connecting the plug into mains, both coffee buttons blink for three times .

2. Press any coffee button to start heating up.

3. When buttons stop blinking and shows steady light, The machine is ready for use.

5. Open the operating lever, insert a capsule and then closed.

6. Press one of the two coffee buttons ( desired amount) while the light is blinking. The machine will start

making your cup of coffee

7. Open the operating lever after extraction stopped. The capsule will be automaticly ejected and drop into the

used capsule container.

• The pre-dened factory volume for Espresso coffee (20-25ml) / Lungo coffee (40-50ml)

• Extraction will stop automatically or press the selected coffee button to stop ahead Energy saving mode

• Automatic Stand-by mode: the machine will turn into stand-by mode automatically after 5 minutes of non use. The boiler turned off and the external surface of the machine cools down. All button indicator lights on the control panel go out.

• When user press any coffee button again, the appliance leaves from standby mode, restart heating up process until “Ready to use”. Warning If both coffee buttons ash alternately (see illustration). Turn the device off, wait 2 minutes, and then turn it on again to check if the problem is resolved. Otherwise, contact the authorized representative for examination, repair or adjustment. ENGLISH only compatible with: aluminum cupsPersonal settings The control panel can also be used to personalize the different extracted coffee capacity. The predened factory volume for the small cup is (20-25 ml) / and for the large cup is (40-50 ml).

• Check whether there is drinking water in the water tank, check that the machine is ON. Wait until the buttons on the control panel are “Ready for use”.

• Then press and hold any coffee button for 3 seconds until the coffee comes out, then release the button (see gure). Once the coffee has reached the desired capacity, press the selected coffee button again and the operation is complete.

• The machine remembers the current personal setting and saves the same coffee quantity for the next time unless new programming is dened. Reset to factory settings

• Make sure the machine is switched off without mains power.

• Press both coffee buttons together for at least 3 seconds and connect the machine to the mains at the same time. Cleaning and maintenance

• Remove the plug from the socket

• Never immerse the appliance in water.

• Only clean the device with a dry cloth.

• Empty the drip tray and used capsule container after each use.

• Clean the coffee nozzle and the inside of the machine regularly with a damp cloth.

• Do not use a strong or abrasive solvent, sponge or cream cleaner. Do not put in the dishwasher.

• For your coffee machine to work efciently, you must regularly clean the scale deposits produced by the water. We recommend that you use the appliance every three months or after approx. 200 capsules. Recycling This product bears the selective sorting symbol for waste electrical and electronic equipment This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human heath due to the presence of hazardous substances. Declaration of conformity Hereby Gimeg Nederland B.V. declares that the device ME-80, applies all basic requirements and other relevant regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive (2014/35/EU). If you require a full declaration of conformity, you can contact the adress listed on the backside of this manual ENGLISHWichtige sicherheitsangaben: Bei der Benutzung von Elektrogeräten sollten grundlegende Vorsichtsmassregeln stets eingehalten werden, um das Risiko von Brand, Elektroschockes und/oder Verletzungen zu verringern. Teile