BF3 - Bottle warmer Petra Electric - Free user manual and instructions

USER MANUAL BF3 Petra Electric

Keep out of reach from children.

Do not operate the appliance unattended.

This appliance is not meant to be used by persons (including children) with reduced physical, sensorial or mental capacities or in absence of the necessary expe- rience and/or knowledge - unless they are supervised by a person responsible for their safety and from whom they get instructions on how to use the appliance.

Operate the appliance out of the reach of the baby. Place the connection cord safely and do not pull it over sharp edges or jam it, do not allow it to hang down and protect it from heat and oil.

Do not place the baby food warmer onto hot surfaces, e. g. hot plate etc. or near gas flames, it may melt.

Do not pull out the plug by the cord and do not touch it with wet hands.

If the following happens do not use the appliance and unplug it immediately: - the appliance or the cord is damaged - the appliance leaks - any defect after the appliance has accidently dropped or something similar is suspected. In these cases have the appliance repaired.

Always heat up the food using the water bath.

Before putting into operation take care that there is enough water in the container. When operating the appliance for a longer time, under no circumstances allow the water to evaporate completely.

Caution, the container and the water will become hot during use.

Open the jars before warming up.

Baby food warm up once only and serve directly. Do not keep food warm for longer than one hour other- wise the hygienic quality of the baby food may be Instructions for use GB6 reduced.

The appliance cannot be switched off permanently by the temperature control. Therefore unplug always after use.

Do not immerse the baby food warmer in water.

In case of misuse, wrong handling or incorrect repair no liability will be taken for possible damages. Claims under guarantee are also excluded in such cases.

The appliance is not designed for commercial purposes.

Packaging material like foil bags are not designed for children.

In case the cord of this appliance is damaged, it has to be replacede by an authorised service agent of the manufacturer or a person having similar qualifications. Substantial dangers for the user can appear from inap- propriate repairs. Putting into operation The appliance can be used for a convenient warming up and keeping warm of feeding bottles and all standard sized baby food jars with a diameter of up to 73mm. Prior to use, roll up the not required cord at the botom of the appliance and slide the pointed end of the lifter into the groove in the upper edge of the appliance. To warm up baby food jars, only push the lifter down until the edge of the open glass is just over the appliance. For feeding bottles, push the lifter right down to the bottom. Then fill container with water up to 2 cm below the edge. Comment: Sometimes, the jugs of some manufacturers of baby food might jam when inserting into the appliance. The often reason for this is an non-round jug. Please try to turn the jug a bit - by this normally it fits in slightly. Temperature control The temperature of the water bath can be controlled by the rotary switch. The warming up of the baby food depends on the consistency and composition of the bott- le or the glass. For solid food choose a higher setting of the rotary switch than for liquid food. Full bottles and jars also require a higer setting than for less filled ones. When practising the correct setting can be found quickly. The control lamp shows that the device is heating. It goes out as soon as the water reaches the set tempe- rature. For taking out the food jars, push the lifter a bit upwards. Shake the bottle well or stir the baby food well in order to guarantee equally warm contents. The right temperature should always be checked by holding the baby bottle against the cheek or better by tasting yourself. If the food is to be kept warm for some time, the jar or the bottle should be left in the container. The thermostat guarantees a constant temperature by switching on the heating time after time.7 - the wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.Do not connect any wire to the terminal which is marked with the letter E or by the earth symbol , or coloured green or green and yellow.3. If a 13 A (BS 1363) plug is used it must be fitted with a 3 A fuse conforming to BS 1362 and be ASTA approved. If any other type of plug is used, the appliance must be protected by a 5 A fuse either in the plug or adapter or atthe distribution board.If in doubt - consult a qualified electrician.4. Never use the plug without closing the fuse cover. The appliance complies with the European directives 2006/95/EC, 2004/108/EC and 2005/32/EC. At the end of its lifetime this product must not bedisposed of through the normal domestic waste, butit should be handed to an assembly point for therecycling of electrical and electronical appliances. You caninquire about details at the local administration.Subject to technical changes. Proper dispose of the packaging material. Cleaning and maintenance Before cleaning always unplug the appliance and pour out the remaining water. Never immerse the appliance into water. Do not use caustic or scouring cleansing agents. Clean with a damp cloth, if necessary use some washing-up liquid. For UK use only 1. This product is supplied with a 13 A plug conforming to BS 1363 fitted to the mains lead. If the plug is unsuitablefor your socket outlets or needs to be replaced, please note the following. If the plug is a non-rewireable one, cut it from the mains lead and immediately dispose of it. Never insert it into a socket outlet as there is a very great risk of an electric shock.2. The replacement of the plug at the mains lead has to be done according to the following instructions:Important: The wires in this mains lead are coloured in accordance with the following code:blue: Neutralbrown: LiveAs the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- the wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black, CE8 Avant usage Lire attentivement le mode d’emploi. Il comprend des indications importantes pour l’utilisation, la sécurité et la maintenance de l’appareil. Il doit être soigneusement conservé et remis le cas échéant à des utilisateurs ultérieurs. L’appareil ne doit être utilisé que pour la destination prévue conformément à ce mode d’emploi. Cet appareil est destiné à des utilisations dome- stiques et comparables comme par exemple : - dans les cuisines pour les collaborateurs dans les commerces, les bureaux et d’autres domaines pro- fessionnels; - dans les domaines agricoles; - par les clients des hôtels, motels et autres services résidentiels; - dans les gîtes avec petit déjeuner. L’appareil n’est pas destiné à un usage purement commercial. Respecter les consignes de sécurité pour l’utilisation. Spécifications techniques Tension nominale: 230 V 50 Hz Puissance absorbée: 110 W Classe de protection: II Indications de sécurité