90.660 - Barbecue Beper - Free user manual and instructions

Frequently Asked Questions - 90.660 Beper

USER MANUAL 90.660 Beper

For further information and/or for instructions for use in other languages, please visit: beper.com

General Safety Instructions

• Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing.
• The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges.

Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it immediately. Do not put it in water.

• When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories.
• Do not operate the machine without supervision. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead).
• To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance.
• Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instructions".

Special safety information concerning this unit

• Keep the unit at a safe distance from easily inflammable objects such as furniture, curtains, etc.!
• Place the unit on a flat and heat-resistant surface. In the case of sensitive surfaces please place a heat-resistant board under the pan.
• Allow the unit to cool down before you put it away.
• Never let any water get into the fat.
• Only hold the handles or the knobs. The unit gets very hot.
• In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.

Set-up for use

Non-stick coating

• Grease the pans and the cooking plates slightly. Insert the pans in the relevant cavities in the bottom plate.
• Make the appliance work for about 5 minutes without any food in it to remove the protective coating (see Using the Appliance). A small amount of smoke is normal. Please ensure that there is adequate ventilation.
• Clean the pans and the baking plate in a rinsing bath once they have cooled down. Your new unit is now ready for operation.

Using the unit

Place the device on a heat-resistant surface.

1. Cut all the ingredients into small pieces or slices.
2. Lightly grease the baking plate.
3. Please ensure that the temperature regulator is turned to OFF. Connect the appliance to a duly. The left-hand lamp goes on to signal that the device is connected to the mains power supply.
4. Turn on the machine by moving the regulator clockwise to the desired position.

The right-hand lamp goes on. If necessary, start on a low setting. The device has reached the correct temperature when the right-hand control lamp goes off. During operation the control lamp goes on from time to time to show that the correct temperature is being maintained.

1. Choose the food to be grilled on the cooking plate. In the pans you can put for example mushrooms or small slices of bread with cheese to cook. To avoid damaging the non-stick coating, remove the food with a wood spatula.

Warming function

Turn the temperature regulator to the lowest setting. The roasting plate now serves as a hot plate.

After Use

To switch the device off, first turn the temperature regulator to OFF and remove the plug from the socket.

Cleaning

• Always pull the plug out of the mains socket and wait until the unit has cooled down before cleaning the unit.
• Under no circumstances should the device be immersed in water for cleaning.
• Clean the pan in the usual manner in soapy water.

Non-stick coating

• Please remove any food residues while they are still warm with a damp cloth or paper towel.
• Wash off the coating with a soft sponge and soapy water, then rinse with clear water and dry thoroughly with a soft cloth.
• Do not use sharp objects to clean the appliance. Otherwise, the non-stick coating may be damaged.
• Use a slightly damp cloth to clean the unit.

This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations.

Subject to technical changes without prior notice!

TECHNICAL DATA

Power: 1800W

Power supply: 220 - 240V 50 / 60Hz

For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.

The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.

This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee applies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.

The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance

For any technical assistance, please contact directly the seller or our head office in order to preserve the appliance's efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons will automatically void the guarantee.

Guarantee conditions

If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:

• The appliance has been used properly and for the purpose for which it has been intended.
• The appliance has not been tampered with, otherwise it is not maintainable.
• The purchase receipt shall be presented.
• The appliance showing a fair wear and tear shall not be covered by this guarantee.

Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements...) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier.

For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge.

In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product

Technical assistance

Even after the guarantee period we will always pay attention to repairs for defected appliances. For technical assistance and/or repairs after the guarantee period you can directly contact the below address:

Assistance technique