WIRELESS OPTICAL USB MOUSE - Wireless Mouse BELKIN - Free user manual and instructions

USER MANUAL WIRELESS OPTICAL USB MOUSE BELKIN

Wireless Optical USB Mouse

Navigate with optical precision and wireless freedom

Wireless Optical USB Mouse

Navigate with optical precision and wireless freedom

User Manual

F8E847eaUSB

TABLE OF CONTENTS

Introduction 1
Compatible Equipment 2
Operating Systems 2
Package Contents 2
Quick Installation Guide 3
Troubleshooting 4
Information 6

INTRODUCTION

Congratulations and thank you for purchasing the Wireless Optical Mouse from Belkin. We appreciate your business and are sure you will enjoy years of reliable use with this high-quality, input device. Please review this entire User Manual so you can be sure to get the most reliable performance from your new equipment.

INTRODUCTION

Compatible Equipment

Works with all PCs that are compatible with IBM® and equipped with USB interface

NOTE: Use of these products on a desk made of iron, or other metal, will negatively impact the operation of your Wireless Mouse.

Operating Systems

WindowsXP,Me,2000and98SE

Package Contents

Wireless Optical Mouse

Receiver

2 AA batteries

User Manual

Please read the instructions for installing, operating, and using the wireless mouse.

QUICK INSTALLATION GUIDE

1. Be sure that your computer is turned on. If you are running Windows 98 SE, Me, or 2000, you will need to keep your old mouse connected for installation.
2. Connect the receiver to your computer through the USB port. Note: When connecting the USB cable to your computer, Windows will start a New Hardware Wizard. In Windows XP, it will complete the Wizard automatically. In Windows 98 SE, Me, and possibly 2000, you will need to follow through the New Hardware Wizard with your old mouse.
3. Install the batteries into your Mouse. Please make sure you follow the indication on the inside compartment for correct positioning of the batteries.
4. The receiver will automatically scan and synchronize the Mouse. It should now be functioning.
5. If automatic synchronization does not occur, please refer to the "Troubleshooting" section of this User Manual.

TROUBLE SHOOTING

The Mouse is not detected or does not work after installation.

• Make sure the receiver cables are plugged into the computer's USB port.
• For optimal performance, place the receiver at least eight inches (20cm) away from the computer monitor, the computer, any external storage devices, or other electrical devices.
• Make sure you have properly installed the batteries. Test the batteries to make sure they are not dead (you can do this by installing them into another device).
• You may have other system devices that are conflicting with the Mouse. Check the IRQ/address setting of these devices for conflicts and change the settings as required. Please refer to your computer documentation or the manufacturer's technical support for assistance in making these changes.

TROUBLESHOOTING

• Make sure you have properly established communication/synchronization between the receiver and the Mouse:

1) Press the reset button on the receiver.
2) Press the connect button on the mouse.

• If the Mouse is not working, make sure that the LED on the Mouse starts flashing when you push any of the Mouse buttons, or move the Mouse. If the LED does not flash, check to make sure you have installed the batteries correctly.
• When the Mouse LED is flashing, the LED on the receiver should also flash to indicate they are speaking to each other. If the LED on the receiver does not flash, it means that the device has not connected properly. Push the reset button on the Mouse.
• If your Mouse pointer becomes choppy on-screen, replace batteries with a fresh set.

INFORMATION

FCC Statement

DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY

We, Belkin Corporation, of 501 West Walnut Street, Compton, CA 90220, declare under our sole responsibility that the product,

F8E847eaUSB

to which this declaration relates, complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CE Declaration of Conformity

We, Belkin Corporation, declare under our sole responsibility, that the F88E47eaUSB to which this declaration relates, is in conformity with EN55022, EN61000-3-2, EN61000-3-3, and EN55024.

Caution: Exposure to Radio Frequency Radiation.

The radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such manner that the potential for human contact normal operation is minimized. When connecting an external antenna to the device, the antenna shall be placed in such a manner to minimize the potential for human contact during normal operation. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

INFORMATION

Modifications

The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by Belkin Components may void the users authority to operate the equipment.

Belkin Corporation Limited Lifetime Product Warranty

Belkin Corporation warrants this product against defects in materials and workmanship for its lifetime. If a defect is discovered, Belkin will, at its option, repair or replace the product at no charge provided it is returned during the warranty period, with transportation charges prepaid, to the authorized Belkin dealer from whom you purchased the product. Proof of purchase may be required.

This warranty does not apply if the product has been damaged by accident, abuse, misuse, or misapplication; if the product has been modified without the written permission of Belkin; or if any Belkin serial number has been removed or defaced.

THE WARRANTY AND REMEDIES SET FORTH ABOVE ARE EXCLUSIVE IN LIEU OF ALL OTHERS, WHETHER ORAL OR WRITTEN, EXPRESSED OR IMPLIED. BELKIN SPECIFICALLY DISCLAIMS ANY AND ALL IMPLIED WARRANTYES, INCLUDING, WITHOUT LIMITATION, WARRANTYES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

No Belkin dealer, agent, or employee is authorized to make any modification, extension, or addition to this warranty.

BELKIN IS NOT RESPONSIBLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM ANY BREACH OF WARRANTY, OR UNDER ANY OTHER LEGAL THEORY, INCLUDING BUT NOT LIMITED TO, LOST PROFITS, DOWNTIME, GOODWILL, DAMAGE TO OR REPROGRAMMING OR REPRODUCING ANY PROGRAM OR DATA STORED IN, OR USED WITH, BELKIN PRODUCTS.

Some states do not allow the exclusion or limitation of incidental or consequential damages or exclusions of implied warranties, so the above limitations of exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

INFORMATION

Canada- Industry Canada (IC)

The wireless radio of this device complies with RSS 139 & RSS 210 Industry Canada. This Class B digital complies with Canadian ICES-003.

Radio products with the CE 0560 or CE alert marking comply with the R&TTE Directive (1995/5/EC) issued by the Commission of the European Community.

C0470①

Compliance with this directive implies conformity to the following European Norms (in brackets are the equivalent international standards).

EN 60950 (IEC60950) - Product Safety
- EN 300 328 Technical requirement for radio equipment
- ETS 300 826 General EMC requirements for radio equipment.

To determine the type of transmitter, check the identification label on your Belkin product.

CE ①

Products with the CE marking comply with the EMC Directive (89/336/EEC) and the Low Voltage Directive (72/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms (in brackets are the equivalent international standards).

EN 55022 (CISPR 22) - Electromagnetic Interference
EN 55024 (IEC61000-4-2,3,4,5,6,8,11)-Electromagnetic Immunity
EN 61000-3-2 (IEC61000-3-2) - Power Line Harmonics
EN 61000-3-3 (IEC61000) - Power Line Flicker
- EN 60950 (IEC60950) - Product Safety

CE

Products that contain the radio transmitter are labeled with CE 0560 or CE alert marking and may also carry the CE logo.

BELKIN

belkin.com

Belkin Ltd.

Express Business Park • Shipton Way • Rushden

NN10 6GL • United Kingdom

Tel: [phone]

Fax: [phone]

Belkin B.V.

Boeing Avenue 333

1119 PH Schiphol-Rijk · The Netherlands

Tel: [phone]

Fax: [phone]

Belkin GmbH

Hanebergstrasse 2

80637 Munich · Germany

Tel: [phone]

Fax: [phone]

Belkin SAS

© 2004 Belkin Corporation. All rights reserved.

All trade names are registered trademarks of respective manufacturers listed.

BELKIN

Canada - Industry Canada (IC)

Assistance technique Belkin

Europe: 00 800 223 55 460

P74679ea

Canada- Industry Canada (IC)

Canada-Industry Canada (IC)

80637 Munich - Germany

Tel: [phone]

Fax: [phone]

Belkin SAS

© 2004 Belkin Corporation. All rights reserved.

All trade names are registered trademarks of respective manufacturers listed.