BF1 - Bottle warmer Petra Electric - Free user manual and instructions

USER MANUAL BF1 Petra Electric

The appliance is no toy! Children are not allowed to use it and therefore store it out of their reach.

Operate the appliance out of the reach of the baby. Place the connection cord safely and do not pull it over sharp edges or jam it, do not allow it to hang down and protect it from heat and oil.

Do not place the baby food warmer onto hot surfaces, e. g. hot plate etc. or near gas flames, it may melt.

Do not pull out the plug by the cord and do not touch it with wet hands.

If the following happens do not use the appliance and unplug it immediately: - the appliance or the cord is damaged - the appliance leaks - any defect after the appliance has accidently dropped or something similar is suspected. In these cases have the appliance repaired.

Before putting into operation take care that there is water in the container. When operating the appliance for a longer time, under no circumstances allow the water to evaporate completely.

Caution, the container and the water will become hot during use.

Open the jars before warming up.

Always heat up the food using the water bath.

Baby food warm up once only and serve directly. Do not keep food warm for longer than one hour otherwise the hygienic quality of the baby food may be reduced.

This appliance is not meant to be used by persons (including children) with reduced physical, senso- rial or mental capacities or in absence of the necessary experience and/or knowledge - unless they are supervised by a person responsible for Instructions for use GB6 their safety and from whom they get instructions on how to use the appliance.

Keep out of reach from children.

The appliance cannot be switched off permanently by the temperature control. Therefore unplug always after use.

Do not immerse the baby food warmer in water.

In case of misuse, wrong handling or incorrect repair no liability will be taken for possible damages. Claims under guarantee are also excluded in such cases.

The appliance is not designed for commercial purposes.

Packaging material like foil bags are not designed for children. Putting into operation The appliance can be used for a convenient warming up and keeping warm of baby food jars and all standard sized feeding bottles. Any of the cord that is not required can be rolled up and stowed in the bottom of the appliance. Prior to first use slide the pointed end of the lifter into the groove in the upper edge of the appliance. To warm up baby food jars, push the lifter right down and fill the container with water up to the mark. Then place the opened jar onto the raised lifter and lower it until the water reaches the maximum level which is 1 cm under the edge of the container. In order to warm up a feeding bottle put it into the container and slide the lever right down. Then fill contai- ner with water up to 1 cm below the top of the container. Temperature control The temperature of the water bath can be controlled by the rotary switch. The warming up of the baby food depends on the consistency and composition of the bottle or the glass. For solid food choose a higher setting of the rotary switch than for liquid food. Full bottles and jars also require a higer setting than for less filled ones. When practising the correct setting can be found quickly. The control lamp shows that the device is heating. It goes out as soon as the water reaches the set temperature. Shake the bottle well or stir the baby food well in order to guarantee equally warm contents. The right temperature should always be checked by holding the baby bottle against the cheek or better by tasting yourself. If the food is to be kept warm for some time, the jar or the bottle should be left in the container. The thermostat guarantees a constant temperature by switching on the heating time after time. Cleaning and maintenance Before cleaning always unplug the appliance and pour out the remaining water. Never immerse the appliance into water. Do not use caustic or scouring cleansing agents. Clean with a damp cloth, if necessary use some washing-up liquid.7 coloured red. Do not connect any wire to the terminal which is marked with the letter E or by the earth symbol , or coloured green or green and yellow.

3. If a 13 A (BS 1363) plug is used it must be fitted with a

3 A fuse conforming to BS 1362 and be ASTA approved. If any other type of plug is used, the appliance must be protected by a 5 A fuse either in the plug or adapter or at the distribution board. If in doubt - consult a qualified electrician.

4. Never use the plug without closing the fuse cover.

The appliance complies with the European direc- tives 2006/95/EC and 2004/108/EC. At the end of its lifetime this product must not be disposed of through the normal domestic waste, but it should be handed to an assembly point for the recycling of electrical and electronical applian- ces. You can inquire about details at the local administration. Subject to technical changes. In order to avoid injury, any repairs of the appliance as well as the exchange of a damaged connection cord should only be carried out by the manufacturer, his authorised service agent or a person having similar qualifications. For UK use only

1. This product is supplied with a 13 A plug conforming to

BS 1363 fitted to the mains lead. If the plug is unsuitable for your socket outlets or needs to be replaced, please note the following. If the plug is a non-rewireable one, cut it from the mains lead and immediately dispose of it. Never insert it into a socket outlet as there is a very great risk of an electric shock.

2. The replacement of the plug at the mains lead has to be