AL C20D - Battery charger YARDFORCE - Free user manual and instructions

Product Type	Battery Charger
Brand	YARDFORCE
Model	AL C20D
Input Voltage	220-240 V ~
Input Frequency	50/60 Hz
Input Power	120 W
Output Voltage	21 V
Output Current	4 A
Protection Class	II (double insulation)
Compatible Battery Type	PERUN Lithium-Ion batteries
Intended Use	Indoor only
Charge Indicator	Green LED (blinking during charging, solid when ready)
Safety Protection	Overvoltage, overcurrent and short-circuit protection
Compliance	European directives (WEEE, CE)
Approximate Dimensions	150 x 80 x 50 mm
Approximate Weight	400 g
Maintenance	Clean with a soft, dry, clean brush
Estimated Lifespan	Several years depending on usage

Frequently Asked Questions - AL C20D YARDFORCE

What type of battery can I charge with this charger?

This charger is designed exclusively for PERUN Lithium-Ion batteries. Do not attempt to charge other battery types.

How long does it take to charge a battery?

Charging time depends on battery capacity. With an output current of 4 A, a 4 Ah battery charges in about 1 hour.

Can I use this charger outdoors?

No, the charger is intended for indoor use only. Protect it from moisture and rain.

What does the green LED blinking mean?

The green LED blinks during normal charging. When the battery is fully charged, the LED stays solid.

Is the charger compatible with batteries from other brands?

No, use only compatible PERUN batteries. Using other batteries may present a fire or explosion risk.

What to do if the charger does not work?

Check the mains socket, cable and battery. If the problem persists, do not disassemble the charger and contact a qualified professional.

Does the charger heat up during use?

Slight heating is normal. However, do not cover the charger to avoid overheating.

Can I leave the battery on the charger after charging?

It is recommended to remove the battery from the charger once fully charged to extend its lifespan.

How to clean the charger?

Unplug the charger and clean it with a soft, clean, dry brush. Do not use water or chemicals.

How to dispose of the charger at the end of its life?

Do not dispose of the charger with household waste. Follow your local WEEE recycling rules or return it to a store.

USER MANUAL AL C20D YARDFORCE

The purpose of safety symbols is to attract your attention to any possible dangers. The safety symbols and their explanations deserve your careful attention and full understanding. The symbol warnings do not, by themselves, eliminate any danger. The instructions and warnings they give are no substitute for proper accident prevention measures.

WARNING: Be sure to read and understand all safety instructions within this operator's manual, including all safety alert symbols such as "DANGER", "WARNING", and "CAUTION" before using this tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.

SAFETY ALERT SYMBOLS: Indicate DANGER,

WARNING, or CAUTION. May be used in conjunction with other symbols or pictographs.

Symbol meanings

This page depicts and describes safety symbols that may appear on this product. Read, fully understand and follow all instructions on the machine before attempting to assemble and operate.

SYMBOLS

To reduce the risk of injury, user must read instruction manual carefully.

The charger is for indoor use only.

Double insulation

Protective 5 A limited

WEEE symbol. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

The product complies with the applicable European directives and an evaluation method of conformity for these directives was done.

GB

GENERAL SAFETY WARNINGSGENERAL SAF

Read all safety warnings and all instructions. Fail-ure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.

Save these instructions for later use.

Use the battery charger only when you fully understand and can perform all functions without limitation, or have re- ceived appropriate instructions.

• Only charge PERUN lithium-ion batteries. The battery voltage must match the battery charging voltage of the charger. Otherwise there is danger of fire and explosion.
• Keep the battery charger clean. Contamination can lead to danger of an electric shock.
• Before each use, check the battery charger, cable and plug. If damage is detected, do not use the battery charger. Never open the battery charger yourself. Have repairs performed only by a qualified technician and only using original spare parts. Damaged battery chargers, cables and plugs increase the risk of an electric shock.
• Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the charger. Keep cord away from heat, oil, sharp edges and moving parts. Damaged or en- tangled cords increase the risk of electric shock.
• Do not operate the battery charger on easily inflammable surfaces (e. g., paper, textiles, etc.) or surroundings. The heating of the battery charger during the charging process can pose a fire hazard.
• In case of damage and improper use of the battery,

vapours may be emitted. Ventilate the area and seek medical help in case of complaints. The vapours can irritate the respiratory system.

Supervise children during use, cleaning and maintenance. This will ensure that children do not play with the charger.
- This tool is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
- Cleaning and user maintenance of the battery charger shall not be made by children without supervision.
- Do not cover off the battery charger. Otherwise, the battery charger can overheat and no longer operate properly.
- In addition, observe the safety instructions for the battery.
- This is a class I unit and may only be connected to properly earthed power sources.

Products sold in GB only: Your product is fitted with a BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362).

If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. The replacement plug should have the same fuse rating as the original plug. The

GENERAL SAFETY WARNINGS

severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere.

INTENDED USE

The contained charger is intended for use with PERUN battery pack.

TECHNICAL DATA

Battery charger Model AL C20D
Input	220-240 V ~, 50/60 Hz 120 W
Output 21 V , 4 A	= =
Protection class II

OPERATION

Charging the battery pack

NOTE: Remove the battery pack from the charger after it has been fully charged.

NOTE: Battery should be fully charged before first use.
NOTE: Make sure the mains voltage is the same as rating label which is located on the charger.
1. Connect the charger to a power supply. The red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with the grooves of the charger then push it in.
3. The green LED light of the charger will flash continuously during normal charging.
4. After charging is complete, the green LED will light up.

MAINTENANCE AND STORAGE

Maintenance and Cleaning

Occasionally clean the battery using a soft, clean and dry brush.

Disposal

Battery chargers, accessories and packaging should be sorted for environmental-friendly recycling.
Be not disuence of bather pheromr into household wortl

Do not dispose of battery chargers into household waste!

Only for EC countries:

According to the European Guideline 2012/19/EU for Waste Electrical and

Elec- tronic Equipment and its implementation into national right, battery

chargers that are no longer usable must be collected separately and disposed of in an environmental correct manner.

CE DECLARATION

To the provisions of Council Directives

We

MEROTEC GmbH

Otto-Brenner-Str.8
47877 Willich, Germany

Declare that the product:

Machine Description: 20V Charger

ALC20D

BQ-SP07-2040ZA/BQ-SP07-2040ZB

Function: Charging battery

Complies with the essential health and safety requirements of the following directives:

Low Voltage Directive 2014/35/EU
Electromagnetic Compaliblity Directive 2014/30/EU
EC Directive 2011/65/EU and its amendment Directive (EU) 2015/863 (RoHS)

Standards and technical specification referred to :

EN60335-1:2012-A11+A13 EN60335-2-29:2004+A2+A11
EN55014-1:2017 EN55014-2:2015 EN55014-1:2006-A1+A2
EN 61000-3-2:2014 EN 61000-3-3:2013
EN50581:2012E

Authorized Signatory

Date:24.03.2020

Signature:

Place: Willich

Name: Roland Menken

General Manager

The object of the declaration described above satisfies the provisions of directive 2011/65/EU of the European Parliament and the Council of 8 June 2011 on limiting the use of certain harmful substances in electrical and electronic appliances.

WARNSYMOBLEWARNSYMOBLE

Sicherheitssymbole

Sous reserve de modifications.

DECLARATION CE

47877 Witten, Germany

Directive RoHS (LdSD) 2011/65/UE

Date:24.03.2020 Signature:

Lirr Willich

Nom: Roland Menken

Director General