Black Core One - Car stereo MAGNAT - Free user manual and instructions

USER MANUAL Black Core One MAGNAT

At the end of the product's useful life, please dispose of it at appropriate collection points provided in your country.

Dear MAGNAT Customer,

The BLACK CORE ONE car hi-fi power amplifier will enable you to satisfy your high demands on sound reproduction in your car. With its impressive deep-bass power reserves, low harmonic content and neutral reproduction, the BLACK CORE ONE takes car hi-fi to new heights. The amplifier is characterized by low operating current, rapid switching capabilities and excellent temperature stability. Experience and enjoy how this high-tech machine perfectly reproduces magnificent sound.

Please read all of the owner's manual before installing and using the amplifier.

1. TECHNICAL DATA

Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 900 W on 4 ohm

Nominal output power (DIN 45 324, B+=14.4V) 350 W on 4 ohm

Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 1500 W on 2 ohm

Nominal output power (DIN 45 324, B+=14.4V) 500 W on 2 ohm

Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 2100 W on 1 ohm

Nominal output power (DIN 45 324, B+=14.4V) 700 W on 1 ohm

Loudspeaker impedance 1 - 8 Ohm

Frequency response 5 - 300 Hz (-3 dB)

Total harmonic content (DIN 45 403) < 0.05 % (1 kHz)

Weighted noise distance (IEC A)

Input sensitivity LOW LEVEL INPUT

Input impedance LOW LEVEL INPUT

Low-pass filter

Subsonic filter

Bass boost

Supply

Fuse

Sizes (W x H x D)

Weight

100 dB

0.4 - 4 V

20 kOhm

40 - 300 Hz, 12 dB per octave

10 - 40 Hz, 12 dB per octave

0...12 dB at 45 Hz

+12 V (10 - 14.4 V), minus to ground

4 × 20 A

434 x 54 x 215 mm

4.1 kg

SUBJECT TO TECHNICAL CHANGE

2. FEATURES

• Complementary push-pull final stage
- Stable at 1 ohms
Low-pass (subwoofer) and subsonic filter with infinitely adjustable separating frequencies
• Infinitely variable bass equalisation
- Adjustable input sensitivity
Electronic protective circuit against short circuiting, DC offset and excess temperature
- Mute switch for suppressing switch-on crackle interference
Low-level outputs (cinch jacks) for connecting additional amplifiers
• Capsulated loudspeaker and power-supply screw terminals
- Status indicator (green LED) and overload indicator (red LED)
• Remote control for volume control

3. IMPORTANT INSTALLATION INFORMATION

This appliance may only be connected to a 12 volt system with negative ground.
The heat radiated when the amplifier is used means that sufficient air circulation is required at the place of installation. It is very important that the cooler's cooler ribs do not contact any metal plating or any surfaces which could impair air circulation. The amplifier may not be installed in small confined spaces or spaces without air circulation (e.g. spare wheel recess or under the vehicle carpeting). Installation in the boot is recommended.
• Install the amplifier in such a way that it is protected as far as possible against vibrations and dust and dirt.
• Make sure that the input/output cables are sufficiently distant from the power supply cables as otherwise interference may occur.
• Make sure that the fuse and operating elements are accessible after installation.
The appliance's reliability and performance depend on the quality of installation. Preferably get an expert to install the system, particularly if you want to install several loudspeakers or a complex multi-way system.

4. CONNECTIONS

4.1 POWER SUPPLY AND AUTOMATIC SWITCHING ON

Important notice: Before commencing the installation, disconnect the plus terminals from the car battery in order to prevent short circuits.

The power cabling usually installed in on-board car networks is not sufficient for a power amplifier's demands. Make sure that the power lines to GND and to the +12 V terminal have been sufficiently specified. A cable cross-section of at least 25 mm^2 must be used to connect the battery to the amplifier's terminals.

First connect the amplifier's GND terminal to the battery's minus pole. It is very important that the connection is good. Dirt residues must be carefully removed from the battery's connection point. A loose connection may cause malfunctions or interference noise or distortion.

The +12 V amplifier connection must then be connected with a power cable possessing an integrated fuse to the battery's plus pole. The fuse must be located close to the battery, the length of cable from the battery's positive pole to the fuse must be less than 60 centimetres for safety reasons. Only insert the fuse when all installation work, including the connection of the loudspeakers, has been completed.

Now connect the car hi-fi receiver's remote control connection to the amplifier's REM control jack. A cable with a cross-section of 0.75mm^2 is sufficient for connecting the amplifier's REMOTE connection and the control device.

4.2 AUDIO CABLES

When installing the audio cable between the cinch output of your car receiver and the cinch input of the amplifier inside your car, the audio and power supply cables should, wherever possible, not be routed along the same side of the vehicle. We recommend an isolated installation, e.g. routing the power cable through the cable duct on the left-hand side and the audio cable through the cable duct on the right-hand side or vice versa. This reduces interference due to crosstalk into the audio cables.

This also applies to the connecting cable for the remote control for regulating the volume. This cable should not be laid on the side of the power supply leads but together with the audio cable.

4.3 LOUDSPEAKER CONNECTIONS

• The lowest terminal resistance is 1 ohm
• Never connect the loudspeakers' minus terminals to the vehicle chassis.
• Never connect the +12 V supply voltage to a loudspeaker output as this would destroy the amplifier final stage.

If the amplifier is operated with lower terminal resistances or incorrectly used as described above, both the amplifier and the loudspeakers may be damaged. The warranty becomes void in such cases.

5. OPERATING ELEMENTS AND IN/OUTPUTS

5.1 SETTING THE INPUT SENSITIVITY

The input sensitivity may be adapted to any car radio or tape deck. Turn the volume control of your radio to its central position and then adjust the input-level control (2) to produce an average medium volume. This setting usually provides sufficient power reserves at optimum weighted noise voltage.

ATTENTION: only reproduce loud test noises briefly to prevent damaging the loudspeakers.

5.2 LOW-PASS FILTER WITH ADJUSTABLE CROSS-OVER FREQUENCY

Set the desired cross-over frequency with the control (4). This makes the filter adaptable to the installed woofer's sound requirements. The filter's high edge steepness is responsible for the precision reduction of medium and high frequency ranges.

5.3 SUBSONIC FILTER

The subsonic function reduces the lowest bass frequencies. The reduction rate may be infinitely adjusted with the regulator (5). This allows distortions produced by excessive loudspeaker membrane movements to be effectively minimized without reducing the utilizable bass levels.

5.4 BASS-BOOST

The bass-boost function (3) is used to increase or equalize the lower bass frequencies.

5.5 VOLUME REMOTE CONTROL

The volume may be adjusted by using the supplied remote control. Please observe during installation that the remote control line shouldn't be routed along the same side of the vehicle as the power supply cables. The remote control unit should be mounted on the dashboard or at any other easily accessible position. Now, the subwoofer volume may be adjusted independently from the settings at the radio.

5.6 OUTPUTS FOR CONNECTING ADDITIONAL AMPLIFIERS

The input signal of the INPUT connections INPUT L and R (1) is forwarded directly to the OUTPUT (6) L and R jacks. The OUTPUT connections allow the use of additional amplifiers without requiring additional T-plugs and cables.

FIG. 1 POWER SUPPLY / REMOTE SWITCH-ON CONNECTION

(1) GND terminal for the ground, to the battery's minus pole
(2) REM terminal for remote switch-on
(3) Terminal for +12 V battery voltage
(4) Battery
(5) Cable fuse
(6) To your car radio's automatic aerial connection

If your car is not equipped with an automatic aerial connection, connect this cable's plus pole (+) to the ignition lock. An on/off switch should be inserted in this case. Make sure that this switch is switched off if the amplifier is not used.

FIG. 2 OPERATION WITH STEREO CAR RADIO

Connect and set the amplifier as shown in Fig. 2 if it is to be controlled by a car radio with two output channels. Operation of the low-pass filter used is described in Chapter 5.2.

(1) To the car radio, left output
(2) To the car radio, right output
(3) Subwoofer

FIG. 3 OPERATION WITH ONE CAR RADIO WITH SUBWOOFER OUTPUT

(1) To the car radio, subwoofer output
(2) Subwoofer

FIG. 4 USE AS A SUBWOOFER AMPLIFIER WHILE USING AN ADDITIONAL 4-CHANNEL AMPLIFIER (BLACK CORE FOUR / BLACK CORE FOUR LTD) FOR 4 SATELLITE LOUDSPEAKERS

(1) To the car radio, front left output
(2) To the car radio, front right output
(3) To the car radio, rear left output
(4) To the car radio, rear right output
(5) Front left loudspeaker
(6) Front right loudspeaker
(7) Rear left loudspeaker
(8) Rear right loudspeaker
(9) Subwoofer

FIG. 5 OPERATING ELEMENTS AND IN/OUTPUTS

(1) Low-level input
(2) Input level control
(3) Bass-booster control
(4) Transfer frequency control for low pass
(5) Cross-over frequency control for the subsonic filter
(6) Outputs for connecting other amplifiers

Très cher client de MAGNAT

Ecart signal / bruit (IEC A)

Dimensions (L x H x P)

Poids

$$ < 0, 05 \% (1 \mathrm{kHz}) $$

$$

1 0 0 \mathrm{dB} $$

$$ 0, 4 - 4 \mathrm{V} $$

$$ 2 0 \mathrm{kOhm} $$

Dimensioni (L x A x P)

Peso

20 Kohm

4.3 HÖGTALARANSLUTNINGAR

GB Congratulations! You have made a wise selection in becoming the owner of a MAGNAT HiFi equipment. Due to high quality MAGNAT products have earned an excellent reputation through the western world. And this high quality standard enables us to grant a 2-years warranty for MAGNAT HiFi-electronic components.

The equipments are checked and tested continuously during the entire production process. In case you have problems with your MAGNAT HiFi equipment, kindly observe the following:

1. The guarantee period commences with the purchase of the component and is applicable only to the original owner.

2. During the guarantee period we will rectify any defects due to faulty material or workmanship by replacing or repairing the defective part at our discretion. Further claims, and in particular those for price reduction, cancellation of sale, compensation for damages or subsequential damages, are excluded. The guarantee period is not altered by the fact that we have carried out guarantee work.

3. Unauthorized tampering with the equipment will invalidate this guarantee.

4. Consult your authorized dealer first, if guarantee service is needed. Should it prove necessary to return the component to the factory, please insure that • the component is packed in original factory packing in good condition • the quality control card has been filled out and enclosed with the component, • your enclose your receipt as proof of purchase.

5. Excluded from the guarantee are: • Illuminates • Wear parts • Shipping damages, either readily apparent or concealed (claims for such damages must be lodged immediately with forwarding agent, the railway express office or post office). • Scratches in cases, metal components, front panels, etc. (You must notify your dealer directly of such defects within three days of purchase.) • Defects caused by incorrect installation or connection, by operation errors (see operating instructions), by overloading or by external force. • Equipments which have been repaired incorrectly or modified or where the case has been opened by persons other than us. • Consequential damages to other equipments. • Reimbursement of cools, without our prior consent, when repairing damages by third parties.

F

Toutes nos félicitations!

Name and address of the dealer/stamp

Käufer/Customer

Name/Name

Straße/Street

PLZ, Ort/City

Land/Country

Kaufdatum/buying date

No warranty without receipt!

Magnat®