DO9017J - Juicer DOMO - Free user manual and instructions

USER MANUAL DO9017J DOMO

Kundendienst. 14DO9017J Read the operating instructions carefully before the operation. These instructions shall be stored properly so that you can get them immediately to ensure you can operate the machine safely. When turning on the machine, make sure that the following requirements on the safety and related maintenance shall be complied : - This product is in accordance with the related regulations on technical certifi cation and safety of electrical products. - In no case immerge the product into water or any other liquid to prevent from electric shock. - Do not use the machine in the outdoor. - Do not operate the machine near the water source or similar containers fi lled with water. - No cleaning operation is allowed until you make sure that the plug has been removed. - Do not contact with the cord or sharp edge ; pull/draw the cord, do not suspend anyting with the cord, the cord shall be kept away from hot gas or steam. - Do not place the product on or near the hot surface such as gas stove ; in no case let the cord come in contact with hot parts. - Do not plug in or remove the plug when your hand has sweated. - Prevent the product from getting moist, in no case place it into a bowl or dish washer for cleaning. - Only use the product for its intended use. - The product shall be operated and stored properly by an adult. - The external surface must be cleaned with a dry cotton cloth, do not clean it with a wet cloth or strong detergent. - The product shall be stored in a dry place where it cannot be exposed to direct sunlight and the children cannot get access to it. - Do not operate the product when it has failed/damaged or is destroyed as a result from falling or improper operation. - Do not disassemble the machine by yourself ; this will cause the warranty to end. - Before operating the product, check and make sure that all machine parts such as the plug, cas,... shall be normal. In any abnormal condition has been foud you shall : contact with your dealer and manufacturer for repalcing it or put it to a qualifi ed repair center for repairing it. - If the supply cord is damaged, it must be repalced by the manufacturer or its service agent or a similarly qualifi ed person in order to avoid a hazard. - This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilties prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance. - Switch off the appliance before changing accessories or cleaning. 15DO9017J COMPONENTS

7. Stainless steel body

USE Unwind the electrical cord and plug in the unit. Place a glass or bowl under the juice outlet for the juice. Cut the fruit in two halves. Press down the juice outlet for opening and the juice can fl ow out. Remove the lid. Place the fruit on the head and press it down. IMPORTANT : you will hear a noice when the juice process is fi nished and the head is coming back up. This is normal. Press for 15 sec. than let the unit rest for 15 sec. Place the lid on the juicers. Press down the lid, the juicer will now rotated the sieve at high speed so that the juice remaining in the pulp will be trown out. After centrifuging close the juice outlet by pressing it upwards. CLEANING When the operation has fi nished, unplug the unit. Remove the lid and the sieve. Clean the sieve under running water. Remove the dish. Clean the lid, the sieve and the dish in warm water with a mild detergent. Clean the outside of the unit with a soft dry cloth. Never immerse the unit in water. PROBLEM SHOOTING When problems occur with the unit check below problems and their solutions. If the problem isn’t solved , get in contact with the distributor or his after sales service. PROBLEM : The unit doesn’t operate when pressing the head or lid.

16DO9017J PROBABLE CAUSES: The plug isn’t properly plugged in. The voltage of the unit doesn’t correspond with the voltage at your home. The unit isn’t correctly assembled. The motor fuse has blown . SOLUTIONS Plug in the plug. Check the voltage. Disassemble and reassemble the unit. Get in contact with the distributor or his after sales service. 17LINEA 2000 - Industriezone Klein Gent - Bouwelven 12A - 2280 Grobbendonk - Tel [phone] - Fax : 014/21,54,63