4721 - Kettle Cloer - Free user manual and instructions

USER MANUAL 4721 Cloer

• The appliance is intended to be used in household only and similar environments like: – staff kitchen areas in shops, offices and other working environments, – in farm houses, – by clients in hotels, motels and other residential type environments – on bed and breakfast type environments.

• Repairs of Cloer electronics appliances should be carried out only by the Cloer customer service. Improper repairs can involve substantial dangers for the user. Moreover, this will void your warranty claims.

• Operate the appliance only at household-usual power sockets. Check if the mains voltage stated on the type plate is up to that of your power supply network.

• The appliance should be connected to a protective grounding conductor.

• If the supply cord is damaged, it must be replaced by Cloer in order to avoid damage.

• Pull power plug of the power socket – in case of a defect – if the appliance is not used for a longer time – before any cleaning.

• Only pull at the plug, never at the feed cable.

• Do not stretch the feed cable over sharp edges and do not tighten it too tight, do not use the feed cable for carrying and protect it from heat (hotplate, for example).

• This appliance can be used by children aged from 8 years and above and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

• Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children less than 8 years to avoid they play with it.

• Do not use the appliance outdoors.

• Use the electric kettle only with the provided base station.

• More information about proper cleaning on the following pages.

• Do not immerse appliance or base in water and do not clean under running water.

• Use the product only to cook water. An improper use of the appliance may lead to serious injuries.

• Do not use the kettle without the lime filter and only with the closed lid. Otherwise, the kettle will not turn off automatically once the water boils.

• Do not fill the appliance over the MAX mark since there is risk of burns if the water spills over.

• Avoid water spills on the base station. If this occurs, proceed as follows: – Pull the power plug of the power socket. – Dry the base station with a dry absorbent paper towel. – Dry the Surface where the appliance is. – Connect the power plug again.

• Please do not open the lid during the boiling process or immediately after it.

• ATTENTION: The kettle will become extremely hot during the process only grasp the handle of the kettle. EN7

Before the first use Read these operating instructions carefully before using the appliance for the first time.

• Remove all packing parts and possibly stickers, but not the type plate nor the serial number.

• Remove all packaging elements and labels, but not the rating plate.

• Do not fill the electric kettle with water past the MAX marking (470X/471X= 1,5 l, 472X = 1,0 l). Scalding may result from water boiling over.

• Always remove the electric kettle from the contact base before filling with water.

• This electric kettle may only be used for heating water.

• Use the electric kettle only with the provided contact base.

• Before operating the machine, make sure that the contact base is dry.

• Please make sure that water is never spilled on the contact base.

• If water is accidentally spilled onto the contact base, proceed as follows: – Unplug the unit from the wall socket. – Dry the contact base with an absorbent dry kitchen towel. – Dry the surface beneath the contact base. – Plug the unit into the wall socket again.

• Never operate the electric kettle without the lid closed and without lime filter, since then the device will not shut off automatically when the water boils. ATTENTION! Always unplug appliance when not in use and before cleaning! CAUTION! The surface is hot during operation. Only touch the device at its handle. Operation

• Plug the power plug into the wall socket.

• Remove the electric kettle from the contact base. Open the lid of the removable kettle by pressing the button to open the lid.

• NOTE: For your safety, the lid is equipped with a lo

cking device. If the electric kettle is accidentally over- turned during use, the lid will not open. This reduces the risk of being scalded by spilled water.

• Fill the electric kettle with water.

• Close the lid manually.

king on the inside of the pot or on the water level indicator.

• Place the electric kettle anywhere on the contact base. The unit is now ready for operation.

tom of the handle. The switch locks into place and the control lamp lights up.

• When the water boils, the electric kettle automatical

ly switches off and the control lamp goes out.

• You can interrupt the boiling process at any time by pushing up the ON/OFF switch.

• IMPORTANT: Always make sure that the device is switched off before removing the electric kettle from the contact base. CAUTION! Please do not to open the lid immediately after boiling or when water is still hot. When opening the lid scalding may result from splashing water. Overheating protection device The electric kettle is equipped with a double-action overheating protection device. In the event that you accidentally operate the electric kettle without water or if the water level is too low, causing the water to evaporate during boiling, the device will automati

cally switch off for your safety. The device will be rea- dy to operate once it has been filled with cold water. Cleaning

• CAUTION: The appliance must not be immersed in water!

• Do not clean the electric kettle with heavily abrasive cleaners. They could scratch the appliance.

• Clean very dirty appliances either with lukewarm wa

ter or with a stainless steel cleaner.

• If a stainless steel cleaner is used, make sure that it is not aggressive and does not contain chlorine or acids. Care

• Use a special stainless steel care product for minor cleaning (water stains, light fingerprints, etc.).8

• CAUTION: Use only for the exterior! Do not use on surfaces that come into contact with food (inside). Decalcifying If you have hard water, the electric kettle should be decalcified regularly (depending on the hardness of the water, about every 2 - 3 weeks). Use a commerci

ally available liquid decalcifying product (do not use chemical decalcifiers) and follow the manufacturer’s instructions. Tip: Mild calcium deposits can also be removed with a mixture of 5 to 6 tablespoons of vinegar in 0.5 l of water.

• Please observe the following when decalci-fying the machine:

• First, pour cold water into the electric kettle (if the decalcifier foams excessively, use only 0.5 l of water).

• Briefly bring it to a boil.

• Now, add the decalcifier and let the device stand for a while.

• CAUTION: Do not bring this mixture to a boil. After decalcifying, rinse the pot twice with clear water.

• Do not clean the electric kettle with heavily abrasive cleaners. They could scratch the appliance.

• Note: Regularly decalcifying your electric kett

le will reduce the electricity used and prolong the life of the appliance. The calcium content of water varies from region to region. Please con

sult your local water works or utility works for information on water hardness.

• In the event of malfunctions due to calcium de

posits, the guarantee will be voided! Environmentally friendly disposal We use environmentally friendly packaging for the transport of our appliances. Please recycle cardbo

ard/ paper and plastic packaging appropriately. ATTENTION! Electrical appliances should not be disposed of with the household trash. Electrical appliances contain valuable raw materials. When an appliance is worn-out, please take it to a recognised recycling facility. Consult the local autho

rities for information on recycling appliances. Warranty Cloer electrical appliances are in conformity with the currently required EC-guidelines and safety regulations. If your Cloer electrical appliance has a defect or it does not work properly, contact your specialist dealer. Registered clients have at their disposal our technical customer service. Manufacturer warranty Please register your appliances in the period of 6 months since the purchase in order to benefit from our manufacturer warranty. The published conditi

ons of warranty in the moment of the registration are valid. You will find conditions of warranty and pro

duct registration here: Manufacturer warranty https://cloer.eu/guarantee9