HT-R548 - Récepteur audio/vidéo ONKYO - Free user manual and instructions

USER MANUAL HT-R548 ONKYO

Speaker Configuration

About AV Connections

Connecting Your Components

Playing USB Device Listening to AMFM Radio

BFinding Stations by Type (PTY)

Using the Listening Modes

Listening Mode Description Input |Speaker

Setting the Display Brightness

Turn this setting on to broaden the width of the front stereo image when using the Dolby Pro Logic II Music listening mode.

“Auto Standby” will display on the display and OSD from 30 seconds before the Auto Standby functions.

+ Depending on some sources, the Auto Standby function may activate during playback.

Turn this setting on to allow R1HD -compatible components connected via HDMI to be controlled by the AV receiver (> page 54).

This preference determines whether the incoming audio signal is output from the HDMI output. You may want to turn this preference on if your TV is connected to the

HDMI output and you want to listen to the audio from a connected component through your TV’s speakers. Normally, this should be set to “Off”.

Turn this setting on to enhance the sound quality of compressed music files. Use it with music files that use

“lossy” compression, such as MP3. Tip + Alteratively, you can use the AV receiver's MUSIC OPTIMIZER. Turn this setting on to soften overly bright movie soundtracks, which are typically mixed for reproduction in a movie theater. CinemaFILTER can be used with the following listening modes: Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Pro Logic II Movie, Multichannel, DTS, DTS Neo:6 Cinema, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master Audio and DTS Express. En 42

iPod/iPhone Playback via Onkyo Dock

Press the appropriate

REMOTE MODE first En 48

Only the front speakers produce sound

&The following settings can be made for the composite video inputs

You must use the buttons on the unit to make these settings. En 52

Connection Tips and Video Signal Path

Using an RIHD-compatible TV, Player, or Recorder