500 EEC - Scooter SXT - Free user manual and instructions

USER MANUAL 500 EEC SXT

ALWAYS WEAR A HELMET AND

OBEY ALL LAWS! BATTERY MAINTENANCE and CHARGING INSTRUCTIONS

1. You MUST charge completely prior to initial use. (Follow char-

ging instructions in your Product Handbook)

2. Charge immediately after each use.

3. Charge before storage. You must charge every 30 days if not

4. Charge the unit for 6-8 hours or until the light on the charger

5. DO NOT allow this unit to deep discharge the battery.

6. For safety purposes, DO NOT charge for over 24 hours.

7. Turn the unit OFF when not in use.

Failure to follow these INSTRUCTIONS will VOID YOUR WARRANTY! This PRODUCT IS NOT INTENDED FOR EXTREME or OFF-ROAD Use! Please take care of your SXT! DO NOT JUMP or ABUSE THIS PRODUCT! DO NOT RIDE IN WET/ICY CONDITIONS! Failure to follow these instructions will VOID YOUR WARRANTY! BATTERY MAINTENANCE and CHAR- GING INSTRUCTIONSWARNING! With each scooter comes an europanwide valid street certication (socalled COC) that makes this scooter street-legal in whole EU. With this document this scooter model can be insured by an insurance company of your choice and you will get the neccessary insurance plate number without any problems. Having an valid insurance and plate number is a „Must-Have“ on this scooter model. In order to drive this street-legal scooter on public roads you need to have a valid driving license. DO NOT operate this product on wet, frozen, oily or unpaved surfaces or under the inuence of drugs and/or alcohol. Avoid uneven surfaces, potholes, surface cracks and obstacles. DO NOT use a water hose to clean this product. See Product Handbook for more information. This product is recommended for riders 16 YEARS OF AGE and older. SAFETY!

• Persons without excellent vision, balance, coordination, reex, muscle and bone strength and good decision-making capabilities should not use this product.

• Minors without adult supervision should not use this product.

• Persons unwilling or unable to take responsibility for their own actions should not use this product.

• The user of this product assumes ALL risks associated with its use. To minimize these RISKS, the user must wear safety helmet, goggles, gloves, elbow and kneepads and appropriate footwear.

• This product is ELECTRIC! DO NOT ride this product in wet conditions, puddles or rainy weather. IMPORTANT

PLEASE READ THIS BEFORE

USING THIS PRODUCTQUICK REFERENCE

SAFETY GUIDE SAFETY GUIDE

• The recommended minimum age for riding this scooter is 16 years old.

• To avoid damage to the motor and footplate, do not overload the scooter.

• Never ride with more than one person.

• Inspect your scooter thoroughly before each use for loose or missing parts.

• Avoid unintentional starts by turning the scooter off while not in use.

• To avoid the risk of a short circuit in the electrical parts, do not use your Electric scooter in the rain and never spray or wash off your scooter with water.

• Do not place the battery near re or heat.

• To avoid damage to the battery, do not use the charger if it has been damaged in any way.

• Keep hands, face, feet and hair away from all moving parts.

• Do not touch the motor or wheels while they are rotating.

• Brakes are designed to control speed as well as stop the scooter. Practice braking for proper slowing down and smooth stops.

• Maintain your scooter as recommended in this Product Handbook.

• Use only quality replacement parts as recommended by the manufacturer.

• Inspect the entire scooter prior to each use. Replace any part that is cracked, chipped or damaged before use. *NEVER ALLOW CHILDREN TO OPERATE THE SCOOTER WITHOUT ADULT SUPER- VISION. *NEVER ATTEMPT TO OPERATE THE SCOOTER WHILE UNDER THE INFLUENCE OF ALCOHOL. If a situation arises that is not covered in the manual, proceed with caution and use good judgment.G e b r a u c h a n w e i s u n G sxt-scooters1000

Assembly Thank you for reading the instructions carefully. 1. 1. Carefully remove the SXT Scooter from the box.2. 1. To unfold the Scooter, begin by pressing down on the FOLDING HANDLE with one hand while gently pulling up on the handlebars with the other.3. Fully extend the handlebars to their upright position until you feel the mechanism lock into place.4. Attach the handlebars by inserting the silver handlebar clamp onto the handlebar post stopping just below the top. Be sure to orient the bars in the correct riding position with the throttle on the rider’s right side. Secure the handlebars to the post by tightening the bolts on the clamp with the enclosed Allen wrench as shown. . 5. Secure the hand brakes in place by using the provided Allen Wrench to rst loosen the tension bolts. Adjust the levers to a comfortable position and tighten the bolts. * BE CAREFUL NOT TO PULL ON THE CABLES! Your SXT scooter comes with the following accessories:

2. 1 36 V battery charger

3. Toolkit and fuses exchange

i n s t u c t i o n s sxt-scooters

56. Remove the battery, open the protective bag

and snap the fuse into the slot. Do not hesitate to press hard with your thumb to get the fuse.

7. Place the battery into the slot in the plastic

platform and connect.

8. Insert the seatpost into the slot and snap the

saddle and tighten the ring clamping. IF your clamping ring seems too small, do not hesitate to deviate a little so it ts more easily.

9. IF you have the SXT 1000, install the light

10. Check all screws before the rst departure

SXT (screw brakes, fork, suspension ect).

GETTING STARTED i n s t u c t i o n s sxt-scooters 6Your scooter comes charged out of the carton. We still recommend charging the unit for 6-8 hours prior to it’s rst use. We also recommend charging your scooter after each use and prior to storage.

WARNING: Do not allow your scooter to go into deep discharge, as this

will damage the batteries.

1. Make sure that all of the exposed bolts and screws are tightened.

2. This scooter model has a safety switch at the kickstand. If kickstand is

down this scooter model cannot be operated as the electricity is cut automati- cally for safety reasons.

3. Push the on/off switch (located on the left handlebar) to the ON position.

4. Put one foot on the deck of the SXT while pushing off with the other foot,

gently rotate the THROTTLE GRIP, on the right side of the handlebars. The scooter will begin to move on its own power. **Your scooter has a variable speed hand throttle. You can control the speed of your scooter by the amount of pressure you use when rotating the hand throttle. The more you rotate, the faster you will go. CHARGING

1. 1. Make sure unit is turned off.

2. Open the charging socket cover located on the right

side of the scooter frame, under the footplate.

3. Locate your Battery Charger. Find the charger socket

end that has a three-prong socket and plug it into the scooter.

4. Next, plug the AC plug into a wall outlet.

When rst plugged in, the charger has one red light that will illuminate at the same time, indicating that the char- ging process has started. Once the light on the charger turns red & green, you may remove the charger and close the safety cap. i n s t u c t i o n s sxt-scooters 7*Your SXT scooter is equipped with a variable throttle. Turn the handle to accelera-te, then release to stop the motor. When the engine shuts off your scooter will slow automatically, use the brakes if necessary. STOPPING & BRAKING 1. Pour ralentir lâchez l‘accélérateur, puis pressez les leviers droits et gauches. Appliquant une pression sur les leviers de freins ceci coupera automatiquement le moteur.

CHARGE INDICATOR, FAULT DIAGNOSIS

1. To brake, release the THROTTLE GRIP and depress the BRAKE LEVERS (on the left/right side of the handlebars. Depressing the brake will disengage power to the motor. When the unit feels like it is loosing power or not accelerating to full speed, the scooter is ready to be re-charged. NOTE: If the on/off switch is left in the ON position for more than 10-15 minutes without moving, Smart Power will shut itself OFF. To reset, turn the unit OFF, wait a few seconds and then switch it back ON again. BRAKING SYSTEM The scooter uses a pinch braking system for the front, and a disc/caliper system for the rear They are both activated by a hand brake lever on the left and right side of the handlebar. Squeezing the hand brake lever with your left hand activates the rear brake. Squeezing the hand brake lever with your right hand activates the front brake. Make sure to release the HAND THROTTLE GRIP when engaging the brakes. Your scooter is equipped with switches on each brake lever that will disengage power to the motor when the brake levers are depressed. Practice braking on a smooth, dry surface to get used to the feel of the braking system. Braking distance is affected by wet conditions and loose and uneven riding surfaces. GENERAL i n s t u c t i o n s sxt-scooters 8ADJUSTING BRAKES The Brakes on the scooter should come fully adjusted from the factory. However, it may be necessary to adjust the brakes from time to time.

SQUEAKY BRAKES The brakes may squeak before they are broken in. This is normal and will not affect the function or performance of the brakes. With continued use the squeak should go away. ADJUSTING BRAKES:To adjust the rear brakes:1. Adjust the tension screw on the right hand brake lever by rotating it counter-clockwise until the wheel spins freely.For brakes that are adjusted too tight:2. 1. Tighten the tension screw on the right hand brake lever by rotating it clockwise until the wheel has a slight drag. For Further Front Brake Adjustment :3. 1. Locate the adjustment screw on the front brake assembly (located above the front wheel). Tighten or loosen as necessary.For Further Rear Brake Adjustment:4. Locate the adjustment screw on the rear brake assembly (located on the left side of the back wheel. Tighten or loosen as necessary. GENERAL i n s t u c t i o n s sxt-scooters 9TIRE PRESSURE The tire must be inated to a maximum of 50 P.S.I. It is also recommended to use a tube additive like Slime, available from any motorcycle shop, to avoid inconvenient punctures.Empty all air from the tire, prior to loosening the bolt to split the rim. BATTERY INDICATOR On the right handlebar is your battery indicator button. The green, orange and Red LEDs display the loading status of your battery pack. LEDs are also used for diagnos-tics of failures. Charge level indicator : TIRE PRESSURE BATTERY INDICATOR i n s t u c t i o n s sxt-scooters 10RECOMMENDED TOOLS To adjust and service the scooter you will need the following tools:- Allen Wrenches: 3/4/5/6 mm- Wrenches: 10/13/13 mm Open end wrench- Large Adjustable Crescent Wrench- Philips Head Screwdrivers- Oil, Grease or Lubricant

The head unit will come adjusted from the factory. However, riding on rough terrain and general use may cause the head unit to become loose over time. It may be necessary to adjust the head unit from time to time. MAINTENANCE

• If the chain is skipping or jumping on the sprockets, this is too loose and may be harmful.

• If the chain is making a humming sound when the wheel is turning, this is too tight and may cause the chain to snap.

• The correct tension is achieved by adjusting the chain from its loose positi- on to when it becomes lightly tense.

MAINTENANCE SCHEDULE Proper care of your scooter will insure optimal performance and longer life span. The following are a few maintenance suggestions that will keep your scooter running in top condition. To tighten the chains: Slightly loosen the two axle bolts on both sides of the rear wheel. (Fig.14). Then slowly adjust the two adjus- ting screws on each side of the rear tire (Fig.15) until chain reaches the proper tension. Rotate the rear wheel to make sure the chain is alig- ned. Finally, lock and tighten the rear axle bolts prior to riding.

• Clean the exterior of the unit with a soft, damp rag. (DO NOT WASH WITH A HOSE)

• Check that all nuts and bolts are securely tightened.

• Lubricate the chain with any silicone spray, 3&1 oil or any good clean motor oil.

• Check battery charger for any frayed/cut wires.