10028003 - Kettle Klarstein - Free user manual and instructions

USER MANUAL 10028003 Klarstein

1. Read all instructions before using.

2. Before connecting the kettle to the power supply, check that the voltage indicated on the appliance

(underside the kettle & base) corresponds with the voltage in your home. If this is not the case, contact your dealer and do not use the kettle.

3. The attached base can not be used for other than intended use.

4. Do not operate the appliance without load to avoid damaging the heat elements.

5. Unplug from the outlet when not in use.

6. Do not let the cord hang over edge of table counter or touch hot surface.

7. Do not place on or near a hot gas or electric burner or in a heated oven.

8. Should you accidentally allow the kettle to operate without water, the boil-dry protection will

automatically switch it o. If this should occur, allow the kettle to cool before lling with cold water and re-boiling.

9. Ensure that kettle is used on a rm and at surface where the children can’t touch, this can prevent

from overturning the kettle to damage the person or kettle.

10. To protect against a re, electric shock or personal injury, do not immerse cord, electric plugs or

kettle in water or other liquids.

11. Always take care to pour boiling water slowly and carefully without tipping the kettle too fast.

12. Be careful when opening the lid for relling when the kettle is hot.

13. Close supervision is necessary when any appliance is used by or near children.

14. Do not touch the hot surface. Use the handle or the button.

15. Extreme caution must be used when moving an appliance containing hot water.

16. The appliance is not a toy. Do not let the children play it.

17. The use of attachments that are not recommended by the appliance manufacturer may result in re,

electric shock or personal injury.

18. While boiling water, avoid to contact with steam from the spout when water is boiling or just after it

has switched o. Do not be anxious to uncover the lid.

19. Unplug from outlet when not in use and before cleaning; Allow it to cool before putting on or taking

o parts and before cleaning the appliance.

20. Always ensure the lid is closed and do not lift it while the water is boiling. Scalding may occur if the

lid is removed during the brewing cycles.

21. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a

similarly qualied person in order to avoid a hazard.

22. Do not use the appliance for other than intended use.

23. The kettle can only use with the stand provided.

24. If the kettle is overlled, boiling water may be ejected.

25. Do not use the kettle outdoors.

26. This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.

27. Children should be supervised to ensure that they do not play with the appliance.

28. This appliance is intended to be used in household and similar applications such as: sta kitchen

areas in shops, oces and other working environments; farm houses; by clients in hotels, mo- tels and other residential type environments; bed and breakfast type environments.

29. Save these instructions.Kettle

A Lid Cover B Filer C Body D Base E Power Indicator Light F On/O Switch] G Handle H Thermometer Before initial use If you are using the kettle for the rst time, it is recommended that you clean your kettle before use by boiling a full kettle of water twice and then discarding the water. Operation

1. To ll water into the kettle, remove it from the power base and open the lid by pressing the lid

open button , ll with the desired amount of water to the kettle. Always ll the kettle between the minimum (0.5L) and maximum (1.7L) marks. Too little water will result in the kettle switching o before the water has boiled. NOTE: Do not ll the water over the maximum level, as water may spill out of the spout when boiling. Ensure that the lid is rmly in place before connecting the power cord to the outlet.

2. Position the kettle on the power base.

3. Connect the plug into a power outlet. Press the switch button below the handle. The indicating

lights inside the kettle will light up. Then start to boil the water. The kettle will switch o automatically once the water has boiled and the light extinguishes. You can shut o the power by pressing the switch button at any moment during boiling water. NOTE: Ensure that switch is clear of obstructions and the lid is rmly closed. The kettle will not turn off if the switch is constrained or if the lid is left open.

4. Lift the kettle from the power base and then pour the water.

NOTE: Operate carefully when pouring the water from your kettle as boiling water may result in scald, besides, don’t open the lid while the water in the kettle is hot.

5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before

reopening to boil water. The kettle may be stored on the power base when not in use. NOTE: Ensure power supply is turned off when kettle is not in use.

Boil-dry protect Should you accidentally allow the kettle to operate without water, the boil-dry protection will automatically switch it o. If this should occur, allow the kettle to cool before lling with cold water and re-boiling. Care and cleaning Always disconnect the appliance from the power outlet before cleaning. Never immerse the kettle or cord in water, or allow moisture to contact with these parts. Removal of mineral deposits Mineral deposits in tap water may cause the kettle interior to discolor .To remove this build-up, use Liquid Descaler, a simple to use non-toxic cleaner. Alternatively:

1. Fill the kettle with 3 cups of white vinegar and the remainder with water and be allowed to stand

overnight. DO NOT BOIL.

2. Empty the solution from the kettle. Any stains remaining inside the spout can be removed by

rubbing with a damp cloth, ll the kettle with clean water, bring to boil and then discard the water. Repeat and the kettle will then be ready to use. The outside of the kettle can be wiped over with a damp cloth. Cleaning appearance of housing Wipe the appearance of housing with a wild and damp cloth or cleaner, never use a poisonous cleaner. Cleaning the lter Remember to clean the lter with a wild and damp cloth at intervals. The lter can be detached for easier cleaning simply by pulling it out. To attach, insert the lter into the support dent. CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle. Storage When not in use or storage, the power cord may be wound around the cord storage under the bottom of kettle. Technical Specications Technical specications: 220-240V 50/60Hz 2200W9 Hints on Disposal According to the European waste regulation 2002/96/EG this symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappro- priate waste handling of this product. For more detailled information about recy- cling of this product, please contact your local council or your household waste disposial service. Declaration of Conformity Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany. This product is conform to the following European Directives: 2014/30/EU (EMC) 2014/35/EU (LVD) 2011/65/EU (RoHS)10 11 Instructions de sécurité Appareil : Pour réduire le risque d‘incendie, d‘électrocution et de dommages en général :