SV3052 - Croque monsieur clip Concept - Free user manual and instructions

USER MANUAL SV3052 Concept

Acknowledgements Thank you for purchasing a Concept product. We wish you much joy with your new appliance every day you use it. Please read the instruction manual carefully before initial use. To refer to this manual any time you need to, we recommend you to keep it in a safe place. Please ensure that other persons who will use this product are familiar with these instructions. Technical specications Voltage 220-240 V~50-60 Hz Input 700 W IMPORTANT Before connecting to the mains, make a visual check to ensure that the unit is intact and that no damage occurred during transport.

IMPORTANT SAFETY PRECAUTIONS

• Do not use the appliance in any other way than as described in this manual.

• Remove all the covering and marketing materials from the appliance before the rst use.

• Make sure the mains voltage corresponds to the values on the rating plate of the product.

• The appliance is hot during operation and for some time after switching o. Therefore, do not touch hot surfaces. Use handles and buttons. There is risk of serious burns!

• Do not clean, store or cover the appliance until it has cooled completely.

• Do not place the appliance on its side during operation.

• Do not leave the appliance unattended when it is switched on or connected to the mains.

• Never carry the appliance during operation or while it is still hot. Do not carry it by the power cord.

• When disconnecting the appliance from the wall outlet, never pull the power cord, grasp the plug end and disconnect it by removing it from the receptacle.

• Do not allow children or unauthorized people to handle the appliance, use it out of their reach.

• Persons with reduced mobility, reduced sensory perception, mental disadvantage or persons not familiar with the operation must use the appliance only under the supervision of responsible person, who is Caution! Hot surface

familiar with the instructions.

• Pay extra attention if the appliance is used near children.

• Do not use the appliance as a toy.

• Before cleaning and after use of the appliance, switch the appliance o, disconnect it from the mains and allow it to cool down.

• Do not allow the power cord to hang freely over the edge of the table. Do not allow the power cord to touch hot surfaces.

• Only place the appliance on a stable and heat-resistant surface away from other heat sources such as radiators, ovens, etc. Protect it from direct sunlight and moisture.

• Do not use the appliance in an environment where there are explosive gases and ammable substances (solvents, varnishes, adhesives, etc.).

• Caution - bread may ignite! When using the appliance, keep a sucient space around and above the appliance to ensure sucient air circulation. Do not let the appliance come into contact with curtains, wall linings, textile, paper, or other combustible materials while in operation. In addition, it is not recommended to install the appliance near or under the above materials. Do not put any of these materials on top of the appliance.

• Do not insert any metal objects into the appliance.

• Do not put excessively large pieces of food in the appliance.

• The appliance is only suitable for home use and is not intended for commercial use.

• When unplugging the appliance from the wall outlet, make sure the appliance has been turned o, then disconnect the plug from the wall outlet.

• Do not touch the appliance with wet hands.

• Do not immerse the power cord, plug or appliance in water or any other liquid.

• Do not use any accessories other than those recommended by the manufacturer.

• Do not repair the appliance yourself. Contact an authorized service centre.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Cleaning and maintenance performed

by the user must not be carried out by children unless they are 8 years old and under supervision. Children aged under 8 years of age must be kept away from the appliance and its power cord. Do not let children play with the appliance. Damages from failure to follow the manufacturer's instructions are not covered by the warranty. PRODUCT DESCRIPTION 1 Hinged top lid 2 Bottom cover 3 Safety closure 4 Power indicator 5 “Heat on” indicator 6 Grip handle

WATER OR ANY OTHER LIQUID! OPERATING INSTRUCTIONS Before using the appliance for the rst time, wash the toasting surfaces with a wet cloth. In spite of that, we recommend not to eat the rst two pairs of sandwiches. Sandwich maker preparation procedure:

1. Insert the plug into a socket. Make sure that the mains

voltage corresponds to the voltage of the appliance. The power indicator and the “heat on” indicator will be on.

2. Close the top lid of the sandwich maker (you can

prepare your food while it is warming up).

3. The sandwich maker is ready when the green “heat on”

4. Open the top lid of the sandwich maker and place the

food on the bottom part of the sandwich maker.

5. Your food will be ready in approximately 4 minutes (or

longer, according to your taste). NOTE:

• Do not close the sandwich maker by force. A cloud of steam may rise from the toasting surfaces during the toasting process.

• Use the safety closure to lock the two parts of the sandwich maker during the toasting process. Please note that the “heat on” indicator will go on and o during the toasting process as the thermostat maintains the correct temperature of the sandwich maker.

• Open the sandwich maker and remove the food using a plastic or a wooden spatula. Never use a metal knife as it may damage the non-adhesive coating.

• Close the lid in order to keep the surfaces hot for further toasting.

• You may prepare another food during the toasting process.

• When nished, unplug the appliance.

CLEANING AND MAINTENANCE

• Before cleaning, unplug the appliance and let it cool down. Wipe the inside and edges of the grating with a paper towel or a soft cloth.

• Wipe the surface of the sandwich maker using only a slightly damp cloth to ensure that no water, grease or oil enter the cooling openings.

• Do not clean the inner and outer parts with a rough sponge or a pot scourer as it may damage the surfaces. SERVICE CENTRE Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by aqualied specialist or the service centre. ENVIRONMENTAL CONCERNS

• Packaging materials and old appliances should be recycled.

• Packaging materials may be disposed of as sorted waste.

• Dispose the plastic bags made of polyethylene (PE) of as sorted waste. Recycling of the appliance at the end of its lifespan: This appliance is labelled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appliances (Waste Electrical and Electronic Equipment - WEEE). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The disposal of such material has to be done according to the recycling regulations. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the appliance. The product meets all the necessary requirements of the EU directives applicable to the specic product. Changes in text, design, and technical specications are subject to change without prior notice and we reserve the right to change them. ENEN 3736 SV3051 | SV3052 | SV3053SV3051 | SV3052 | SV305339 SV3051 | SV3052

SV3051 | SV3052 WARRANTY TERMS Warranty The manufacturer (or importer) is responsible for ensuring the product complies with the requirements of applicable legal regulations as well as those of the relevant technical standards. Moreover, they are responsible for ensuring the product has the properties the manufacturer described in documents related to the goods or those reasonably expected by the customer with regard to the nature of the goods or based on advertising produced by the manufacturer, and further they are responsible for ensuring the product is t for the purpose proposed by the manufacturer or that aproduct of the same type is normally used for. The quality warranty term is 24 months from product takeover by the customer. The warranty does not apply to wear and tear caused by regular use. The customer shall not be entitled to any warranty claims if, prior to taking the product over, they knew the product contained a defect or if the defect is attributable to the customer. The warranty specically does not apply:

• if the product installation, operation and service conditions stipulated in the product operating manual have not been adhered to,

• to malfunctions caused due to mechanical, heat or chemical damage, short circuit, over voltage or incorrect installation,

• to malfunctions caused by an inexpert third-party intervention,

• to malfunctions caused by natural disaster,

• to malfunctions caused by insucient or inappropriate maintenance in violation of the operating manual, including malfunctions caused by water and other sediments,

• to changes in colour of the heating surface or to scratching of the surface caused as a result of using the products in an unusual manner,

• to appearance and functional changes caused by exposure to sunlight, thermal radiation of water and other sediments,

• if the service life of certain product parts expires, e.g. for accumulators, bulbs, etc. The warranty does not apply to any products and services provided along with the product (gifts, promotional articles, etc.). Filing a complaint A complaint against a product defect must be led as soon as identied, yet no later than before the end of the warranty term. The customer must le a product complaint with the dealer from which they have purchased the product, or with any authorised service centre, a list of which is included in the product package, or available at www. my-concept.com. While ling a product complaint, the product must be duly cleaned and securely packed so as to prevent any damage during its transport to an authorised service centre, where relevant, unless the product is delivered in person. The customer must submit proof of having concluded a purchase contract for the product by producing the receipt. While ling their complaint, the customer must indicate the noted defect and identify the preferred complaint application method. Complaints processing As long as the noted defect may be removed, the user has the right to have the defect duly removed free of charge on a timely basis. Where such a procedure is not reasonable with regard to the nature of the defect, the user may require to be supplied a new defect-free product (replacement), or, where the defect applies to a part of the product only, replacement of the part concerned. However, if replacement of the product or any part thereof is not proportionate with regard to the nature of the defect, especially if the defect can be removed without undue delay, the customer has the right to have the defect removed free of charge.

SV3051 | SV3052 If the noted defect is not removable, or if the customer becomes entitled to replacement of the product or a part thereof, yet the replacement is not possible, for example due to the product having been sold out, the customer has the right to return the product (withdrawal from the contract). The customer shall have the right to a new product (replacement) or to replacement of a part of the product even if the defect can be removed, provided they cannot properly use the product due to repeated occurrence of the defect or due to a high number of such defects. In such a case, the customer also has the right to return the product (by withdrawing from the contract). If the product is not returned (the customer does not withdraw from the contract), or if the customer does not apply the right to a new defect-free product (replacement), to replacement of a part thereof or to repair of the product, they may request a reasonable discount. The customer also has a right to a reasonable discount if a new defect-free product cannot be supplied to them, or if a product part cannot be replaced or the product repaired unless the situation is remedied within a reasonable time limit, or if remedying the situation would create major discomfort on the part of the customer. The seller, authorised service centre or a sta member authorised by them must decide about each complaint immediately or within three business days in complicated cases. This term does not include areasonable period of time, depending on the type of product concerned, required for the defect to be assessed by an expert. A complaint, including defect removal, must be dealt with without any undue delay, yet no later than within 30 calendar days of the complaint ling date, unless the seller and the customer agree on a later deadline. On returning the product (withdrawing from the contract) the customer must return any accessories and documents supplied along with the product. The customer does not have the right to keep the defective parts and components of the product replaced as part of a repair of the product. This shall be without prejudice to any other rights the customer may have in relation to the purchase of the product. Remark: Complaints against products damaged in transport are governed by the carrier’s complaints procedure. Manufacturer Jindřich Valenta - Concept Vysokomýtská 1800, 565 01 Choceň Czech Republic tel.: [phone] fax [phone] Company ID No. 13216660 email: [e-mail] www: www.my-concept.com Product data Model: Production number: Date of purchase: Seal and signature of vendor:8382 SV3051 | SV3052 | SV3053SV3051 | SV3052 | SV3053