MC126284 - Mechanical chipper Emerio - Free user manual and instructions

USER MANUAL MC126284 Emerio

1. Warning: Potential risk of injuries from misuse.

2. Always disconnect the appliance from the supply if it

is left unattended and before assembling, disassembling or cleaning.

3. This appliance shall not be used by children. Keep

the appliance and its cord out of reach of children.

4. Appliances can be used by persons with reduced

physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.

5. Children shall not play with the appliance.

6. If the supply cord is damaged, it must be replaced by

the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

7. Switch off the appliance and disconnect from supply

before changing accessories or approaching parts that move in use.- 3 -

8. Care shall be taken when handling the sharp cutting

blades, emptying the bowl and during cleaning.

9. Before inserting the plug into the mains socket,

please check that the voltage and frequency comply with the specifications on the rating label.

10. Disconnect the mains plug from the socket when the

appliance is not in use and before cleaning.

11. Ensure that the mains cable is not hung over sharp

edges and keep it away from hot objects and open flames.

12. Do not immerse the appliance or the mains plug in

water or other liquids. There is danger to life due to electric shock!

13. Do not plug or unplug the appliance from the

electrical outlet with a wet hand.

14. Children are unable to recognize the hazards

associated with incorrect handling of electrical appliances. Therefore, children should never use electric household appliances unsupervised.

15. This appliance is not designed for commercial use.

16. Do not use the appliance for other than intended

17. Always unplug the appliance immediately after use.

To unplug the cord by grasping the plug, do not pull on the cord.

18. Ensure fingers are kept well away from moving parts.

19. Do not use the multi chopper when it is empty.

20. Never attempt to take food or liquid into the Jar

when the blade is moving. Always wait until the blade stops completely.

21. Do not immerse the Motor Unit into water or under

a tap or in a dishwasher.

23. Do not use outdoors.

24. Regarding the instructions for cleaning the surfaces

which come in contact with food and operating times, please refer to the below paragraph of the manual.

25. Do not use the machine without the lid.

26. Do not use the machine in high temperature

1. Remove the appliance from the packaging.

2. Take care when handling sharp blades.

3. Clean the appliance as described in section “CLEANING AND MAINTENANCE”.

1. Attach the blade assembly onto blade support in the jar and pour in the food to be chopped. Never

exceed the MAX line indicated on the jar. Hard food must be cut into small pieces (about 2cm). Otherwise, the motor may block. Note: This blade assembly is equipped with two sets of blades. Rotate the upper set of blades anti-clockwise, you can separate the two sets of blades. You can use either one set or two sets of blades when processing food. Check and tighten the upper set of blades before use if two sets of blades are applied. Caution: Handle the blades with care! Only touch the plastic part when separate or assemble the two sets of blades.

2. Place and rotate the jar lid onto the jar (note the bulge and groove). Place the motor unit onto the jar lid.

Make sure the edge of the motor unit and the jar lid is fully aligned.

3. Put the plug into an appropriate power outlet. Press the on/off button for processing. The appliance only

works when the on/off button is pressed.

4. After use, take out the plug from the power outlet. Make sure the blades stop rotating completely before

removing the motor unit, jar lid and blade assembly. Note: Always make sure the motor unit is in its place; otherwise, the unit will not function. Do not operate for more than 1 minute at a time. Stop and cool for 2 minutes then resume. Please make sure the appliance rest more than 2 minutes between any two operations. After working 3 cycles, the unit has to stop 15 minutes to wait the main engine to cool down.- 6 - This product cannot chop hard things, such as meat with bones, soya bean, pepper, coffee bean, ice cubes and freezing food. CHOPPING GUIDE Food Type Preparation hints Fruits and vegetables Cut into small pieces (20x20x50mm). Process up to 100g for several seconds until the desired chop/puree is reached. Nuts Process up to 100g for several seconds until the desired chop is reached. Meat Cut into small pieces (20x20x50mm). Process up to 60g for several seconds until the desired chop is reached.

CLEANING AND MAINTENANCE

1. Unplug the appliance and remove motor unit.

2. Wash the jar, jar lid and blade assembly in warm soapy water. Rinse and try them thoroughly before use.

3. The jar, jar lid and blade assembly are dishwasher-safe.

4. Wipe the motor unit with a damp cloth and then dry it thoroughly. Never immerse it in water for cleaning

as electrical shock may occur. Caution: Blade is every sharp, handle with care. TECHNICAL DATA Operating voltage: 220-240V ~ 50-60Hz Power consumption: 400W