SBCSC362/86U - Headphones PHILIPS - Free user manual and instructions

USER MANUAL SBCSC362/86U PHILIPS

This document is printed on chlorine free produced paper Data subject to change without notice Printed in China

€0682

baby monitor

SBC SC362

A-1 Power light - lights when unit is powered; flashes when batteries are low
A-2 Transmit light - lights when a sound is being transmitted
A-3 Talk pushbutton push this button to talk
A-4 Microphone high-sensitivity microphone
A-5 DC power supply socket ---- plug mains adapter connector into this socket
A-6 Mode switch

VOICE: baby monitoring mode; microphone is sound activated OFF: switches off the Baby unit completely

A-7 Channel selection switch select channel A or B (whichever has least interference)
A-8 Battery compartment cover ---- unscrew and unclip to insert batteries
A-9 AC power adapter plug into AC mains socket and into DC power supply socket

PARENT UNIT

B-1 Power light - lights when unit is powered; flashes when batteries are low
B-2 Loudspeaker provides clear sound
B-3 Loudspeaker Volume control / Off switch set loudspeaker level;
- switches off the power to the unit completely
B-4 Power base place unit in base to operate it on mains power
B-5 Battery compartment cover unclip to replace batteries
B-6 Channel selection switch --- select channel A or B (same as Baby unit)
B-7 Belt clip handy clip for carrying the unit
B-8 DC power supply socket ---- plug mains adapter connector into this socket
B-9 AC power adapter plug into AC mains socket and into DC power supply socket
B-10 Power base light - lights when unit is in the base

CONGRATULATIONS

You have just purchased a high-performance, cordless Baby Monitor that lets you listen to your child from wherever you are in and around the house. Please read this guide carefully before using the monitor, and keep it for future reference.

IMPORTANT!

This Baby Monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such.

Make sure the Baby unit and adapter cable are always out of reach of the baby, at least 1 metre away.

Never place the Baby unit inside the baby's bed or playpen!

The antennas on the Parent and Baby units are fixed; do not try to extend them.

Never cover the Baby unit (with a towel, blanket, etc.)

GETTING THE UNITS READY FOR USE

Baby unit

Connect the AC power adapter (A-9) to an AC mains socket, and then connect the cord to the DC power supply socket (A-5) of the Baby unit.

If you want to use batteries, remove the battery compartment cover (A-8) using a screwdriver. Insert four 1.5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw.

The Baby unit operates cordlessly for up to 30 hours on fresh batteries. The red POWER light (A-1) flashes when battery power is low. If this happens install new batteries.

Note: To switch off the Baby unit completely set the mode switch (A-6) to OFF.

Parent unit

Connect the AC power adapter (B-9) to an AC mains socket, and then connect the cord to the DC power supply socket (B-8) of the power base (B-4). Place the Parent unit inside the power base. The red light (B-10) lights.

If you want to use batteries, remove the battery compartment cover (B-5). Insert four 1.5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting the + and - configuration inside the battery compartment. Put the cover back in place.

The Parent unit operates cordlessly for up to 30 hours on fresh batteries. The red POWER light (B-1) flashes when battery power is low. If this happens install new batteries.

Monitoring baby's sounds

To use the units to listen to your baby:

• Position the Baby unit at least 1 metre away from the baby so that the microphone (A-4) can pick up baby's sounds.
• Set the channel switch to the same position on both units.
• Set the mode switch on the baby unit (A-6) to VOICE; the red POWER light (A-1) lights.
• Move away from the Baby unit with the Parent unit.
• Switch on the Parent unit using the Volume control/Off (B-3) and adjust the volume to the level you prefer; the red POWER light (B-1) lights.
• The green TRANSMIT light (A-2) lights when a sound is picked up by Baby unit.

Talk pushbutton

To use the Baby unit manually to talk to the Parent unit:

• Set the mode switch on the Baby unit (A-6) to OFF.
• Switch on the Parent unit using the Volume control/Off (B-3) and adjust it to about mid-range; the red POWER light (B-1) lights.
• On the Baby unit, press and hold the TALK pushbutton (A-3) and talk clearly into the microphone (A-4). Release the TALK pushbutton when you are finished.

ADDITIONAL FEATURES

Avoiding interference

Both units use anti-interference technology to reduce the chance of interference from other signals. If interference does occur or if sound reception is poor, try switching both units to the other channel to improve the sound quality.

Note: Always make sure that the channel selection switches (A-7, B-6) on both units are set to the same position.

Belt clip

If the Parent unit is operating on batteries, you can carry it around giving you freedom of movement while still monitoring your baby. Use the belt clip (B-7) to attach the unit to your clothing and so keep your hands free. The belt clip can be removed by unclipping the top and sliding it downwards.

PROBLEM SOLVING

Problem	Possible Cause	Solution
Power light does not light	Unit is not turned on.	Parent unit:- turn Volume control/Off switch clockwise (B-3). Baby unit:- set mode switch (A-6) to the VOICE position.
	AC adapter is not plugged in or Batteries are exhausted.	Plug in AC adapter or replace batteries.
	AC adapter plugged into an outlet that is not working.	If the power socket has a switch, turn it on.
High pitched noise.	Units are too close together.	Move Parent unit away from Baby unit.
	Volume too high.	Turn volume control on Parent unit counter-clockwise.
No sound.	Volume control on Parent unit is set too low.	Turn volume control/Off switch clockwise (B-3).
	Units are out of range.	Move Parent unit closer to Baby unit.
Power light blinking.	Batteries are low or empty.	Replace batteries or connect to mains power.
Interference or poor reception.	Mobile or cordless phones too close to the baby monitor can cause interference.	Move the phones away from the units.

TECHNICAL SPECIFICATIONS

Power supply

• Optional batteries 4 × 1.5 ~V ; AA alkaline for Parent Unit (not included);
• Optional batteries 4 × 1.5 ~V ; AA alkaline for Baby Unit (not included);
• AC power adapter 230V AC, 50Hz (two included): - Output voltage 9V DC, 200mA .

Only use the AC power adapter included or a type that complies with safety standard EN60950 and that has the following specification: 9 Volt DC / 200mA.

Operating range

• up to 150 metres in ideal conditions (walls and floors can limit this distance).

• 10^ to 40^

Pilot tone

• Continuous communication link (hidden signal ensures a continuous link between both units so you only hear your baby's sounds).

Transmission frequencies

SBC SC362/86U & SBC SC362/87U:

SBC SC362/05U (IRE, UK):

SBC SC362/13U (SE):

SBC SC362/16U (ES):

Channel A

40.695 MHz

49.890 MHz

27.145 MHz

31.350 MHz

Channel B

40.675 MHz

49.830 MHz

27.095 MHz

31.000 MHz

UNITE BÉBÉ

A-1 Témoin d'alimentation ----- s'allume quand l'unité est active; clignote quand les piles sont faibles
A-2 Témoin de transmission s'allume quand un son est en cours de transmission
A-3 Bouton «Parlez» appuyez sur ce bouton pour parler
A-4 Microphone - microphone très sensible
A-5 Prise d'alimentation élect. c.c. --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- enfichez le connecteur d'adaptateur réseau dans cette prise
A-6 Selecteur de mode

Zendfrequencies:	Kanaal A	Kanaal B
SBC SC362/86U & SBC SC362/87U:	40.695 MHz	40.675 MHz
SBC SC362/05U (IRE, UK):	49.890 MHz	49.830 MHz
SBC SC362/13U (SE):	27.145 MHz	27.095 MHz
SBC SC362/16U (ES):	31.350 MHz	31.000 MHz

UNITA BAMBINO

A-7 Selettore del canale selezione il canale A o B (quello che presenta meno interferenze)
A-8 Coperchio vano batterie svitarlo e toglierlo per insere le batterie
A-9 Adattatore A.C. --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- D.C.

UNITÀ GENITORE

B-4 Base di alimentazione collocare l'apparecchio nella base in modo che sua alimentato a corrente
B-5 Coperchio vano batterie toglierlo per sostituire le batterie
B-6 Selettore canale selezionare il canale A o B (deve essere quello del unità bambino)
B-7 Gancio per cintura pratico gancio per il trasporto dell'unità
B-8 Presa per alimentazione D.C.-- inserire il connettore dell'adattatore alla rete in questa presa
B-9 Adattatore per A.C. --- -- --- -- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- --- —--- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 100 - 100 - 100 - 100 - 100 - 100 - 100 - 100 - 100 - 100 - 100 - 100 - 100 -
B-10 Spia alimentazione si accende se l'apparecchio è collocato nella base di alimentazione

CONGRATULAZIONI

TALK (tale) trykknap

Sendefrekvenser	Kanal A	Kanal B
SBC SC362/86U & SBC SC362/87U:	40.695 MHz	40.675 MHz
SBC SC362/05U (IRE, UK):	49.890 MHz	49.830 MHz
SBC SC362/13U (SE):	27.145 MHz	27.095 MHz
SBC SC362/16U (ES):	31.350 MHz	31.000 MHz

BABY-ENHET

TALK-trykknapp (tale)

SBC SC362/86U & SBC SC362/87U
R&TTE Directive 1999/5/EC

BE √	DK √	GR √	ES	FR √
IRE	IT √	LU √	NL √	AT √
PT √	FI √	SE	UK	NO √
DE √	CH √

SBC SC362/05U
R&TTE Directive 1999/5/EC

BE	DK	GR	ES	FR
IRE✔	IT	LU	NL	AT
PT	FI	SE	UK✔	NO
DE	CH

SBC SC362/13U
R&TTE Directive 1999/5/EC

BE	DK	GR	ES	FR
IRE	IT	LU	NL	AT
PT	FI	SE √	UK	NO
DE	CH

SBC SC362/16U
R&TTE Directive 1999/5/EC

BE	DK	GR	ES √	FR
IRE	IT	LU	NL	AT
PT	FI	SE	UK	NO
DE	CH