VTTEST15 - Electric meter HQ Power - Free user manual and instructions

USER MANUAL VTTEST15 HQ Power

To all residents of the European Union Important environmental information about this product This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized company for recycling. This device should be returned to your distributor or to a local recycling service. Respect the local environmental rules. If in doubt, contact your local waste disposal authorities. Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, do not install or use it and contact your dealer.

Read and understand this manual and all safety signs before using this appliance.

This device can be used by children aged from 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and user maintenance shall not be made by children without supervision.

3. General Guidelines

Refer to the Velleman

Service and Quality Warranty on the last pages of this manual.

Warning: Do not puncture batteries or throw them in fire

as they may explode. Do not attempt to recharge non- rechargeable batteries (alkaline). Dispose of batteries in accordance with local regulations. Keep batteries away from children.VTTEST15

Turn the rotary switch fully clockwise to test the strength of a battery. The battery LED will light bright green if the internal battery is fully charged. Plug one end of the cable into the appropriate jack on the left side of your VTTEST15. Plug the other end of the cable into the appropriate jack on the right. Now, set the rotary switch to “1” to test the connection of contact “1” on the plug inserted into the left. If there is a connection, the green LED will light below “1” while a yellow LED will light above the contact of the plug connected to the right. If no LED lights, there is no connection: the left connection will either be floating or open. Set the rotary switch to “2” to test contact “2” etc. until all contacts have been checked. If the GROUND LED lights, there is a connection between the corresponding contacts and the chassis. To test a cable with banana plugs, just plug each end of the cable into the banana jacks. The LED will light and the unit will beep if there is a connection between the plugs. These jacks can also be used for continuity tests using two probe leads. Jack Speakon

¼” TS Mono to ¼” Mono ¼” TRS to ¼” TRS 1 Sleeve 1 Sleeve, 3 Ring 1 Sleeve 1 Sleeve, 3 Ring 2 Tip 2 Tip 2 Tip 2 Tip 3 Ring 1 Sleeve, 3 Ring (shorted with sleeve) 3 Ring 1 Sleeve, 3 Ring XLR Balanced to XLR Balanced XLR Unbalanced to XLR Unbalanced Pin 1 Pin 1 Pin 1 Pin 1, Pin 3 Pin 2 Pin 2 Pin 2 Pin 2 Pin 3 Pin 3 Pin 3 Pin 1, Pin 3 ¼” TS Mono to XLR Unbalanced ¼” TRS to XLR Balanced 1 Sleeve Pin 1, Pin 3 1 Sleeve Pin 1 2 Tip Pin 2 2 Tip Pin 2 3 Ring Pin 1, Pin 3 (shorted with sleeve) 3 Ring Pin 3VTTEST15

V. 02 – 23/04/2018 4 ©Velleman nv

6. Technical Specifications

power supply............... 1 x 9 V E-block (order code 6LR61, incl.) dimensions .............................................. 120 x 210 x 70 mm total weight ................................................................. 900 g Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device. For more info concerning this product and the latest version of this manual, please visit our website www.velleman.eu. The information in this manual is subject to change without prior notice. © COPYRIGHT NOTICE The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the prior written consent of the copyright holder.VTTEST15

A Velleman NV detém os direitos de autor deste manual do utilizador. Todos os direitos mundiais reservados. É estritamente proibido reproduzir, traduzir, copiar, editar e gravar este manual do utilizador ou partes deste sem prévia autorização escrita por parte da detentora dos direitos.Velleman® Service and Quality Warranty Since its foundation in 1972, Velleman® acquired extensive experience in the electronics world and currently distributes its products in over 85 countries. All our products fulfil strict quality requirements and legal stipulations in the EU. In order to ensure the quality, our products regularly go through an extra quality check, both by an internal quality department and by specialized external organisations. If, all precautionary measures notwithstanding, problems should occur, please make appeal to our warranty (see guarantee conditions). General Warranty Conditions Concerning Consumer Products (for EU):

• All consumer products are subject to a 24-month warranty on production flaws and defective material as from the original date of purchase.

• Velleman® can decide to replace an article with an equivalent article, or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses are out of proportion. You will be delivered a replacing article or a refund at the value of 100% of the purchase price in case of a flaw occurred in the first year after the date of purchase and delivery, or a replacing article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery.

• Not covered by warranty: - all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity...), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits; - consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, non-rechargeable, built-in or replaceable), lamps, rubber parts, drive belts... (unlimited list); - flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…; - flaws caused deliberately, negligently or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions; - damage caused by a commercial, professional or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally); - damage resulting from an inappropriate packing and shipping of the article; - all damage caused by modification, repair or alteration performed by a third party without written permission by Velleman®.

• Articles to be repaired must be delivered to your Velleman® dealer, solidly packed (preferably in the original packaging), and be completed with the original receipt of purchase and a clear flaw description.

• Hint: In order to save on cost and time, please reread the manual and check if the flaw is caused by obvious causes prior to presenting the article for repair. Note that returning a non- defective article can also involve handling costs.

• Repairs occurring after warranty expiration are subject to shipping costs.

• The above conditions are without prejudice to all commercial warranties. The above enumeration is subject to modification according to the article (see article’s manual).