ESLA63S - Shaver PANASONIC - Free user manual and instructions

USER MANUAL ESLA63S PANASONIC

Operating Instructions

Before operating this unit, please read these instructions completely and save them for future use.

IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic

precautions should always be followed, including

Read all instructions before using this appliance.

DANGER To reduce the risk of electric

1. Do not reach for an appliance that has fallen

into water. Unplug immediately.

2. Charger unit is not for immersion or for use in

3. Do not place or store appliance where it can fall

or be pulled into a tub or sink. Do not place in

or drop into water or other liquid.

4. Except when charging, always unplug this

appliance from the electrical outlet immediately

5. Unplug this appliance before cleaning.

6. Do not use an extension cord with this

WARNING To reduce the risk of burns, fire,

electric shock, or injury to persons:

1. Close supervision is necessary when this

appliance is used by, on, or near children or

2. Use this appliance only for its intended use as

described in this manual. Do not use

attachments not recommended by the

ver operate this appliance if it has a

damaged cord or plug, if it is not working

properly, if it has been dropped or damaged, or

dropped into water. Return the appliance to a

service center for examination and repair.

4. Keep the cord away from heated surfaces.

5. Never drop or insert any object into any

6. Do not use outdoors or operate where aerosol

(spray) products are being used or where

oxygen is being administered.

7. Do not use this appliance with damaged

shaving blades and/or foil, as it has the

potential to result in facial injury.

8. Always attach plug to appliance first, then to

outlet. To disconnect, turn all controls to “off”

then remove plug from outlet.

SAVE THESE INSTRUCTIONS SPECIFICATIONS Power source: See the name plate on the product.

(Automatic voltage conversion)

Motor voltage: 3.6 V DC Charging time: 1 hour

This product is intended for household use only.

ES-LA63_USA.indb 2 2009/06/08 11:13:163

This WET/DRY shaver can be used for wet shaving with shaving

lather or for dry shaving. You can use this watertight shaver in

the shower and clean it in water. The following is the symbol of

Wet shaver. The symbol means that the hand‑held part may be

used in a bath or shower.

Treat yourself to wet lather shaves for at least three weeks and

notice the difference. Your Panasonic WET/DRY shaver requires

a little time to get used to because your skin and beard need

about a month to adjust to any new shaving method.

Caution ‑ The outer foil is very thin and can be damaged if not

used correctly. Check that the foil is not damaged before using

the shaver. Do not use the shaver if the foil etc. is damaged as

you will cut your skin.

Do not use any power cord or AC adaptor other than one

specifically designed for this model (RE7‑51). Plug in the

adaptor into a household outlet where there is no moisture and

handle it with dry hands. The shaver may become warm during

use and charging. However, this is not a malfunction. Do not

charge the shaver where it will be exposed to direct sunlight or

other heat sources. Hold the adaptor when disconnecting it from

the household outlet. If you tug on the power cord, you may

damage it. The supply cord cannot be replaced. If the cord is

damaged, the appliance should be scrapped.

Adequate ambient temper

ature for charging is 15‑35 °C (59‑

If the indicators on the LCD panel do not glow, wait for a short

while until it glows.

The adaptor is intended to be correctly oriented in a vertical or

floor mount position.

Warning ‑ Disconnect the power cord from the shaver before

cleaning it to prevent electric shock.

Keep both the inner blades inserted. If only one of the inner

blades is inserted, the shaver may be damaged. If you clean the

shaver with water, do not use salt water or hot water. Do not

soak the shaver in water for a long period of time. Wipe it with a

cloth dampened with soapy water. Do not use thinner, benzine

Disconnect the power cord when storing the shaver. Do not

bend the power cord or wrap it around the shaver. This

appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a

person responsible for their safety. Children should be

supervised to ensure that they do not play with the appliance.

Keep these operating instructions in a safe place.

Insert the appliance plug into

Plug in the adaptor into a

household outlet. The indicators on the LCD panel glow and charging starts.Charging is completed when the indicators on the LCD panel blink. (Max. 1 hour later) •

• If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the proper configuration. •

The LCD panel shows the remaining battery capacity from 0% to

100%, in 10% increments.

During use After use

The used time is shown.

The indicators turn off after 5 seconds.

The shown time returns to

[0’00”] after 10 minutes.

The used time and the

remaining battery capacity

are shown alternately after

turning off the shaver.

When the battery capacity is low

You can shave 1 to 2 times after “10%” appears.

(This will differ depending on usage.)

“10%” appears and blinks.

A full charge will supply enough power for approx. 14 shaves of

Start out shaving by applying gentle pressure to your face. Stretch

your skin with your free hand and move the shaver back and forth

in the direction of your beard. You may gently increase the amount

of pressure as your skin becomes accustomed to this shaver.

Applying excessive pressure does not provide a closer shave.

Using the trimmer handle

You can change the pivot action. Also, slide the handle up to “ ”

when using the trimmer.

FREE You can move the

LOCK FREE LOCK You can lock the

Slide the trimmer handle up. Place at a

right angle to your skin and move

downwards to trim your sideburns.

We recommend that you clean

your shaver with the turbo mode

for “sonic” vibration cleaning

when the faucet symbol

appears on the LCD panel.

1. Disconnect the power cord

2. Apply some hand soap and

some water to the outer foil.

3. Slide the switch lock button

downwards to unlock the OFF/

4. Press the OFF/ON switch for

more than 2 seconds to

activate the turbo mode for

“sonic” vibration cleaning.

After about 20 seconds, it

will be automatically turned

off, or you can turn it off by

pressing the OFF/ON switch.

5. Remove the outer foil section

and press the OFF/ON switch

for more than 2 seconds to

activate the turbo mode for

“sonic” vibration cleaning and

clean it with running water.

6. Wipe off any drops of water

7. Dry the outer foil section and

the shaver completely.

8. Attach the outer foil section to

Caution for turbo mode

Shaving in turbo mode may damage your skin. Turn the shaver

off and then on again to cancel turbo mode.

Do not place your fingers on the OFF/ON switch while using

the shaver. This may cause the shaver to turn off or enter turbo

Replacing the system outer foil and the inner

appears on the LCD panel once a year. (This will differ

depending on usage.) We recommend checking the system outer

foil and the inner blades when it appears.

Press the OFF/ON switch for more than 30 seconds to delete .

system outer foil once every year

inner blade once every two years

Replacing the system outer foil

1. Press the foil frame release

buttons and lift the outer foil

section upwards as illustrated.

2. Press the system outer foil

release buttons and pull down

the system outer foil as

3. Align the foil frame mark

and the system outer foil 

mark and securely attach

The system outer foil cannot

be reversely attached.

Always insert the system

outer foil to the foil frame

when attaching to the shaver.

4. After turning the mark to

the front, securely attach the

outer foil section to the shaver

Replacing the inner blades

1. Press the foil frame release

buttons and lift the outer foil

section upwards as illustrated.

2. Remove the inner blades one

at a time as illustrated.

Do not touch the edges

(metal parts) of the inner

blades to prevent injury to

3. Insert the inner blades one at

a time until they click as

Removing the built-in rechargeable battery

A lithium ion battery that is recyclable powers the product you

have purchased. Please call 1‑800‑8‑BATTERY for information

on how to recycle this battery.

T M WARNING for Lithium Battery:

Fire, explosion, and severe burn hazard. Do not crush,

disassemble, heat above 100°C (212°F), or incinerate.

Remove the built‑in rechargeable battery before disposing of the

shaver. Do not dismantle or replace the battery so that you can

use the shaver again. This could cause fire or an electric shock.

Replace it at an authorized service center.

Disconnect the power cord from the shaver when removing the

Perform steps 1 to 4 and lift the battery, and then remove it.