SWKD 100 A1 - Uncategorized SILVERCREST - Free user manual and instructions

USER MANUAL SWKD 100 A1 SILVERCREST

health and the health of others, but also to prevent damage to the heated blanket. Observe this safety advice. If you pass the heated blanket on to anyone else, please pass on these operation instructions as well. SCALDING HAZARD! This heated blanket may not be used by persons insensitive to heat and other persons in need of protection who do not respond to overheating (e.g. diabetics, persons with skin changes caused by illness or scarred skin areas in the application area, after using analgesics or alcohol). There is a risk of skin burns.13 GB/IE Important safety instructions This heated blanket may not be used for very young children (0–3 years), as they are unable to react to overheating. There is a risk of skin burns. The heated blanket may be used by children over 3 years and under 8 years when supervised, if the switch is always set to the lowest temperature level. Otherwise there is a risk of burns. This heated blanket may be used by older children age 8 and up, and persons with diminished physical, sensory or mental ca- pacities or lacking experience and knowledge when supervised and instructed on the safe use of the heated blanket and understand the associated risks. Children must be supervised to ensure they do not play with the heated blanket. There is a risk of injury. Children must not perform clean or maintain the heated blanket without supervision. There is a risk of injury.

he heated blanket is not inte nded for use in hospitals or for com- mercial use. This poses a risk of injuries and / or damage to the heated blanket.

not poke the heated blanket with needles or sharp objects. There is a risk of electric shock.

not switch on the heated blanket whilst folded or bunched up. The heated blanket may oth- erwise be damaged. Do not use when wet! Otherwise there is a risk of electric shock. This heated blanket may only be operated with the control unit specified on the label. The heated blanket may otherwise be dam- aged. The electric and magnetic fields emitted by this heated blanket could possibly interfere with the functionality of your pacemaker. However, the levels are far below the permissible limits: electric field strength: max. 5000 V / m, magnetic field strength: max. 80 A / m, magnetic flux density: max. 0.1 milli-Tesla. Therefore please consult your physician and the manufacturer of your pacemaker before using this heated blanket. Do not pull, twist or kink the cables

The heated blanket may otherwise be damaged.14 GB/IE Important safety instructions / Safety system The cable and the switch of the heated blanket may pose a risk of catching, strangulation, tripping or being stepped on if positioned incorrectly. The user must ensure excess cable and cables in general are positioned safely. Frequently check this heated blan- ket for signs of wear or damage. If signs thereof are detected, the heated blanket was used improp- erly or will no longer heat up, it must first be inspected by the man- ufacturer before being switched on again. If the mains lead to the heated blanket is damaged it must be replaced by the manufacturer, its customer service centre, or a similarly qualified person to pre- vent hazards. With the heated blanket switched on, never – place objects on it (e.g. suit- cases or clothes baskets), – place a heating source such as a hot-water bottle, heating pad or similar items on it. The heated blanket may otherwise be damaged. The electronic components inside the control unit will heat up whilst operating the heated blanket. For this reason, never cover the control unit or place it on the heated blanket during operation. This poses a risk of injuries and / or damage to the heated blanket. Always observe the information on start-up, cleaning and care, and storage. If you have additional questions on using our products, please contact our Customer Service Department. Safety system Note: The heated blanket features a safety system. The electronic sensor technology prevents the heated blanket from overheating across the entire surface by automatically switching off in the event of a mal- function. If the safety system switches the heated blanket off automatically as a result of a malfunction, the func tion display

will no longer light up, even when the heated blanket is switched on. Please note that, for safety reasons, the heated blanket must not be used after a fault and must be returned to the service address indicated. Under no circumstances should you connect the defective heated blanket to another switch of the same type. This would also result in a permanent shutdown by the safety system in the switch.15 GB/IE Start-up / Storage Start-up Note: When the heated blanket is used for the first time, you may notice a smell of plastic; however, this will disappear after a short time. To use the heated blanket, first connect the con- trol unit

with the heated blanket using the plug-in connector

(see Fig. B). Then insert the mains plug into the socket. Switching on / off / Selecting the temperature Switching on: Set the control unit

to level 1, 2, 3, 4, 5 or 6 to switch on the heated blanket. Note: The function display

will light up af- ter switching the heated blanket on. Switching off: Set the control unit

will go off. Selecting the temperature: Set the control unit to the highest temperature setting (setting 6). This will cause the heating blanket to warm up quickly. When opera- ting the heated blanket for several hours, we recommend setting the control unit

to the lowest setting to prevent the body from overheating and to prevent potential subsequent skin burns or a heat stroke. Temperature levels Set the control unit

to the desired temperature (see Fig. A). Level 0: off Level 1: minimum heat Level 2–5: customised heat Level 6: maximum heat Automatic switch-off Note: The heated blanket switches itself off auto- matically after approx. 180 minutes. The function display

will then start flashing. To switch the heated blanket back on, first select level 0 and after approx. 5 sec. select the desired temperature level. If the heated blanket is no longer used after the timer expires: – switch off the heated blanket (level 0), – unplug from the socket, – disconnect the plug-in connector

, thus the control unit

from the heated blanket. Storage

RISK OF DAMAGE TO THE

PRODUCT OR PROPERTY! Let the heated blanket cool before put- ting it away. The heated blanket may otherwise be damaged.